2005 Prevost H3-45 TSBs

H3 LAVATORY FAN RETROFIT KIT

Air Tanks Draining Sequence.

Air Tanks Draining Sequence

Revision : A Torque value reduced

LAVATORY FAN RETROFIT KIT Applicable for H3 Series coaches from R-1012 (1994) Revision A: Added installation detail at...

H3 DRIVERS PARTITION LITE INSTALLATION

SIGMA PASSENGER SEATS PARTITION KIT

PREVOST VEHICLE DISINFECTION PROCEDURE

HAND SANITIZER DISPENSER INSTALLATION

PREVOST: INSTALL DECAL WARNING AGAINST PERFORMING ANY WELDING WORK.

PREVOST - INSTALLING DECAL WARNING AGAINST PERFORMING ANY WELDING WORK.

COPPER PIPING AND CONNECTOR REPLACEMENT AT WATER PUMP INLET.

Added: Power cables for L.H.

Revision : Addition of Wiring Schematics at the end of this document

This instruction sheet explains how to replace HVAC MODULE on certain vehicles;

This instructions sheet explains how to replace the slide-Out Module 563430

This Instruction Sheet explains how to repalce 062720 AND 063344 AC MODULES, that are obsolete and replaced by a new...

This internal instruction explains how to bench program the FMS gateway module used in the ELD (Electronic Logging...

This Instruction sheet explains how to remplace MASTER ID? WITH ?MCM? MODULE

This instructions sheet explains how to replace Slide-Out Module 563430

Rev A: Mention added concerning DDC Series 60 engine SCA requirement

INTRODUCING A NEW ENGINE COOLANT INTO SERVICE

Engine Exhaust Gas Recirculation Differential Pressure - Mechanical system not responding properly US13 US20...

This instruction sheet explains how to relocate engine door gas spring.

This instruction sheet explains how to relocate engine door gas spring.

POWER WINDOW HARNESS- REMOVAL OF ZENER SUPPRESSOR DIODES.

PREVOST: NEW FIXING HARDWARE FOR THE REAR HEIGHT CONTROL VALVE LINK ROD.

STEERING GATEWAY. Revision B - PIN 2 and 10 were inverted on connector A139

TIE ROD 610052 FIRST INSTALLATION INSTRUCTIONS: Use these instructions when replacing the drop joint tie rod on S82, S84 / S84U I-beam axles.

This Instruction Sheet explains how to perform the first installation of Tie Rod 610052 on Prevost vehicles equipped...

Vehicles identified below are compatible with a new tie rod design.

This instruction sheet explains how to install the Tie Rod 610052.

INSPECTION & REPLACEMENT OF POWER STEERING PRESSURE HOSE.

FAN CLUTCH PLATE BOLTS RE-TORQUING

JERKY, NOISY OR HARD TO TURN STEERING GEARBOX.

PREVOST: REMOVE ZF TRANSMISSION NEUTRAL POSITION RELAY ON H3 MULTIPLEX VEHICLES.

REMOVAL OF ZF TRANSMISSION NEUTRAL POSITION RELAY ON H3 MULTIPLEX VEHICLES.

MODIFICATION OF SPEED SENSOR CONNECTORS ON ALLISON WORLD TRANSMISSION.

Sway bar collars improvement.

SWAY BAR COLLARS IMPROVEMENT

FRONT AND TAG AXLE HUB BEARING AND KING PIN PERIODIC MAINTENANCE.

CENTRAL HVAC MERV FILTERS INSTALLATION

CENTRAL HVAC MERV FILTERS INSTALLATION REVA

This instruction sheet explains how to replace the two older generation (brush type) condenser fans by four newer style...

STORAGE AND STARTUP GUIDELINES: Periodically, circumstances arise requiring operators to temporarily park a coach in storage.

STORAGE AND STARTUP GUIDELINES Revision: B Parts added to Suggested Material 08-10-2020

STORAGE AND STARTUP GUIDELINES - ALL PREVOST VEHICLES & VOLVO 9700

MP-1000 MULTIMEDIA PLAYER INSTALLATION

MESSAGE CENTER DISPLAY (MCD) REPLACEMENT

Air Tanks Draining Sequence.

Halogen to LED fog light replacement kit.

STORAGE AND STARTUP GUIDELINES: Rev A: 21516229 replaced by 23381562 20523393 replaced by 21454749 800383 removed ...

This instruction sheets explains how to replace the fuel tank on H-series vehicles.

PREVOST: INSTALLING THREE-POINT PASSENGER SEAT RESTRAINT SYSTEM.

IMPROVED AIR CIRCULATION ON H3 COACHES EQUIPPED WITH WCL AND SLIDING DOOR.