2015 Mitsubishi Outlander TSBs

conditioner, ventilation vents) when the blower motor is turned on.

system for affected vehicles.

complains that the engine will not start while using the remote start system.

vents) when the blower motor is turned on.

affected vehicles with improved countermeasure parts. Due to a change in the reclining motor, the new longer harness and connector are necessary.

affected vehicles with improved countermeasure parts. Due to a change in the reclining motor, the new longer harness and connector are necessary.

of absorbers unnecessarily when trace amounts of oil are noted to have adhered to the shock absorber.

of absorbers unnecessarily when trace amounts of oil are noted to have adhered to the shock absorber.

ISSUED January, 2016, to add 2016 model year Outlander, and updated ECM software. Revisions are italicized and indicated by. - Affected vefhicles may exhibit a condition where the engine is hard to re-start if engine coolant temperature is low. Due to inappropriate programming in the engine ECM, IF THE COOLANT TEMPERATURE IS BETWEEN 32 - 68 f (0-20 C) a hard to re-start condition may occur.A new software that will resolve fthis concern.

Exhaust Manifold and instructs dealers to replace the Heat Protector Assembly with a new part.

Motor Magneto Malfunction diagnosis procedure.

This bulletin updates the Engine cooling section of the affected Service Manuals, to correct the on-vehicle service information and the coolant replacement procedure.

This bulletin updates the Engine Section of the affected Service Manuals, to revise the oil pan and timing chain case removal and installation procedure.

This bulletin updates the General section of the affect Service Manuals, to correct the lubricant capacity table and engine coolant change procedure.

The bulletin instructs dealers to confirm a list of specific Diagnostic Trouble Codes (DTCs) if vehicle experiences the following symptoms in cold weather: the check engine light illuminating with a limited vehicle speed (failsafe mode), or the engine does not restart after driving a short distance and stopping the engine for a few minutes. Once symptoms and DTCs are confirmed, dealers should replace the following relays with anti- freezing types: ETV, A/T (CVT), injector, and starter. This bulletin supersedes TSB-18-13-003, issued December, 2018, to add Eclipse Cross, applicable Canadian models, and countermeasure dates.

The bulletin instructs dealers to confirm a list of specific Diagnostic Trouble Codes (DTCs) if vehicle experiences the following symptoms in cold weather: the check engine light illuminating with a limited vehicle speed (failsafe mode), or the engine does not restart after driving a short distance and stopping the engine for a few minutes. Once symptoms and DTCs are confirmed, dealers should replace the following relays with anti- freezing types: ETV, A/T (CVT), injector, and starter. This bulletin supersedes TSB-18-13-003, issued December, 2018, to add Eclipse Cross, applicable Canadian models, and countermeasure dates.

This bulletin instructs dealers to how to fix a condition of a metallic knocking sound coming from the rear brakes. Affected vehicles experience this condition when the brake is applied while driving at low speeds, or on driving on uneven roads. Dealers are instructed to replace the rear brake pad clips (upper and lower) with new parts on affected vehicles, and to apply grease between the brake pad and caliper support.

The bulletin instructs dealers to confirm a list of specific Diagnostic Trouble Codes (DTCs) if vehicle experiences the following symptoms in cold weather: the check engine light illuminating with a limited vehicle speed (failsafe mode), or the engine does not restart after driving a short distance and stopping the engine for a few minutes. Once symptoms and DTCs are confirmed, dealers should replace the following relays with anti- freezing types: ETV, A/T (CVT), injector, and starter.

sections of the affected Service Manuals to update engine coolant capacities and replacement procedures.

2016, REGARDING UPDATED ECM SOFTWARE ECM REPROGRAMMING FOR HARD TO RE-START ENGINE WITH LOW COOLANT TEMPERATURE.

RELATING TO HARD TO RE-START ENGINE WITH LOW COOLANT TEMPERATURE.

MANUALS TO UPDATE THE ROCKER COVER INSTALLATION PROCEDURES.

FROM THE ROCKER COVER.

It covers various topics and reviews the previous months publications.

residue.

capacity be affixed to vehicles when the total net weight of accessories is more than 1.5 percent of the vehicle's gross vehicle weight rating (GVWR) or 100 lbs.

It covers various topics and reviews the previous months publications.

It covers various topics and reviews the previous months publications.

tape when customers complain the Power Seat Side Shield is coming off while entering/exiting the vehicle.

This bulletin supersedes TSB-16-54-005, issued October, 2016, to add replacement and registration of a new key set for cases where registration of the immobilizer ID still fails after performing the Immobilizer Registration Procedure in TSB-16-54-005.

*CN

connection when certain devices are connected to WiFi.

affected vehicles with improved countermeasure parts.

should be obtained.

terminals and again at the low beam halogen headlight bulbs for repair validation.

This bulletin provides dealers with a basic description of the hands-free systems used in Mitsubishi built vehicles. The bulletin covers components and operation, system layouts showing the differences in Japan built and U.S. built vehicles, diagnostic flow charts, a list of commonly used acronyms and terms, and part numbers. The bulletin also provides a comprehensive Hands-free/FUSE Information Sheet to guide the service writer in getting complete and accurate details from the customer. With this information, dealer personnel can answer questions and conduct an efficient diagnosis to resolve customer concerns as quickly as possible.

This bulletin provides dealers with a basic description of the hands-free systems used in Mitsubishi built vehicles. The bulletin covers components and operation, system layouts showing the differences in Japan built and U.S. built vehicles, diagnostic flow charts, a list of commonly used acronyms and terms, and part numbers. The bulletin also provides a comprehensive Hands-free/FUSE Information Sheet to guide the service writer in getting complete and accurate details from the customer. With this information, dealer personnel can answer questions and conduct an efficient diagnosis to resolve customer concerns as quickly as possible.

This bulletin updates the Circuit Diagrams section of the affected Service Manuals for the following areas: Taillight, Position Light, Rear Side Marker Light, License Plate Light, Light Monitor/Light Reminder Tone Alarm, Glove Box Light, Floor Console Box Light and Heated Seat.

This bulletin updates the Chassis Electrical section of the affected Service Manuals to update diagnostics for ETACS-ECU CAN timeout diagnostics with DTC U0141.

This bulletin updates the Supplemental Restraint System (SRS) section of the affected Service Manuals to update diagnostics for ETACS-ECU CAN timeout diagnostics with DTC U0141.

This bulletin updates the Body section of the affected Service Manuals to update diagnostics for ETACS-ECU CAN timeout with DTC U0141.

It instructs dealers to reprogram the AWC ECU with updated software to correct an issue, on certain vehicles, where the ETACS may transmit an incorrect signal, resulting in the 4WD warning indicator illuminating and DTC U0431 may be stored.

This notice informs dealers how to address stored DTCs (including P0657) in extremely cold ambient temperatures. Dealers can remedy this by replacing the throttle actuator control (TAC) relay.

MANUALS TO CORRECT A REFERENCE IN THE COMBINATION METER CHECK PROCEDURE CHART.

MAY EXHIBIT A CONDITION WHERE THE IGNITION CANNOT BE TURNED OFF WHEN BATTERY VOLTAGE DROPS. THIS TSB ALSO INCLUDES INSTRUCTION FOR DEALERS TO PROVIDE EXPLANATIONS TO CUSTOMERS REGARDING SYMPTOMS DUE TO LOW BATTERY VOLTAGE AND THAT BATTERY VOLTAGE SHOULD BE CHECKED AS PART OF ROUTINE VEHICLE MAINTENANCE.

P0139 OR P0171.

THE ETACS ECU.

the Service Brakes portion of the affected Service Manuals.

when customers report a condition where an abnormal rubbing noise is heard from the Seat Back when a driver and/or passenger is seated in the front seat(s).

driver and/or passenger is seated in the front seat(s) and instructs dealers to apply Nonwoven Fabric Tape between the Seat Back and Urethane Pad.

rear end portion of the seat cushion by a passenger, the cushion may sink down and rub against the edges of the metal seat frame. This in turn may cause the damaged urethane material to turn to powder and fall on the floor carpet. This TSB provides a repair procedure to replace the damaged seat cushion pad, and apply tape on the frame to help prevent future damage.

of abnormal noise from the rear shock absorber.

This bulletin updates the Rear Suspension section of the affected Service Manuals, to delete the requirement for an installation direction of the coil spring end of the shock absorber assembly.

This bulletin updates the Rear Suspension section of the affected Service Manuals, to delete the requirement for an installation direction of the coil spring end of the shock absorber assembly.

This notice provides instructions for addressing customer concerns of the brake warning light coming on due to low brake fluid in the brake fluid reservoir and brake fluid is found on the front of the brake booster.

IPHONE/IPOD/IPAD WHEN THE DEVICE IS CONNECTED TO WI‐FI. THIS UPDATE ADDRESSES UNSTABLE, REPEATEDLY CONNECTING AND DISCONNECTING FROM THE VEHICLE'S BLUETOOTH WHEN THE IPHONE'S WI‐FI IS ENABLED. THE CONDITION DOES NOT OCCUR WHEN WI‐FI IS TURNED OFF.

AFFECTED MODELS' SERVICE MANUALS.

Required Condition & Pre-Approval Center (PRC) for a vehicle pulling/drifting and/or with steering wheel off-center concerns.

alignment check and adjustment on an affected vehicle with a customer concern of pulling/drifting and/or steering wheel off-center concerns.

a wheel alignment check and adjustment on an affected vehicle with a customer concern of pulling/drifting and/or steering wheel off-center concerns.

photographs when performing a wheel alignment check and adjustment on an affected vehicle with a customer concern of pulling/drifting and/or steering wheel off-center concerns (while under warranty). This Notice supersedes TIN-17-37-001 released in July, 2017, to expand affected models and model years.

photographs when performing a wheel alignment check and adjustment on an affected vehicle with a customer concern of pulling/drifting and/or steering wheel off-center concerns (while under warranty).

photographs when performing a wheel alignment check and adjustment on an affected vehicle with a customer concern of pulling/drifting and/or steering wheel off-center concerns (while under warranty).

MAY EXHIBIT A CLICKING OR CREAKING NOISE FROM THE STEERING WHEEL CLOCK SPRING AREA WHEN TURNING THE STEERING WHEEL.

Windshield Wiper in the Exterior portion of the affected Service Manuals.

a natural phenomenon, and water penetration caused by improper sealing or a defective/broken part.

windshield Removal and Installation procedure for vehicles equipped with Forward Collision Mitigation System (FCM), Lane Departure Warning System (LDW), and Automatic High Beam System (AHB).

manuals.

This bulletin instructs dealers how to re-register vehicle keys for affected vehicles. Affected vehicles may experience a condition of the door(s) inability to be locked or unlocked using the Remote Keyless Entry (RKE) function. Dealers are instructed to re- register the ley using "Customer Key Programming" procedure in the Owner's Manual. This bulletin also provides Summary Table for Function Customization & Key Programming.

The bulletin updates the Body section of the affected Service Manuals to add the type of the hood latch mounting bolt and to correct the tightening torque for the hood.

REPLACEMENT OF THE TAILGATE GARNISH, IN CASES WHERE THE TAILGATE GARNISH CONTACTS THE REAR COMBINATION LAMPS.

to install the oil seal within the Automatic Transaxle sections of the applicable Service Manuals.

F1CJC/W1CJC (CVT-8) transmissions that may exhibit a shudder or surge condition possibly caused by a poor reaction of the hydraulic pressure circuit.

This bulletin updates the Automatic Transmission section of the affected Service Manual, to correct information in the diagnosis data list reference table for automatic transmissions F6AJA and W6AJA.

Variable Transmission.

MANUALS TO CORRECT THE CLAMPING TORQUE OF STEERING GEAR AND LINKAGE IN FRONT CROSSMEMBER REMOVAL AND INSTALLATION.

TOOLS USED IN THE CVT HYDRAULIC PRESSURE TEST IN THE INDICATED SERVICE MANUALS.

belt, related labels, inserts, and replacement of the second row right hand side seat belt (if needed).

belt buckle design on the second row seat.

belt, related labels, inserts, and replacement of the second row right hand side seat belt (if needed). Due to seat arrangement of the second row seat back, if the owner's manual is not properly followed when folding the second row seat back down, the center seat belt buckle may interfere with the right hand side seat belt buckle. As a result, the cover of the right hand side seat belt buckle may come off causing the buckle latch to become inoperable and unable to engage the seat belt tongue.

second row right side seat belt buckle cover has come off, and in some instances, may prevent the second row right side seat belt tongue from latching into the buckle when the internal buckle components have fallen off. This TSB instructs dealers to replace the second row right side seat belt buckle with a new part, which has been shortened by 14 mm to prevent the center seat belt buckle from covering the right side seat belt buckle, and install the countermeasure second row center seat belt buckle.

Customers may report the front seat belt fraying as a result of being caught under the seat reclining adjusting lever. This TSB instructs dealers how to replace the front seat belt and reclining adjusting lever (driver and/or passenger side) with a countermeasure part, to prevent fraying of the seat belt should it get caught under the lever, on affected vehicles.

STOPPER BUTTONS.

displaying on the Display Audio Unit while driving forward.

speakers in Mitsubishi vehicles equipped with original equipment audio components.

This bulletin provides instructions for downloading software and updating the Display Audio unit for customers who experience the rear view camera displaying on the Display Audio while driving, when the vehicle is not in Reverse.

It provides dealers instructions for resolving customer's report that Bluetooth pairing code given by the Hands Free Link system does not work for certain smartphone models, namely, Samsung Galaxy and Sony Xperia. For these smartphone models, the pairing code for Bluetooth connection must be set to a fixed code of ?0000.? This TSB instructs dealers how to register these smartphones using the pairing code ?0000.?

RECOGNITION TO COMPLETE BEFORE CONNECTION TO THE PHONE BEGINS, TO RECTIFY THE CONDITION WHERE THE HFM ATTEMPTS A BLUETOOTH CONNECTION WITH A MOBILE PHONE WHILE VOICE RECOGNITION IS BOOTING AT THE SAME TIME. IF THE BLUETOOTH CONNECTION COMPLETES BEFORE VOICE RECOGNITION COMPLETES, VOICE RECOGNITION CANNOT BE USED.

technician quiz for 2023.

technician quiz for 2023.

beginning with Model Year 2015.

gas springs outside the population of vehicles covered by Safety Recall No. SR-25-002.

Suspension section of the Service Manual.

(Service Manual Revision)

The bulletin updates the Front Suspension section of the affected Service Manuals to update the special service tool used in replacement of the Lower Arm Ball Joint Dust Cover.

This bulletin supersedes TSB-18-00-003, issued April, 2018, to add updated information for Carrying Capacity Reduced Label.

This bulletin updates the Propeller Shaft section of the affect Service Manuals, to correct the propeller shaft assembly removal procedure.

This bulletin updates the Propeller Shaft section of the affect Service Manuals, to correct the propeller shaft assembly removal procedure.

CERTAIN EXHAUST FASTENERS.

TSB-17-52A-003, to add Outlander PHEV and additional model years for Outlander and Outlander Sport, and to update parts and procedures to help resolve the power seat movement.

issued January 2019, to update symptoms in the Purpose section, and to remove Outlander PHEV from the Affected Vehicles.