2008 Honda Fit

AIR BAGS:FRONTAL

ON CERTAIN VEHICLES ORIGINALLY SOLD IN OR CURRENTLY REGISTERED IN THE STATES OF CONNECTICUT, DELAWARE, ILLINOIS, INDIANA, IOWA, KENTUCKY, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN, MINNESOTA, MISSOURI, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT, VIRGINIA, WEST VIRGINIA , WISCONSIN AND THE DISTRICT OF COLUMBIA. THE WIRE HARNESS FOR THE OCCUPANT DETECTION SYSTEM (ODS) AND THE OCCUPANT POSITION DETECTION SYSTEM (OPDS) IS ROUTED UNDERNEATH THE CARPET ON THE DRIVER'S SIDE FLOORBOARD. IN AREAS WHERE ROAD SALT IS USED, SALT FROM THE SNOW ON THE DRIVER'S SHOES WILL MELT AND MAY PENETRATE THE CARPET AND LEAK INTO THE WIRE HARNESS. IF THE HARNESS IS EXPOSED TO SALT BRINE, CORROSION MAY OCCUR AND THE WIRE MAY BREAK CAUSING THE SRS INDICATOR LIGHT TO ILLUMINATE. A FAILURE OF THE ODS AND OPDS MAY NOT DETECT THE PRESENCE OF A CHILD SEAT OR AN OUT-OF-POSITION PASSENGER AND DEPLOYMENT OF BOTH THE FRONT SEAT PASSENGER'S FRONTAL AND SIDE AIR BAGS WILL NOT BE SUPPRESSED.

VISIBILITY:POWER WINDOW DEVICES AND CONTROLS

HONDA IS RECALLING CERTAIN MODEL YEAR 2007-2008 FIT VEHICLES. UNDER SEVERE CONDITION, WATER MAY ENTER THE DRIVER'S WINDOW AND REACH THE MASTER POWER WINDOW SWITCH. IF THE MASTER POWER WINDOW SWITCH IS DAMAGED AS A RESULT OF THE WATER INTRUSION, OVERHEATING AND FAILURE OF THE SWITCH MAY RESULT.

EXTERIOR LIGHTING:HEADLIGHTS:HIGH/LOW BEAM DIMMER SWITCH

HONDA IS RECALLING MODEL YEAR 2007-2008 HONDA FIT VEHICLES. DUE TO AN ERROR DURING INSTALLATION OF THE WIRING HARNESS FOR THE COMBINATION SWITCH THAT CONTROLS LOW HEAD BEAM FUNCTION, THE WIRES FOR THE LOWER BEAM CIRCUIT WERE PULLED TIGHTER THAN INTENDED. AFTER REPEATED USE OF THE HEADLIGHT SWITCH, THE ELECTRICAL CONNECTOR TERMINAL FOR THE LOW BEAM HEADLIGHT CIRCUIT CAN BECOME WORN AS A RESULT OF THIS TENSION, WHICH CAN RESULT IN LOW CONDUCTIVITY AND CAUSE AN ACCUMULATION OF COPPER OXIDE IN THE AREA OF THE CONTACTS.

VISIBILITY:POWER WINDOW DEVICES AND CONTROLS

Honda is re-recalling certain model year 2007-2008 Fit vehicles covered under previous recall 10V-033. The remedy applied in this earlier recall may have been insufficient. In the affected vehicles, over time, the plastic cover may separate from the master power window switch allowing water to enter the driver's window and reach the master power window switch. If the master power window switch is damaged as a result of the water intrusion, overheating and failure of the switch may result.

AIR BAGS:FRONTAL:PASSENGER SIDE:INFLATOR MODULE

Honda (American Honda Motor Co.) is recalling certain model year 2003-2006 Acura MDX, 2005-2011 Acura RL, 2005-2006 Honda CR-V, 2003-2011 Element, 2007-2008 Fit, 2003-2008 Pilot, 2002-2004 Odyssey, and 2006-2011 Ridgeline vehicles originally sold, or that have ever been registered, in Alabama, California, Florida, Georgia, Hawaii, Louisiana, Mississippi, South Carolina, Texas, Puerto Rico, American Samoa, Guam, the Northern Mariana Islands (Saipan), and the U.S. Virgin Islands, or "Zone A." Additionally, unless included in "Zone A" above, Honda is recalling certain model year 2003-2006 Acura MDX, 2005-2008 Acura RL, 2005-2006 Honda CR-V, 2003-2008 Element, 2007-2008 Fit, 2003-2008 Pilot, 2002-2004 Odyssey, and 2006-2008 Ridgeline vehicles originally sold, or that have ever been registered, in Arizona, Arkansas, Delaware, District of Columbia, Illinois, Indiana, Kansas, Kentucky, Maryland, Missouri, Nebraska, Nevada, New Jersey, New Mexico, North Carolina, Ohio, Oklahoma, Pennsylvania, Tennessee, Virginia, and West Virginia, or "Zone B." Lastly, unless included in "Zone A" or "Zone B" above, Honda is recalling model year 2002-2004 Odyssey and model year 2003-2004 Acura MDX, Honda Element, and Honda Pilot vehicles originally sold, or registered, in Alaska, Colorado, Connecticut, Idaho, Iowa, Maine, Massachusetts, Michigan, Minnesota, Montana, New Hampshire, New York, North Dakota, Oregon, Rhode Island, South Dakota, Utah, Vermont, Washington, Wisconsin, and Wyoming. These vehicles are equipped with certain air bag inflators assembled as part of the passenger frontal air bag modules, and used as original equipment or replacement equipment. In the event of a crash necessitating deployment of the front air bags, these inflators may rupture due to propellant degradation occurring after long-term exposure to absolute humidity and temperature cycling.