2010 Ic Bus Fe

ENGINE AND ENGINE COOLING:COOLING SYSTEM:FAN

NAVISTAR IS RECALL 7,521 MY 2009 INTERNATIONAL MODEL TRUCKS AND MY 2009 AND 2010 IC SCHOOL AND TRANSIT BUSES MANUFACTURED FROM APRIL 1, 2008 TO DECEMBER 12, 2008, EQUIPPED WITH A HORTON 2-SPEED FAN DRIVE, IDENTIFIED BY FEATURE CODE 12THT. THE FASTENERS THAT CONNECT THE MAGNET BRACKETS TO THE AIR CHAMBER HOUSING OF THE 2-SPEED ENGINE FAN COULD FAIL RESULTING IN THE MAGNET BRACKET BEING THROWN FROM THE FAN DRIVE AND THE VEHICLE AT HIGH SPEED.

EQUIPMENT:APPLIANCE:AIR CONDITIONER

NAVISTAR IS RECALLING 630 MODEL YEAR 2009 AND 2010 IC SCHOOL AND COMMERCIAL BUSES MANUFACTURED BETWEEN FEBRUARY 1, 2008 AND JULY 6, 2009, EQUIPPED WITH TRANS/AIR AIR CONDITIONING SYSTEMS. EACH TRANS/AIR SYSTEM COMES WITH AN ELECTRICAL KIT AND EC PC BOARD WHICH IF IMPROPERLY INSTALLED COULD OVERHEAT.

EXTERIOR LIGHTING:HEADLIGHTS

NAVISTAR IS RECALLING CERTAIN IC MODEL YEAR 2010 FE AND RE SCHOOL BUSES MANUFACTURED FROM JUNE 1 THROUGH AUGUST 19, 2009. THE WIRES IN THE HEADLIGHT ELECTRICAL HARNESS MAY HAVE BEEN INSTALLED IN THE INCORRECT CONNECTOR CAVITIES RESULTING IN DEGRADED LOW BEAM HEADLIGHT INTENSITY. THE VEHICLE'S LOW BEAM HEADLIGHTS DO NOT MEET THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT."

SERVICE BRAKES, HYDRAULIC

NAVISTAR HAS NOTIFIED NHTSA ABOUT A DEFECT IN CERTAIN MODEL YEAR 2010 AND 2011 IC CE, BE, AND FE SCHOOL BUSES MANUFACTURED FROM NOVEMBER 19, 2003 THROUGH FEBRUARY 9, 2010. THE PARKING BRAKE MAY RELEASE IF THE BRAKE SYSTEM ELECTRONIC CONTROL UNIT SOFTWARE MISINTERPRETS INPUT SIGNALS GENERATED FROM CYCLING THE IGNITION SWITCH MORE THAN ONCE AT A SPECIFIC FREQUENCY.

EQUIPMENT ADAPTIVE/MOBILITY

NAVISTAR IS RECALLING CERTAIN MODEL YEAR 2009 THROUGH 2011 IC CE, FE, RE, AND BE MODEL SCHOOL BUSES MANUFACTURED FROM DECEMBER 10, 2007 THROUGH JANUARY 12, 2010 AND FITTED WITH RICON PUBLIC USE LIFTS. THE RESTRAINT BELT ON THESE LIFTS WAS DESIGNED TO PREVENT THE LIFT FROM MOVING, UNLESS THE TONGUE OF THE BELT IS FULLY ENGAGED AND LATCHED IN THE BUCKLE. RICON HAS DISCOVERED, HOWEVER, THAT IT IS POSSIBLE FOR THE OPERATOR TO INSERT THE BELT TONGUE INTO THE BUCKLE WITHOUT FULLY ENGAGING THE LATCHING MECHANISM. IN THIS CASE, THE RESTRAINT BELT WOULD APPEAR TO BE LATCHED, AND THE OPERATOR COULD RUN THE LIFT. IF THE RESTRAINT BELT TONGUE IS NOT FULLY ENGAGED INTO THE RESTRAINT BELT BUCKLE, AND LATCHED, THE LIFT MAY OPERATE WITH AN OCCUPANT ON THE PLATFORM.