2006 Ic Bus Resb

OTHER:SCHOOL BUS STOP ARM ASSEMBLY

CERTAIN IC MY 2002 THROUGH 2004 3800; 2002 THROUGH 2006 CESB, FESB, AND RESB; AND 2006 AND 2007 BESB SCHOOL BUSES ORIGINALLY SOLD IN OR CURRENTLY REGISTERED IN THE FOLLOWING STATES: ALASKA, COLORADO, CONNECTICUT, DELAWARE, IDAHO, ILLINOIS, INDIANA, IOWA, KANSAS, KENTUCKY, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN, MINNESOTA, MISSOURI, MONTANA, NEBRASKA, NEVADA, NEW HAMPSHIRE, NEW JERSEY, NEW MEXICO, NEW YORK, NORTH DAKOTA, OHIO, OREGON, PENNSYLVANIA, RHODE ISLAND, SOUTH DAKOTA, TENNESSEE, UTAH, VERMONT, VIRGINIA, WASHINGTON, WEST VIRGINIA, WISCONSIN, WYOMING, AND THE DISTRICT OF COLUMBIA. IN EXTREMELY COLD WEATHER, THE MICROSWITCHES USED INTERNALLY TO POSITION THE STOP ARM SIGN IN THE OPEN AND CLOSED POSITIONS MAY MALFUNCTION, CAUSING THE SIGN TO OPEN OR CLOSE IN AN IMPROPER POSITION, OR TO NOT OPEN AT ALL.

OTHER:SCHOOL BUS STOP ARM ASSEMBLY

THIS IS NOT A SAFETY RECALL IN ACCORDANCE WITH THE SAFETY ACT. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY. CERTAIN IC MY 2002-2007 BESB, CESB, FESB, AND RESB SCHOOL BUSES ORIGINALLY SOLD IN OR CURRENTLY REGISTERED IN STATES OTHER THAN THE FOLLOWING: ALASKA, COLORADO, CONNECTICUT, DELAWARE, IDAHO, ILLINOIS, INDIANA, IOWA, KANSAS, KENTUCKY, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN, MINNESOTA, MISSOURI, MONTANA, NEBRASKA, NEVADA, NEW HAMPSHIRE, NEW JERSEY, NEW MEXICO, NEW YORK, NORTH DAKOTA, OHIO, OREGON, PENNSYLVANIA, RHODE ISLAND, SOUTH DAKOTA, TENNESSEE, UTAH, VERMONT, VIRGINIA, WASHINGTON, WEST VIRGINIA, WISCONSIN, WYOMING, AND THE DISTRICT OF COLUMBIA. IN EXTREMELY COLD WEATHER, THE MICROSWITCHES USED INTERNALLY TO POSITION THE SIGN IN THE OPEN AND CLOSED POSITIONS MAY MALFUNCTION, CAUSING THE SIGN TO OPEN OR CLOSE IN AN IMPROPER POSITION, OR TO NOT OPEN AT ALL.

EQUIPMENT ADAPTIVE/MOBILITY

CERTAIN MY 2006 AND 2007 IC CORPORATION FE, RE, AND IC SCHOOL BUSES AND CE SCHOOL AND COMMERCIAL BUSES MANUFACTURED BETWEEN JUNE 12, 2005, AND MARCH 29, 2006, AND EQUIPPED WITH RICON 1200, 2000, AND 5500 SERIES WHEELCHAIR LIFTS. THE PLATFORM LIFTS MAY HAVE A DEFECT IN THE WELD WHICH WILL ALLOW A JOINT ON THE VERTICAL LIFT TO CRACK.

SEATS

CERTAIN 2006 AND 2007 IC RESB (PB305) SCHOOL BUSES MANUFACTURED BETWEEN JULY 1, 2005, AND MAY 9, 2006. A JOINT AT THE REAR OF THE BUS WHERE THE DAVENPORT IS ATTACHED TO THE FLOOR DOES NOT MEET THE JOINT STRENGTH REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 221, SCHOOL BUS BODY JOINT STRENGTH.

SEATS

CERTAIN IC SCHOOL AND COMMERCIAL BUSES MANUFACTURED BETWEEN OCTOBER 11, 2005, AND OCTOBER 31, 2006. THESE BUSES HAVE THE FOLLOWING SAFETY ISSUES: IF THE DRIVER'S SEAT IS IN THE HIGHEST AND MOST REAR POSITION, THE BACK OF THE SEAT MAY LEAN AGAINST A BARRIER BEHIND THE SEAT, OR AGAINST THE SEAT BACK. THIS WILL PREVENT THE SEAT BELT FROM RETRACTING WHICH FAILS TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 209, SEAT BELT ASSEMBLIES. WHEN ADJUST THE SEAT TO A HIGHER POSITION, THE DRIVER MAY PULL THE SEAT PAST THE LAST STOP SO THAT THE SEAT SITS ON THE ADJUSTING PIN, WHICH ALLOWS THE SEAT TO TEETER ON TOP OF THE PIN. IF OVER-TRAVEL OCCURS, THE UPPER SEAT PEDESTAL TUBE COULD SEPARATE FROM THE LOWER PEDESTAL TUBE DURING VEHICLE OPERATION. IF THE DRIVER IS SITTING IN THE DRIVER'S SEAT AND REACHES TO ADJUST THE SEAT HEIGHT, THEIR WEIGHT WILL CAUSE THE SEAT TO DROP, WHICH COULD RESULT IN THEIR HAND BEING PINCHED BETWEEN THE SEAT AND THE LEVER. THE DRIVER'S SEAT IS DIFFICULT TO ADJUST TO A HIGHER POSITION BECAUSE OF THE ADDITIONAL WEIGHT OF THE ALL BELTS TO SEAT (ABTS) DESIGN.