2007 Hino Nv8j

STEERING:LINKAGES

ON CERTAIN TRUCKS, DURING ASSEMBLY, THE DRAG LINK ATTACHMENT NUTS AT THE PITMAN ARM AND STEERING ARM MAY HAVE BEEN INCORRECTLY TORQUED. RESIDUAL GREASE AND PAINT WHICH WAS APPLIED AS A RUST INHIBITOR ON THE STEERING ARM MAY HAVE CONTRIBUTED TO A LOSS OF TORQUE AFTER ASSEMBLY.

SERVICE BRAKES, AIR:SUPPLY:HOSES, LINES/PIPING, AND FITTINGS

ON CERTAIN CAB AND CHASSIS TRUCKS THAT WERE TRANSPORTED TO THE SELLING LOCATION OR BODY COMPANY USING A DECKING SYSTEM (VEHICLES STACKED ON THE REAR OF THE LEAD TRUCK FOR TRANSPORT), THE AIR BRAKE LINES MAY BE DISCONNECTED SO THAT THE BRAKING SYSTEMS CAN BE TIED TOGETHER WITH THE OTHER VEHICLES. WHEN THESE VEHICLES ARRIVE AT THEIR DESTINATION, THE AIR BRAKE LINES ARE RECONNECTED. THESE RECONNECTIONS WERE NOT ALWAYS BEING TIGHTENED TO THE PROPER TORQUE. ALSO, DURING THIS RECONNECTION PROCESS, SOME OF THE ABS WIRING CLIPS HAD BEEN REMOVED AND NOT REINSTALLED.

STRUCTURE

ON CERTAIN VEHICLES, DURING THE STAMPING PROCESS, SOME CROSSMEMBERS WERE MANUFACTURED WITH A DEFORMATION TO THE LOWER CORNERS DUE TO EXCESSIVE WEAR OF THE STAMPING DIE. OVER TIME, IF THIS CONDITION WERE IGNORED, THE STRUCTURAL INTEGRITY OF THE CROSSMEMBERS COULD BE COMPROMISED WHICH COULD RESULT IN A LOSS OF BRAKING ABILITY, SEPARATION OF THE PROPELLER SHAFT AND/OR A LOSS OF REAR WARNING LAMPS.

ENGINE AND ENGINE COOLING

ON CERTAIN TRUCKS EQUIPPED WITH BANDO BELT TENSIONER, CORROSION OR RUST MAY DEVELOP ON THE TENSIONER SPINDLE OR BUSHING CAUSING THE AUTO TENSIONER TO BECOME STIFF OR BIND. THIS CAN CAUSE THE DRIVE BELT TO SUDDENLY COME OFF OR THE AUTO TENSIONER MOUNTING BOLTS COULD SUDDENLY BREAK.

SUSPENSION:FRONT

HINO IS RECALLING 16,805 MY 2005-2008 NA6J, NB6J, NC6J, ND8J, NE8J, NJ8J, AND NV8J TRUCKS. THE TWO VERTICAL RIGHT/LEFT SIDE FRONT SPRING BRACKET BOLTS WERE NOT TIGHTENED PROPERLY DURING THE ASSEMBLY PROCESS. THIS MAY CAUSE INCREASED STRESS ON THE SPRING BRACKET WHICH CAN LEAD TO CRACKING OF THE BRACKET.