2013 Mitsubishi Lancer TSBs

It covers various topics and reviews the previous months publications.

residue.

capacity be affixed to vehicles when the total net weight of accessories is more than 1.5 percent of the vehicle's gross vehicle weight rating (GVWR) or 100 lbs.

has resumed for dealerships and customer facilities.

system for affected vehicles.

complains that the engine will not start while using the remote start system.

quantity of mounting bolts for vehicles equipped with 4B1 series engine. (Service Manual Revision)

to a customer concern of oil leaking.

repair and maintenance procedures.

misfire detected) stored in the ECM under the following conditions: 1. During cold engine start, rough or partial clutch operation (manual transmission only) may cause powertrain vibration similar to a misfire and cause false MIL illumination. 2. At high engine speeds with low load condition, a CVT downshift can cause powertrain vibration similar to a misfire and cause false MIL illumination. 3. At high engine speeds, improper Misfire Monitoring (P0300) threshold values may cause false MIL illumination. New software revises improper Misfire Monitoring (P0300) threshold values to false MIL illumination.

This TSB provides updated service manual information.

This TSB provides updated service manual information.

This Bulletin updates the Intake and Exhaust section of the affected Service Manuals, to correct the exhaust manifold and turbocharger assembly removal and installation procedure.

The bulletin instructs dealers to confirm a list of specific Diagnostic Trouble Codes (DTCs) if vehicle experiences the following symptoms in cold weather: the check engine light illuminating with a limited vehicle speed (failsafe mode), or the engine does not restart after driving a short distance and stopping the engine for a few minutes. Once symptoms and DTCs are confirmed, dealers should replace the following relays with anti- freezing types: ETV, A/T (CVT), injector, and starter. This bulletin supersedes TSB-18-13-003, issued December, 2018, to add Eclipse Cross, applicable Canadian models, and countermeasure dates.

The bulletin instructs dealers to confirm a list of specific Diagnostic Trouble Codes (DTCs) if vehicle experiences the following symptoms in cold weather: the check engine light illuminating with a limited vehicle speed (failsafe mode), or the engine does not restart after driving a short distance and stopping the engine for a few minutes. Once symptoms and DTCs are confirmed, dealers should replace the following relays with anti- freezing types: ETV, A/T (CVT), injector, and starter. This bulletin supersedes TSB-18-13-003, issued December, 2018, to add Eclipse Cross, applicable Canadian models, and countermeasure dates.

The bulletin updates the Engine Electrical section of the affected Service Manuals to correct the tightening torque for the generator assembly removal and installation.

The bulletin updates the Engine section of the affected Service Manuals to correct the tightening torque for the Fastener Tightening Specifications and the oil pump chain's removal and installation.

The bulletin instructs dealers to confirm a list of specific Diagnostic Trouble Codes (DTCs) if vehicle experiences the following symptoms in cold weather: the check engine light illuminating with a limited vehicle speed (failsafe mode), or the engine does not restart after driving a short distance and stopping the engine for a few minutes. Once symptoms and DTCs are confirmed, dealers should replace the following relays with anti- freezing types: ETV, A/T (CVT), injector, and starter.

connection when certain devices are connected to WiFi.

This bulletin provides dealers with a basic description of the hands-free systems used in Mitsubishi built vehicles. The bulletin covers components and operation, system layouts showing the differences in Japan built and U.S. built vehicles, diagnostic flow charts, a list of commonly used acronyms and terms, and part numbers. The bulletin also provides a comprehensive Hands-free/FUSE Information Sheet to guide the service writer in getting complete and accurate details from the customer. With this information, dealer personnel can answer questions and conduct an efficient diagnosis to resolve customer concerns as quickly as possible.

This bulletin provides dealers with a basic description of the hands-free systems used in Mitsubishi built vehicles. The bulletin covers components and operation, system layouts showing the differences in Japan built and U.S. built vehicles, diagnostic flow charts, a list of commonly used acronyms and terms, and part numbers. The bulletin also provides a comprehensive Hands-free/FUSE Information Sheet to guide the service writer in getting complete and accurate details from the customer. With this information, dealer personnel can answer questions and conduct an efficient diagnosis to resolve customer concerns as quickly as possible.

This bulletin updates the Chassis Electrical section of the affected Service Manuals to update diagnostics for ETACS-ECU CAN timeout diagnostics with DTC U0141.

This bulletin updates the Supplemental Restraint System (SRS) section of the affected Service Manuals to update diagnostics for ETACS-ECU CAN timeout diagnostics with DTC U0141.

This bulletin updates the Body section of the affected Service Manuals to update diagnostics for ETACS-ECU CAN timeout with DTC U0141.

the service manuals of affected vehicles. This TSB provides updated caution statements.

This bulletin supersedes TSB-18-00-003, issued April, 2018, to add updated information for Carrying Capacity Reduced Label.

This bulletin updates the Propeller Shaft section of the affect Service Manuals, to correct the propeller shaft assembly removal procedure.

This bulletin updates the Propeller Shaft section of the affect Service Manuals, to correct the propeller shaft assembly removal procedure.

The bulletin updates the Interior section of the affected Service Manuals to correct the tightening torque for the floor console assembly.

to install the oil seal within the Automatic Transaxle sections of the applicable Service Manuals.

assembly removal and installation of the roll stopper bracket.

This bulletin updates the Rear Axle section of the affected Service Manuals, to correct the quantity of rear differential gear oil used.

The bulletin updates the Power Steering section of the affected Service Manuals to correct the tightening torque for the power steering gear box, power steering control unit (EPS-ECU), steering shaft, power steering oil pump assembly and the power steering hoses.

a natural phenomenon, and water penetration caused by improper sealing or a defective/broken part.

manuals.

This bulletin instructs dealers how to re-register vehicle keys for affected vehicles. Affected vehicles may experience a condition of the door(s) inability to be locked or unlocked using the Remote Keyless Entry (RKE) function. Dealers are instructed to re- register the ley using "Customer Key Programming" procedure in the Owner's Manual. This bulletin also provides Summary Table for Function Customization & Key Programming.

The bulletin updates the Exterior section of the affected Service Manuals to correct the tightening torque for the front bumper assembly and radiator grille, under cover and floor console assembly.

technician quiz for 2023.

technician quiz for 2023.

Dealers are asked to use self-tapping screws for mounting the front license plate. License plates should be installed in the locations indicated by dimples in the front fascia. Dealers should use locally sourced, non-corroding, M6 fasteners, 20mm to 25 mm long. Fasteners should be installed using hand tools only.

Dealers are asked to use self-tapping screws for mounting the front license plate. License plates should be installed in the locations indicated by dimples in the front fascia. Dealers should use locally sourced, non-corroding, M6 fasteners, 15mm to 25 mm long.

This bulletin updates the Rear Suspension section of the affected Service Manuals, to delete the requirement for an installation direction of the coil spring end of the shock absorber assembly.

This bulletin updates the Rear Suspension section of the affected Service Manuals, to delete the requirement for an installation direction of the coil spring end of the shock absorber assembly.

The bulletin updates the Steering section of the affected Service Manuals to update the lubricant sealant, special tools, and procedures used in replacement of the Tie Rod End Ball Joint Dust Cover, which are now serviceable parts, for vehicles with electric power steering.

The bulletin updates the Steering section of the affected Service Manuals to update the lubricant, sealant, special tools, and procedures used in replacement of the Tie Rod End Ball Joint Dust Cover, which are now serviceable parts, for vehicles with hydraulic power steering.

The bulletin updates the Front Suspension section of the affected Service Manuals to correct the starting torque of the Lower Arm Ball Joint rotation.

The bulletin updates the Front Suspension section of the affected Service Manuals to update the special service tool used in replacement of the Lower Arm Ball Joint Dust Cover.

Remote Keyless Entry (RKE) integrated key case and FAST Key Transmitter case repair kits are now available. If the plastic parts of the key are broken or missing, but the key functions properly, use the appropriate service parts kit instead of replacing the entire key assembly. When replacing only the key case, it is not necessary to program immobilizer, RKE and OSS functions. For integrated RKE keys, once the electronic components are transferred to the new case, the key can be cut to the vehicle's key code.

This TSB provides updated caution statements.

speakers in Mitsubishi vehicles equipped with original equipment audio components.

The bulletin updates the Heater, Air Conditioning and Ventilation section of the affected Service Manuals to correct the tightening torque for the compressor assembly.