2018 Mitsubishi Outlander Sport TSBs

It covers various topics and reviews the previous months publications.

It covers various topics and reviews the previous months publications.

residue.

capacity be affixed to vehicles when the total net weight of accessories is more than 1.5 percent of the vehicle's gross vehicle weight rating (GVWR) or 100 lbs.

It covers various topics and reviews the previous months publications.

It contains Pre-Delivery Inspection (PDI) procedures that dealers must perform when preparing subject vehicles for sale and delivery.

sent to dealers.

dealers.

Sport.

system for affected vehicles.

complains that the engine will not start while using the remote start system.

affected vehicles with improved countermeasure parts. Due to a change in the reclining motor, the new longer harness and connector are necessary.

affected vehicles with improved countermeasure parts. Due to a change in the reclining motor, the new longer harness and connector are necessary.

of absorbers unnecessarily when trace amounts of oil are noted to have adhered to the shock absorber.

to a customer concern of oil leaking.

communication error that may occur between the One-Touch Start System (OSS) and Engine Control Unit (ECU) or the Keyless Operating System (KOS) and Engine Control Unit (ECU).

Exhaust Manifold and instructs dealers to replace the Heat Protector Assembly with a new part.

found at the hose connection and to replace the old hose clamp with a countermeasure clamp and to replace the old water hose with a new water hose.

found at the hose connection and to replace the old hose clamp with a countermeasure clamp and to replace the old water hose with a new water hose.

and MY 2020-2018 Outlander Sports with 2.4L engines.

This Bulletin updates the Body section of the affected Service Manual to add a Caution to the installation service points of the TPMS valve (rubber snap-in type only).

The bulletin instructs dealers to confirm a list of specific Diagnostic Trouble Codes (DTCs) if vehicle experiences the following symptoms in cold weather: the check engine light illuminating with a limited vehicle speed (failsafe mode), or the engine does not restart after driving a short distance and stopping the engine for a few minutes. Once symptoms and DTCs are confirmed, dealers should replace the following relays with anti- freezing types: ETV, A/T (CVT), injector, and starter. This bulletin supersedes TSB-18-13-003, issued December, 2018, to add Eclipse Cross, applicable Canadian models, and countermeasure dates.

This Bulletin updates the Body section of the affected Service Manual to add a Caution to the installation service points of the TPMS valve (rubber snap-in type only).

The bulletin instructs dealers to confirm a list of specific Diagnostic Trouble Codes (DTCs) if vehicle experiences the following symptoms in cold weather: the check engine light illuminating with a limited vehicle speed (failsafe mode), or the engine does not restart after driving a short distance and stopping the engine for a few minutes. Once symptoms and DTCs are confirmed, dealers should replace the following relays with anti- freezing types: ETV, A/T (CVT), injector, and starter. This bulletin supersedes TSB-18-13-003, issued December, 2018, to add Eclipse Cross, applicable Canadian models, and countermeasure dates.

This bulletin instructs dealers to how to fix a condition of a metallic knocking sound coming from the rear brakes. Affected vehicles experience this condition when the brake is applied while driving at low speeds, or on driving on uneven roads. Dealers are instructed to replace the rear brake pad clips (upper and lower) with new parts on affected vehicles, and to apply grease between the brake pad and caliper support.

The bulletin instructs dealers to confirm a list of specific Diagnostic Trouble Codes (DTCs) if vehicle experiences the following symptoms in cold weather: the check engine light illuminating with a limited vehicle speed (failsafe mode), or the engine does not restart after driving a short distance and stopping the engine for a few minutes. Once symptoms and DTCs are confirmed, dealers should replace the following relays with anti- freezing types: ETV, A/T (CVT), injector, and starter.

The notice informs dealers that two questionnaire forms have been made available on Mitsubishi Dealer Link (MDL). The questionnaires are to identify how two frequent repairs (loss of Key Fob registration and tire/wheel imbalance) are happening. Mitsubishi Motors North America (MMNA) is requesting dealers to complete the appropriate questionnaire during the customer interview process.

The notice informs dealers of some reported coolant leaking from the transmission cooler line hoses at the CVT8 fluid cooler. The notice informs dealers that MMNA is looking to collect 3 complete sets of those CVT8 fluid coolers with the hoses and clamps undisturbed, in order for MMC to perform a duplication test to confirm the area of leakage.

exhibiting a shudder or surge condition possibly caused by poor reaction of the hydraulic pressure circuit.

exhibiting a shudder or surge condition possibly caused by poor reaction of the hydraulic pressure circuit.

affected vehicles with improved countermeasure parts.

Circuits may appear and dealers should check for damage to the drivers seat slide position sensor harness.

These changes are being made to correct the Left, Right, and Center Reflection Amplitudes within the table.

These changes are being made to correct the Left, Right, and Center Reflection Amplitudes within the table.

disassembly procedure of the front seat assembly with these additional parts: Seat heater harness, Front seat hinge protector, and Slide sensor harness.

This bulletin updates the Chassis Electrical section of the affected Service Manuals to update diagnostics for ETACS-ECU CAN timeout diagnostics with DTC U0141.

This bulletin updates the Supplemental Restraint System (SRS) section of the affected Service Manuals to update diagnostics for ETACS-ECU CAN timeout diagnostics with DTC U0141.

This bulletin updates the Body section of the affected Service Manuals to update diagnostics for ETACS-ECU CAN timeout with DTC U0141.

This notice informs dealers how to address stored DTCs (including P0657) in extremely cold ambient temperatures. Dealers can remedy this by replacing the throttle actuator control (TAC) relay.

Windshield Wiper in the Exterior portion of the affected Service Manuals.

a natural phenomenon, and water penetration caused by improper sealing or a defective/broken part.

windshield Removal and Installation procedure for vehicles equipped with Forward Collision Mitigation System (FCM), Lane Departure Warning System (LDW), and Automatic High Beam System (AHB).

Use the 2011 Body Repair Manual (MSSP-217B-2011) along with this TSB for complete body repair information on the 2018 Outlander Sport.

manuals.

This bulletin instructs dealers how to re-register vehicle keys for affected vehicles. Affected vehicles may experience a condition of the door(s) inability to be locked or unlocked using the Remote Keyless Entry (RKE) function. Dealers are instructed to re- register the ley using "Customer Key Programming" procedure in the Owner's Manual. This bulletin also provides Summary Table for Function Customization & Key Programming.

The bulletin updates the Body section of the affected Service Manuals to add the type of the hood latch mounting bolt and to correct the tightening torque for the hood.

onto each black wheel lug and lock after it has been properly torqued to specification. Dealers must immediately clean off all white paint marks using a wash cloth when taking receipt of the vehicles.

to install the oil seal within the Automatic Transaxle sections of the applicable Service Manuals.

on-vehicle service for belt & pulley assembly on certain CVT models.

(Service Manual Revision)

F1CJC/W1CJC (CVT-8) transmissions that may exhibit a shudder or surge condition possibly caused by a poor reaction of the hydraulic pressure circuit.

reaction of the hydraulic pressure circuit. With continued driving under these conditions, the CVT belt may slip repeatedly when accelerating, and abrasion powder may enter the hydraulic pressure circuit, causing a warning light to turn on. This TSB instructs dealers to diagnose and test drive vehicles exhibiting this condition. *This TSB may also apply to later model years with F1CJC/W1CJC (CVT-8) transmissions.

This bulletin updates the Rear Axle section of the affected Service Manuals, to correct the quantity of rear differential gear oil used.

technician quiz for 2023.

technician quiz for 2023.

beginning with Model Year 2015.

year MMNA vehicles.

It informs dealers that an addendum to the Owner?s Manual is being printed and inserted into each vehicle?s Quick Reference Guide.

It instructs dealers to complete and submit a Product Quality Report if they encounter any vehicle issues.

several issues.

when customers report a condition in vehicles equipped with a front wheel arch molding displays a gap between the front wheel arch molding and the fender.

speakers in Mitsubishi vehicles equipped with original equipment audio components.

This bulletin provides instructions for replacing the Display Audio 2 systems exhibiting one or more of the following conditions in cold temperatures: 1) No sound from the audio unit; 2) Audio unit will not switch from radio mode; 3) Audio unit receives an AM/FM signal, but not HD.

TIN-17-54-002 (unresponsive audio system buttons after making a phone call using an iPhone with iOS 11.0 or 11.0.1 and Apple CarPlay?) have now been resolved with iOS 11.1, released by Apple on November 1, 2017.

equipped with Display Audio with Smartphone Link and connected to iPhones that have updated to the recently-released iOS 11.0 or 11.0.1. Vehicles equipped with Display Audio with Smartphone Link and connected to iPhones with iOS 11.0 or 11.0.1, after making a phone call, can lose certain audio system functions.

Required Condition & Pre-Approval Center (PRC) for a vehicle pulling/drifting and/or with steering wheel off-center concerns.

alignment check and adjustment on an affected vehicle with a customer concern of pulling/drifting and/or steering wheel off-center concerns.

a wheel alignment check and adjustment on an affected vehicle with a customer concern of pulling/drifting and/or steering wheel off-center concerns.

photographs when performing a wheel alignment check and adjustment on an affected vehicle with a customer concern of pulling/drifting and/or steering wheel off-center concerns (while under warranty). This Notice supersedes TIN-17-37-001 released in July, 2017, to expand affected models and model years.

tongue not staying in place or that slides down to the floor, always default to searching for applicable TSBs, Tech Talk articles, and TINs first.

Supplemental Restraint System (SRS) section of the affected Service Manuals, to correct the front pillar trim assembly installation procedure.

This bulletin updates the Supplemental Restraint System (SRS) section of the affected Service Manuals, to correct minor errors in the diagnosis for DTC B1631.

Customers may report the front seat belt fraying as a result of being caught under the seat reclining adjusting lever. This TSB instructs dealers how to replace the front seat belt and reclining adjusting lever (driver and/or passenger side) with a countermeasure part, to prevent fraying of the seat belt should it get caught under the lever, on affected vehicles.

and Canada models.

affected Service Manuals, to add model codes XTJHL2M & XTJHZL2M for U.S. and XTFHZL3M for Canada vehicles.

This bulletin supersedes TSB-18-00-003, issued April, 2018, to add updated information for Carrying Capacity Reduced Label.

TSB-17-52A-003, to add Outlander PHEV and additional model years for Outlander and Outlander Sport, and to update parts and procedures to help resolve the power seat movement.

issued January 2019, to update symptoms in the Purpose section, and to remove Outlander PHEV from the Affected Vehicles.

It informs dealers of important new model service information and features for the 2018 Outlander PHEV.

the Service Brakes portion of the affected Service Manuals.

when customers report a condition where an abnormal rubbing noise is heard from the Seat Back when a driver and/or passenger is seated in the front seat(s).

rear end portion of the seat cushion by a passenger, the cushion may sink down and rub against the edges of the metal seat frame. This in turn may cause the damaged urethane material to turn to powder and fall on the floor carpet. This TSB provides a repair procedure to replace the damaged seat cushion pad, and apply tape on the frame to help prevent future damage.

this bulletin instructs dealers to use a software update that is now available, for the Smartphone Link Display Audio built by JVC Kenwood. The update resolves several issues, including: audio-related concerns, language translation error on the display in French, MPG (miles per gallon) displayed on screen instead of "fuel consumption," and EV charge cost history is occasionally erased when power switch is turned On or Off. This bulletin supersedes TSB-18-54-004, issued June, 2018 to add additional affected vehicles and to restate the importance of updating each vehicle with the correct vehicle specific software file.

SEVERAL OF THE EXHAUST PIPE HEAT SHIELD COMPONENTS ARE NOW AVAILALBE AS SERVICE PARTS. WHEN REPAIRING A VEHICLE FOR A NOISE DUE TO A LOOSE HEAT SHIELD, DO NOT REPLACE THE CENTER EXHAUST PIPE WITH CATALYTIC CONVERTOR IF THE HEAT SHIELD CAN BE SERVICED SEPARATELY.

(Service Manual Revision)

2018 Outlander Sport.