2007 Ic Bus Cesb

EQUIPMENT ADAPTIVE/MOBILITY

CERTAIN MY 2006 AND 2007 IC CORPORATION FE, RE, AND IC SCHOOL BUSES AND CE SCHOOL AND COMMERCIAL BUSES MANUFACTURED BETWEEN JUNE 12, 2005, AND MARCH 29, 2006, AND EQUIPPED WITH RICON 1200, 2000, AND 5500 SERIES WHEELCHAIR LIFTS. THE PLATFORM LIFTS MAY HAVE A DEFECT IN THE WELD WHICH WILL ALLOW A JOINT ON THE VERTICAL LIFT TO CRACK.

SEATS

CERTAIN MY 2006 AND 2007 IC CE AND 2007 BE SCHOOL BUSES MANUFACTURED BETWEEN AUGUST 3, 2005, AND MAY 1, 2006. THE CONFIGURATION OF THE MOUNTING BRACKET FOR THE 39 INCH TRACK MOUNTED CE WHITE CHILD SAFETY SEAT FAILS TO CONFORM TO THE STRENGTH REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 210, SEAT BELT ASSEMBLY ANCHORAGES.

STRUCTURE

CERTAIN MY 2003 THROUGH 2007 IC CESB AND MY 1998 3800 SCHOOL BUSES MANUFACTURED BETWEEN DECEMBER 23, 1997, AND MARCH 31, 2006. THE HANDRAILS WERE NOT INSTALLED CORRECTLY WHICH WILL ALLOW PASSENGER COAT STRINGS OR DRAWSTRINGS TO GET CAUGHT AS THE PASSENGER EXITS THE BUS.

SEATS

CERTAIN IC SCHOOL AND COMMERCIAL BUSES MANUFACTURED BETWEEN OCTOBER 11, 2005, AND OCTOBER 31, 2006. THESE BUSES HAVE THE FOLLOWING SAFETY ISSUES: IF THE DRIVER'S SEAT IS IN THE HIGHEST AND MOST REAR POSITION, THE BACK OF THE SEAT MAY LEAN AGAINST A BARRIER BEHIND THE SEAT, OR AGAINST THE SEAT BACK. THIS WILL PREVENT THE SEAT BELT FROM RETRACTING WHICH FAILS TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 209, SEAT BELT ASSEMBLIES. WHEN ADJUST THE SEAT TO A HIGHER POSITION, THE DRIVER MAY PULL THE SEAT PAST THE LAST STOP SO THAT THE SEAT SITS ON THE ADJUSTING PIN, WHICH ALLOWS THE SEAT TO TEETER ON TOP OF THE PIN. IF OVER-TRAVEL OCCURS, THE UPPER SEAT PEDESTAL TUBE COULD SEPARATE FROM THE LOWER PEDESTAL TUBE DURING VEHICLE OPERATION. IF THE DRIVER IS SITTING IN THE DRIVER'S SEAT AND REACHES TO ADJUST THE SEAT HEIGHT, THEIR WEIGHT WILL CAUSE THE SEAT TO DROP, WHICH COULD RESULT IN THEIR HAND BEING PINCHED BETWEEN THE SEAT AND THE LEVER. THE DRIVER'S SEAT IS DIFFICULT TO ADJUST TO A HIGHER POSITION BECAUSE OF THE ADDITIONAL WEIGHT OF THE ALL BELTS TO SEAT (ABTS) DESIGN.

OTHER:SCHOOL BUS STOP ARM ASSEMBLY

CERTAIN 2007 AND 2008 MY IC SCHOOL BUSES MANUFACTURED BETWEEN JANUARY 18, 2006, AND JANUARY 17, 2007. THE AIR SUPPLY FITTING MAY SEPARATE FROM THE BASE PLATE, PREVENTING ACTUATION AIR FROM REACHING THE STOP ARM AND/OR CROSSING ARM. THIS CONDITION WILL RESULT IN NON-DEPLOYMENT OF THE STOP ARM AND/OR CROSSING ARM DURING A SCHOOL BUS STOP TO PICK-UP OR DISCHARGE PASSENGERS.