2023 Peterbilt 520 TSBs

This update provides customers with additional time to service their trucks before a DEF-related derate occurs. The software is being offered to customers in alignment with recently updated regulatory agency guidance.

This update provides customers with additional time to service theirtrucks before a DEF-related derate occurs. The software is being offered to customers in alignment withrecently updated regulatory agency guidance."

policy."

policy."

without a check valve in the power steering system.

specifications.

engines.

Control Unit (VECU) part number Q21-1157-013-011 / Q21-1157-013-013. Parts and procedures for Phase 2 chassis will be available at a later date. This bulletin will be updated at that time. Please refer to the condition section for more details. Certain Ethernet Multiplexed Architecture (EMUX) chassis fail to conform to Federal and Canada Motor Vehicle Safety Standards (FMVSS/CMVSS) No. 108. Delayed or unsteady illumination of the vehicles stop lamps, reverse lamps, turn signal lamps and inadvertent change in headlamp illumination or lift axle position may"

Injectors must be replaced as a full set (6 injectors) and associated software must be updated at the same time.

PCI-2 software on these chassis must be reverted from NA202 to NA201 (Pack 2 injectors) or from NA206 to NA191 (Pack 1 injectors) to prevent incorrect STOP lamp display.

A new Starter Troubleshooting Guide has been created to provide a comprehensive list of starting system checks, which should reduce unnecessary starter replacements and associated warranty claims. Engine starting system warranty claims now require a completed Starter Checklist, a Battery Pack Midtronics Report, and a Cable Drop Midtronics Report. Claims filed without these documents may be denied.

Fuel Filters must be changed before first cleaning. EPA2021 injector cleaning is referenced in RMI for certain injector faults. Complete the procedures in E290. Discard any previous versions of E290 procedures always use the most current document from the link in the bulletin.

With full suspension articulation, HCV bracket flexes and toggles over center the HCV linkage, which results in either deflated airbags or makes them unable to inflate. Fix-as-fail start date is 07/30/2024.

.Debris and contaminants introduced into the high-pressure fuel system. .Denial of warranty claims for injector and/or fuel system faults. .Misfire, rough running, engine knock, and other associated faults and symptoms. Correct fuel filter procedures are outlined in attached service documentation.

This is a one-time reimbursement. Only customers who have received E290 injector cleaning qualify for this reimbursement. See bulletin for limits and purchase tracking requirements.

Production-level engine, VECU, and Digital Display software is now available to make these vehicles compliant. New Engine Emissions and Clean Idle labels will be installed.

Cummins X15, X12, ISX12, ISX12N, L9N, PX-7, and PX-9 engines The technology will leverage the existing Remote Diagnostic cs hardware to deliver secure software updates remotely. This will reduce downtime and save on maintenance costs for eligible vehicles.

control unit (VECU2) and digital display (DD). Steps have also been added to the PACCAR Common Rail Injection 2 (PCI2) software verification.

part number Q21-1157-013-011 / Q21-1157-013-013 / Q21-1157-002-002 / Q21-1157-004-004 / Q21-1157-006-006 / Q21-1157-009-009. See attached Parts Matrix for required parts per chassis.

Certain Peterbilt 579EV and 520EV chassis have the First Responder Guide (FRG) label incorrectly showing the cut loop on the wrong side and are missing the Low Voltage Battery Disconnect Switch and Do Not Jump Start labels. These labels are now available for installation.

to provide general use information. The new EMUX Service Tool Kit improves cab & chassis electrical troubleshooting efficiency, while reducing risk of component damage. 4/29/2025: The Ethernet Multiplexed Architecture (EMUX) Service Tool Kit and individual kit components are now available to order. Dealers that have received their first kit may order an additional kit. The EMUX Service Tool Kit Part number has been updated to match OEM drawings (P74-1045-001). Individual kit component part numbers can be found in the Reference Bill of Materials sheet. The new EMUX Service Tool Kit improves cab & chassis electrical troubleshooting efficiency, while reducing risk of component damage. Information Only New diagnostic tool is required to support PACCAR Ethernet Multiplexed Architecture (EMUX). The EMUX Service Tool Kit will help improve cab & chassis electrical troubleshooting efficiency, while reducing the risk of component damage.

Voltage Interlock Loop (HVIL)circuit configurations may experience a sudden loss of high voltage power with unintended opening of electrical contactors, which may occur without warning. This can result in a loss of propulsion and may increase the risk of a crash. This bulletin will be updated once parts and procedures are available.

This software update corrects or improves certain functions. Software update procedures have been revised. Campaign start date is 12/05/2024. Campaign A software update is available for 520EV and 579EV Battery Electric Vehicles. This software update corrects or improves certain functions. Campaign start date is 12/05/2024.

Loop(HVIL) circuit configurations may experience a sudden loss of high voltage power with unintended opening of electrical contractors, which may occur without warning. This can result in a loss of propulsion and may increase the risk of a crash. Software version verification, along with the installation of an upgraded circuit overlay harness kit, is required to address this issue.

Low Voltage Distribution System (LVDS) Components. Affected chassis will be inspected and necessary components will be installed.

The EMUX Service Tool Kit will help improve cab & chassis electrical troubleshooting efficiency, while reducing the risk of component damage.

Vehicles.

The currently available soft ware, part number:SCM_1p5_BC_R5p00_003, will address issues caused by software version R5.00_002 that affect Peterbilt Model 520EV. The software update will correct the following issues: 1.) Power gauge displays axle RPM instead of power draw, 2.) Air conditioning compressor is inoperative below 10 mph (16 kmh) and over 40 mph (65 kmh), 3.) Low air and low coolant audible alarms (buzzers) are inoperative below 10 mph (16 kmh), and 4.) (520EV Only) Does not charge without ignition in on position.

latest prognostics bulletin verbiage. The Warranty section has also been updated to include Peterbilt specific SRT codes for filing cross-division repairs.

The bulletin will be updated when more information is available."

procedure has been updated with additional note boxes for clear instructions. PB: The repair procedure has been updated with additional note boxes for clear instructions."

Support Order Inquiry case.

Software updates are now available to complete this campaign.

EPA2021 injector cleaning is referenced in RMI for certain injector faults. Complete the procedures in E290. Refer to E300 for in-tank additive information.

2 chassis added to the chassis list. Peterbilt: Dealers should check the chassis list and SIR weekly for VIN changes. 10 chassis added to the chassis list."

Parts kits are now available to install the Bendix Side Collision Mitigation Radar system (BlindSpotter) on chassis that were delivered with a prewire sales code due to parts shortages. Ordering and installation procedures are included.

Operators Manuals are incorrect.

Removed in-tank additive references.

This may cause an intermittent warning light on the dash display.

once they are off the production line, but still on the premises. The tags are left on the trucks which have been sold.

The cab heater coolant system on Peterbilt 579EV and 520EV models may not deaerate properly, causing pump malfunctions and inadequate cab heating. Update coolant deaeration return line parts and procedures are now available to release trapped air back to the reservoir.

Certain Vehicle Model Year 2021-2025 Peterbilt chassis configured for trailer towing require a software update for the Bendix EC80 ABS ECU. Software update procedures for certain Battery-Electric Vehicles (BEV) and EC80 ABS ECU part numbers are not yet available. This bulletin will be updated when software update procedures are available for these chassis. Safety Recall publish date: 1/10/25