2016 Prevost H3-Vip TSBs
66 Technical Service Bulletins across 13 categories
Categories
Engine
16 bulletinsImproved bearings are now available to replace the original bearings used on some Prevost vehicles idler pulleys.
Diesel Exhaust Fluid ( DEF ) Contamination In Fuel System, Inspection And Repair From US10 to newer engine generation
Bendix M-32QR ABS modulator valve replaced by new M-40QR valve.
INTRODUCING A NEW ENGINE COOLANT INTO PREVOST SERVICE CENTER NETWORK
Rev A: Mention added concerning DDC Series 60 engine SCA requirement
INTRODUCING A NEW ENGINE COOLANT INTO SERVICE
This Mainteannce Informaiton presents the latest engine oil & filter change intervals for the Volvo Engine
This Maintenance Information explains how to perform an inspection of the vehicle power cables.
Read full bulletin
Power cables in poor condition can be the cause of failures and serious damages in the engine compartment.
This instruciton sheet explains how to relocate the RV-3 Valve
The Beru sensors used on Prevost vehicles to monitor tire pressure (TPMS system) are being replaced by new Huf sensors...
Read full bulletin
and their corresponding stainless valves stems. Since the older and newer sensors are using different valve stems, replacement of a defective sensor on older vehicles will require the use of a new kit number (valve stem and sensor assembly). The table below provides a quick overview between the older and newer part numbers depending on wheel application.
This Maintenance Information shares information about a new Automatic control mode now available on Prevost vehicles...
Read full bulletin
equipped with the Volvo Engine Brake (VEB).
On the vehicles affected by this bulletin, replace the engine information decal located in the engine compartment.
On the vehicles affected by this bulletin, replace the engine information decal located in the engine compartment.
The Beru sensors used on Prevost vehicles to monitor tire pressure (TPMS system) are being replaced by new Huf sensors...
Read full bulletin
and their corresponding stainless valves stems. Since the older and newer sensors are using different valve stems, replacement of a defective sensor on older vehicles will require the use of a new kit number (valve stem and sensor assembly). The table below provides a quick overview between the older and newer part numbers depending on wheel application.
The Beru sensors used on Prevost vehicles to monitor tire pressure (TPMS system) are being replaced by new Huf sensors...
Read full bulletin
and their corresponding stainless valves stems. Since the older and newer sensors are using different valve stems, replacement of a defective sensor on older vehicles will require the use of a new kit number (valve stem and sensor assembly). The table below provides a quick overview between the older and newer part numbers depending on wheel application.
This Maintenance Information shares information about the Bendix M-32QR valve replaced by M-40QR model htat need to be...
Read full bulletin
taken into consideration, specially when switching them for the first time on a vehicle.
Other
11 bulletinsAir Tanks Draining Sequence.
Read full bulletin
Revision: A - Erroneous Secondary & Accessory tanks location.
Air Tanks Draining Sequence
H3 SERIES ENVIROCARE - IONS AIR SANITIZER
Repair instructions to address fault codes P207F-00; P20EE-00
Repair instructions to address fault codes P207F-00 - Reductant Quality
Repair instructions to address fault codes P008A-00; P0087-00
PREVOST VEHICLE DISINFECTION PROCEDURE
This instruction sheet explains how to install and adjust drag link # 660699
On the vehicles affected by this bulletin, it is now possible to replace the older generation TGW 2.0 (3G network) by...
Read full bulletin
the newer 2.1 version (4G the network) using accessory kit 23266301 and the following procedure.
This conversion kit explains how to to disable the ACB radar.
On the vehicles affected by this bulletin, inspect and re-torque the Prevost slide-out rail bolts.
Read full bulletin
If damaged, replace bolts.
Electrical
10 bulletinsBOSCH HD10 ALTERNATOR DIAGNOSTIC GUIDE Revision B To avoid replacement of alternators that are in fact in good...
Read full bulletin
working order, perform the steps which follow to help you perform a more precise diagnosis.
Use this procedure for the removal and installation of the twin Bosch HD10 (120A or 150A) Alternators.
GENERAL HOISTING AND TOWING PROCEDURES Revision: B Updated 2.1 to show rubber chocks, secure front and rear.
Added: Power cables for L.H.
Read full bulletin
side alternator & fan drive breaker box
On the vehicles affected by this bulletin, the power cable stud adapter on the alternator must be inspected and if...
Read full bulletin
needed, replaced.
This Maintenance Information presents guidelines to help with the diagnosis of the Bosch HD10 alternators
This Maintenance Information explains how to remove and install the Bosch HD10 (120A or 150A) alternators
This procedure explains how to perform a STARTER REMOVAL AND INSTALLATION, and does apply to Melco 105P70 starter part...
Read full bulletin
number #21212425.
This Maintenance Information explains how to remove and install the Bosch HD10 (120A or 150A) alternator.
ON THE VEHICLES AFFECTED BY THIS BULLETIN, VIBRATION IS CAUSING DAMAGE TO A/C COMPRESSOR AND COMPRESSOR HARNESS CONNECTORS.
Read full bulletin
ADDITION OF A REINFORCEMENT BRACKET TO BITZER A/C COMPRESSOR IS NEEDED TO INCREASE THE INSTALLATION STIFFNESS AND REDUCE VIBRATION AMPLITUDE.
Suspension
5 bulletinsTAG AXLE HUB FLANGE - ALTERNATE CAP SCREW
RONT & TAG AXLE UNITIZED HUB BEARING END PLAY VERIFICATION AND REPLACEMENT
Use this procedure when a suspension height check or adjustment must be performed.
This information letter applies only to vehicles equipped with 19000 lb Independent Front Suspension (IFS) and 22.5 x...
Read full bulletin
10.5 Alcoa aluminum wheels for 365/70 R 22.5 size tires. When balancing this wheel for installation on the IFS, a specific type and size of clamp-on wheel weight should be used to provide the appropriate clearance with components of the suspension.
This maintenance information applies only to vehicles equipped with 19000 lb Independent Front Suspension (IFS) and 22.5...
Read full bulletin
x 10.5 Alcoa aluminum wheels for 365/70 R 22.5 size tires. When balancing this wheel for installation on the IFS, a specific type and size of clamp-on wheel weight should be used to provide the appropriate clearance with components of the suspension.
Pre-Delivery & Maintenance
5 bulletinsSTORAGE AND STARTUP GUIDELINES: Periodically, circumstances arise requiring operators to temporarily park a coach in storage.
Read full bulletin
Whether it is a few weeks or several months, sporadic out of service times or a full stop, Prevost recommends following the guidelines in this document during times when: The coach can be operated on a regular/weekly basis while in storage. The coach will be in storage for an extended period without any operation. The coach will return to service following an extended period of downtime.
STORAGE AND STARTUP GUIDELINES Revision: B Parts added to Suggested Material 08-10-2020
STORAGE AND STARTUP GUIDELINES - ALL PREVOST VEHICLES & VOLVO 9700
This maintenance information explains how to tow and hoist Prevost vehicles.
This Maintenance Information does explain how five year old vehicles and older should be subjected to a thorough...
Read full bulletin
structural inspection.
Software & Calibration
4 bulletinsAir Tanks Draining Sequence.
Read full bulletin
Revision: B - General Update
STORAGE AND STARTUP GUIDELINES : part number updates
On the vehicles affected by this bulletin, update EMS and ACM software to the latest version available.
This Maintenance Information explains that decals are available to update the front junction box on 2013 to 2016 Prevost...
Read full bulletin
vehicles; the decals will provide updated information and component descriptions. Refer to the identification part of this bulletin to locate the decal part number currently used on specific vehicles.
Steering
3 bulletinsSTEERING GATEWAY. Revision B - PIN 2 and 10 were inverted on connector A139
STEERING GATEWAY, revision A : Cancel watch dog removal from EFD part of the instruction
STEERING GATEWAY Revision A Cancel watch dog removal from EFD part of the instruction
HVAC & Climate
3 bulletinsCENTRAL HVAC MERV FILTERS INSTALLATION
CENTRAL HVAC MERV FILTERS INSTALLATION REVA
This Maintenance Information presents information about the Bitzer A/C compressor oil change interval and reminds...
Read full bulletin
technicians to clean the oil filter/strainer and the magnetic drain plug.
Brakes
3 bulletinsBRAKE PEDAL SEAL PLATE INSTALLATION KIT
This Instruction Sheet explains how to install the AWARE ADAPTIVE CRUISE BRAKING (ACB) FLR20 RADAR SENSOR REPLACEMENT...
Read full bulletin
kits # 145372 and 145373
This Instruction Sheet explains how to install the AWARE ADAPTIVE CRUISE BRAKING (ACB) FLR20 RADAR SENSOR REPLACEMENT...
Read full bulletin
kits # 145372 and 145373
Transmission
3 bulletinsVOLVO I-SHIFT TRANSMISSION REPLACEMENT - DIFFERENCE BETWEEN CONNECTIONS AT THE TOP OF THE OIL FILTER HOUSING
VOLVO I-SHIFT TRANSMISSION REPLACEMENT - DIFFERENCE BETWEEN CONNECTIONS AT THE TOP OF THE OIL FILTER HOUSING
JERKY, NOISY OR HARD TO TURN STEERING GEARBOX.
Read full bulletin
HYDRAULIC END LIMITER ADJUSTMENT. All models equipped with RB Bosch/ZF Servocom or Servocomtronic steering gearbox
Lighting
1 bulletinHalogen to LED fog light replacement kit.
Read full bulletin
Revision: C - Advanced kits canceled
Hybrid & EV
1 bulletinSTORAGE AND STARTUP GUIDELINES: Rev A: 21516229 replaced by 23381562 20523393 replaced by 21454749 800383 removed ...
Read full bulletin
611471 replaced by 611360 70376808 replaced by 21036050 21396642 replaced by 20967831
Fuel System
1 bulletinThis Maintenance Information explains how to inspect the Fuel Tank Cradle Mounting Screws on a yearly basis