2010 Mitsubishi Lancer Sportback TSBs

residue.

capacity be affixed to vehicles when the total net weight of accessories is more than 1.5 percent of the vehicle's gross vehicle weight rating (GVWR) or 100 lbs.

Added Warranty information for instances where subframe may fail and cause additional damage to unrelated parts. This bulletin provides directions for inspection and repair of affected vehicles' Crossmembers.

Added Warranty information for instances where subframe may fail and cause additional damage to unrelated parts. This bulletin provides directions for inspection and repair of affected vehicles' Crossmembers.

they will be notified when parts become availble for repairs to begin. This notice also provided customers instruction on how to obtain repairs.

system for affected vehicles.

complains that the engine will not start while using the remote start system.

quantity of mounting bolts for vehicles equipped with 4B1 series engine. (Service Manual Revision)

- July 2020

This TSB provides updated service manual information.

Because of this, the shape and position of the timing chain oiling hole has changed.

The bulletin instructs dealers to confirm a list of specific Diagnostic Trouble Codes (DTCs) if vehicle experiences the following symptoms in cold weather: the check engine light illuminating with a limited vehicle speed (failsafe mode), or the engine does not restart after driving a short distance and stopping the engine for a few minutes. Once symptoms and DTCs are confirmed, dealers should replace the following relays with anti- freezing types: ETV, A/T (CVT), injector, and starter. This bulletin supersedes TSB-18-13-003, issued December, 2018, to add Eclipse Cross, applicable Canadian models, and countermeasure dates.

The bulletin instructs dealers to confirm a list of specific Diagnostic Trouble Codes (DTCs) if vehicle experiences the following symptoms in cold weather: the check engine light illuminating with a limited vehicle speed (failsafe mode), or the engine does not restart after driving a short distance and stopping the engine for a few minutes. Once symptoms and DTCs are confirmed, dealers should replace the following relays with anti- freezing types: ETV, A/T (CVT), injector, and starter. This bulletin supersedes TSB-18-13-003, issued December, 2018, to add Eclipse Cross, applicable Canadian models, and countermeasure dates.

The bulletin updates the Engine Electrical section of the affected Service Manuals to correct the tightening torque for the generator assembly removal and installation.

The bulletin updates the Engine section of the affected Service Manuals to correct the tightening torque for the Fastener Tightening Specifications and the oil pump chain's removal and installation.

The bulletin instructs dealers to confirm a list of specific Diagnostic Trouble Codes (DTCs) if vehicle experiences the following symptoms in cold weather: the check engine light illuminating with a limited vehicle speed (failsafe mode), or the engine does not restart after driving a short distance and stopping the engine for a few minutes. Once symptoms and DTCs are confirmed, dealers should replace the following relays with anti- freezing types: ETV, A/T (CVT), injector, and starter.

REPLACING THE RADIATOR AND/OR CONDENSER FAN MOTOR AND CONNECTORS, IN CASES WHERE AN INOPERATIVE FAN MAY BE CAUSED BY A MELTED CONNECTOR AT THE RADIATOR FAN MOTOR AND/OR CONDENSER FAN MOTOR.

THIS TSB PROVIDES INSTRUCTIONS FOR INSPECTION OF OIL LEAKAGE FROM THE FRONT OIL SEAL ON THE CRANKSHAFT, AND IF CONFIRMED, TO REPLACE THE FRONT OIL SEAL. DEALERS ARE TO ALSO INSPECT AND CLEAN THE RUBBER OF THE CRANKSHAFT PULLEY, AND REPLACE THE CRANKSHAFT PULLEY IF RUBBER IS DAMAGED.

PISTON SCUFF, DAYTIME RUNNING LIGHT OR INTAKE AND EXHAUST SYSTEM OR REPLACEMENT OF REAR AXLE ASSEMBLY. VARIOUS MODEL YEARS AND VEHICLES. *PE

An incorrect parameter in the judgment criteria may cause a false MIL (mis-detection of a fault when an abnormal condition is not present). This TSB provides dealers with a procedure to reprogram the ECM with new software to correct the condition.

This bulletin provides dealers with a basic description of the hands-free systems used in Mitsubishi built vehicles. The bulletin covers components and operation, system layouts showing the differences in Japan built and U.S. built vehicles, diagnostic flow charts, a list of commonly used acronyms and terms, and part numbers. The bulletin also provides a comprehensive Hands-free/FUSE Information Sheet to guide the service writer in getting complete and accurate details from the customer. With this information, dealer personnel can answer questions and conduct an efficient diagnosis to resolve customer concerns as quickly as possible.

This bulletin provides dealers with a basic description of the hands-free systems used in Mitsubishi built vehicles. The bulletin covers components and operation, system layouts showing the differences in Japan built and U.S. built vehicles, diagnostic flow charts, a list of commonly used acronyms and terms, and part numbers. The bulletin also provides a comprehensive Hands-free/FUSE Information Sheet to guide the service writer in getting complete and accurate details from the customer. With this information, dealer personnel can answer questions and conduct an efficient diagnosis to resolve customer concerns as quickly as possible.

This bulletin updates the Chassis Electrical section of the affected Service Manuals to update diagnostics for ETACS-ECU CAN timeout diagnostics with DTC U0141.

This bulletin updates the Supplemental Restraint System (SRS) section of the affected Service Manuals to update diagnostics for ETACS-ECU CAN timeout diagnostics with DTC U0141.

This bulletin updates the Body section of the affected Service Manuals to update diagnostics for ETACS-ECU CAN timeout with DTC U0141.

It provides dealers instructions for reprogramming the ETACS ECU with updated software to resolve the issue on certain vehicles experiencing dome light flickering when the vehicle's doors are opened or dome light is switched to "ON."

affected Service Manuals, to provide replacement instructions when installing the new ETACS ECU to replace the old ETACS ECU.

Front Impact Sensors investigation has concluded.

FRONT IMPACT SENSOR(S).

IMPACT SENSOR(S).

MODEL 2008-2012 LANCER, SPORTBACK, EVOLUTION, OUTLANDER. *PE

MODEL 2009-2014 OUTLANDER, LANCER, LANCER SPORTBACK, LANCER EVOLUTION. *PE

update regarding warranty information and entry of claims.

information.

update regarding warranty information and entry of claims.

information.

the service manuals of affected vehicles. This TSB provides updated caution statements.

This bulletin supersedes TSB-18-00-003, issued April, 2018, to add updated information for Carrying Capacity Reduced Label.

The bulletin updates the Interior section of the affected Service Manuals to correct the tightening torque for the floor console assembly.

The bulletin updates the Power Plant Mount section of the affected Service Manuals to correct the tightening torque for the crossmember removal service points.

a natural phenomenon, and water penetration caused by improper sealing or a defective/broken part.

(SR-20-003) for the Crossmember Corrosion.

(SR-20-003) for the Crossmember Corrosion.

the inside and outside surfaces of the front cross members used on certain vehicles, if exposed long term to snow melt water and anti-freezing agents, may corrode due to insufficient performance of the rust protection.

manuals.

This bulletin instructs dealers how to re-register vehicle keys for affected vehicles. Affected vehicles may experience a condition of the door(s) inability to be locked or unlocked using the Remote Keyless Entry (RKE) function. Dealers are instructed to re- register the ley using "Customer Key Programming" procedure in the Owner's Manual. This bulletin also provides Summary Table for Function Customization & Key Programming.

The bulletin updates the Exterior section of the affected Service Manuals to correct the tightening torque for the front bumper assembly and radiator grille, under cover and floor console assembly.

HAS BEEN AFFECTED FOR THE AWC HYDRAULIC UNIT FROM FAILURE DUE TO CORROSION. *LJ

technician quiz for 2023.

technician quiz for 2023.

and repair procedure; noting when a Crossmember replacement is required the anti-corrosive agent application is not required.

and repair procedure; noting when a Crossmember replacement is required the anti-corrosive agent application is not required.

assembly removal and installation of the roll stopper bracket.

TRANSMISSION COMPONENTS.

PRIMARY PULLEY SHAFT BEARINGS AND ONE SECONDARY PULLEY SHAFT BEARING, IF A CLICKING NOISE (ALONG WITH WHINING/HUMMING), DIRECTLY RELATED TO VEHICLE SPEED, IS HEARD IN THE PASSENGER COMPARTMENT.

TOOLS USED IN THE CVT HYDRAULIC PRESSURE TEST IN THE INDICATED SERVICE MANUALS.

parts availability delay of the Crossmember, customer vehicles requiring a replacement of the crossmember are unable to be completed at this time. Additionally, this notice informed dealers that an Interim Owner Notification Letter was mailed to affected owners on July 17th, 2020 to inform customers that MMNA is making every effort to establish a remedy and will contact them again by mail with a follow-up recall notice once parts are in stock and the final remedy is available.

parts availability delay of the Crossmember, customer vehicles requiring a replacement of the crossmember are unable to be completed at this time. Additionally, this notice informed dealers that an Interim Owner Notification Letter was mailed to affected owners on July 17th, 2020 to inform customers that MMNA is making every effort to establish a remedy and will contact them again by mail with a follow-up recall notice once parts are in stock and the final remedy is available.

Remote Keyless Entry (RKE) integrated key case and FAST Key Transmitter case repair kits are now available. If the plastic parts of the key are broken or missing, but the key functions properly, use the appropriate service parts kit instead of replacing the entire key assembly. When replacing only the key case, it is not necessary to program immobilizer, RKE and OSS functions. For integrated RKE keys, once the electronic components are transferred to the new case, the key can be cut to the vehicle's key code.

CERTAIN EXHAUST FASTENERS.

DUE TO PROLONGED EXPOSURE TO ANTI-FREEZING AGENTS, FRONT EXHAUST PIPE SEAL RING MAY CORRODE, IN COLD WEATHER STATES, TO CLEAR ICE AND SNOW FROM ROADWAYS. *PE

This TSB provides updated caution statements.

Customers may report the front seat belt fraying as a result of being caught under the seat reclining adjusting lever. This TSB instructs dealers how to replace the front seat belt and reclining adjusting lever (driver and/or passenger side) with a countermeasure part, to prevent fraying of the seat belt should it get caught under the lever, on affected vehicles.

OTHER MODELS' SERVICE MANUALS ARE UPDATED WITH INFORMATION FOR THE OUTER SEAT BELT ON THE FRONT PASSENGER'S SIDE SEAT TO CLARIFY THE FRONT SEAT BELT INSTALLATION AND REMOVAL PROCEDURE.

The bulletin updates the Front Suspension section of the affected Service Manuals to correct the starting torque of the Lower Arm Ball Joint rotation.

The bulletin updates the Front Suspension section of the affected Service Manuals to update the special service tool used in replacement of the Lower Arm Ball Joint Dust Cover.

speakers in Mitsubishi vehicles equipped with original equipment audio components.

The bulletin updates the Steering section of the affected Service Manuals to update the lubricant, sealant, special tools, and procedures used in replacement of the Tie Rod End Ball Joint Dust Cover, which are now serviceable parts, for vehicles with hydraulic power steering.

The bulletin updates the Heater, Air Conditioning and Ventilation section of the affected Service Manuals to correct the tightening torque for the compressor assembly.