2008 Mitsubishi Lancer Evolution TSBs

Bracket Bush of the Rear Axle Differential Carrier Assembly in the applicable Service Manual sections.

residue.

capacity be affixed to vehicles when the total net weight of accessories is more than 1.5 percent of the vehicle's gross vehicle weight rating (GVWR) or 100 lbs.

VEHICLES ELIGIBLE FOR TSB-14-22-005, AWC HYDRAULIC UNIT WARRANTY EXTENSION, HAS BEEN IDENTIFIED.

Lancer Evolution, 2009 - 2014 Lancer Ralliart, and 2009 - 2011 Lancer Sportback Ralliart built before September 25, 2013. This service campaign will be conducted in the U.S. and Puerto Rico. A Service Campaign Bulletin outlining the reprogramming procedure will be available December 19, 2013 on MEDIC and MDL. In certain affected vehicles, normal Electric Throttle Valve (ETV) fluctuations may cause actual torque to exceed Permitted Torque at low engine speeds. An improper Permitted Torque threshold may then cause false MIL illumination. A software update optimizes the Permitted Torque threshold value to minimize false MIL illumination.

rpm engine speed, due to improper intake air volume judgement parameter. DTCs P1235 (2008-2010 vehicles) or P0068 (2011-2014 vehicles) - Boost/Air Flow Sensor Plausibility may be stored in the ECM. This TSB provides field fix procedures to reprogram the ECM with new software to address false MIL illumination with boost/air flow plausibility monitor DTCs P1235 (2008-2010 models) or P0068 (2011-2014 models) stored in memory.

This TSB provides instructions for transmission overhaul that were not included in the service manual.

This TSB provides the necessary steps to complete diagnosis, replace the Mechatronic Assembly, and program the new electronic control unit.

ENGINE SYSTEM SERVICE REQUIRED on the MID and DTC P0012 may be recorded in ECM memory, but the MIL is not illuminated. An incorrect parameter in the judgment criteria may cause mis-detection of a fault even though the timing chain elongation rate remains within the specified allowance. This TSB provides a procedure to reprogram the ECM, confirm the oil control valve and timing chain are not at fault, and reset the timing chain learned value.

The bulletin instructs dealers to confirm a list of specific Diagnostic Trouble Codes (DTCs) if vehicle experiences the following symptoms in cold weather: the check engine light illuminating with a limited vehicle speed (failsafe mode), or the engine does not restart after driving a short distance and stopping the engine for a few minutes. Once symptoms and DTCs are confirmed, dealers should replace the following relays with anti- freezing types: ETV, A/T (CVT), injector, and starter. This bulletin supersedes TSB-18-13-003, issued December, 2018, to add Eclipse Cross, applicable Canadian models, and countermeasure dates.

The bulletin instructs dealers to confirm a list of specific Diagnostic Trouble Codes (DTCs) if vehicle experiences the following symptoms in cold weather: the check engine light illuminating with a limited vehicle speed (failsafe mode), or the engine does not restart after driving a short distance and stopping the engine for a few minutes. Once symptoms and DTCs are confirmed, dealers should replace the following relays with anti- freezing types: ETV, A/T (CVT), injector, and starter. This bulletin supersedes TSB-18-13-003, issued December, 2018, to add Eclipse Cross, applicable Canadian models, and countermeasure dates.

The bulletin updates the Engine Electrical section of the affected Service Manuals to correct the tightening torque for the generator assembly removal and installation.

The bulletin updates the Engine section of the affected Service Manuals to correct the tightening torque for the Fastener Tightening Specifications and the oil pump chain's removal and installation.

The bulletin instructs dealers to confirm a list of specific Diagnostic Trouble Codes (DTCs) if vehicle experiences the following symptoms in cold weather: the check engine light illuminating with a limited vehicle speed (failsafe mode), or the engine does not restart after driving a short distance and stopping the engine for a few minutes. Once symptoms and DTCs are confirmed, dealers should replace the following relays with anti- freezing types: ETV, A/T (CVT), injector, and starter.

THIS TSB PROVIDES INSTRUCTIONS FOR INSPECTION OF OIL LEAKAGE FROM THE FRONT OIL SEAL ON THE CRANKSHAFT, AND IF CONFIRMED, TO REPLACE THE FRONT OIL SEAL. DEALERS ARE TO ALSO INSPECT AND CLEAN THE RUBBER OF THE CRANKSHAFT PULLEY, AND REPLACE THE CRANKSHAFT PULLEY IF RUBBER IS DAMAGED.

PISTON SCUFF, DAYTIME RUNNING LIGHT OR INTAKE AND EXHAUST SYSTEM OR REPLACEMENT OF REAR AXLE ASSEMBLY. VARIOUS MODEL YEARS AND VEHICLES. *PE

(MIL) MAY OCCUR, IN COLD WEATHER, DURING TURBOCHARGER OPERATION BELOW 3,000 RPM ENGINE SPEED. MODEL 2008-2014 LANCER EVOLUTION. *PE

AN IMPROPER PERMITTED TORQUE THRESHOLD CAN CAUSE A FALSE MALFUNCTION INDICATOR LAMP (MIL) ILLUMINATION DUE TO ELECTRC THROTTLE VALVE (ETV) FLUCTUATIONS TO EXCEED PERMITTED TORQUE AT LOW ENGINE SPEEDS. THE ECM NEEDS REPROGRAMMING. MODEL 2008-2014 LANCER EVOLUTION, 2009-2014 LANCER RAE, 2009-2011 LANCER SPORTBACK. *PE

MODELS INCLUDE OUTLANDER MY2007-2014, OUTLANDER SPORT/RVR 2011-2014, LANCER 2008-2014, LANCER EVOLUTION 2008-2014, AND LANCER SPORTBACK 2009-2014. *JS UPDATED 12/16/13. *PE

THERE IS A PROGRAMMING ERROR. 2008-2011 LANCER EVOLUTION. *RM

IT IS A PROGRAMMING PROBLEM. 2008-2011 LANCER EVOLUTION. *RM

THE ECM NEEDS TO BE REPROGRAMMED. *RM

RELEASE CABLE CAN MAKE IT DIFFICULT TO RELEASE THE HOOD LATCH USING THE LATCH HANDLE. *PE

false MIL illumination with torque monitor P1241 (2008-2010 models) or P061A (2011-2014 models) stored in memory.

This bulletin provides dealers with a basic description of the hands-free systems used in Mitsubishi built vehicles. The bulletin covers components and operation, system layouts showing the differences in Japan built and U.S. built vehicles, diagnostic flow charts, a list of commonly used acronyms and terms, and part numbers. The bulletin also provides a comprehensive Hands-free/FUSE Information Sheet to guide the service writer in getting complete and accurate details from the customer. With this information, dealer personnel can answer questions and conduct an efficient diagnosis to resolve customer concerns as quickly as possible.

This bulletin provides dealers with a basic description of the hands-free systems used in Mitsubishi built vehicles. The bulletin covers components and operation, system layouts showing the differences in Japan built and U.S. built vehicles, diagnostic flow charts, a list of commonly used acronyms and terms, and part numbers. The bulletin also provides a comprehensive Hands-free/FUSE Information Sheet to guide the service writer in getting complete and accurate details from the customer. With this information, dealer personnel can answer questions and conduct an efficient diagnosis to resolve customer concerns as quickly as possible.

This bulletin updates the Chassis Electrical section of the affected Service Manuals to update diagnostics for ETACS-ECU CAN timeout diagnostics with DTC U0141.

This bulletin updates the Supplemental Restraint System (SRS) section of the affected Service Manuals to update diagnostics for ETACS-ECU CAN timeout diagnostics with DTC U0141.

This bulletin updates the Body section of the affected Service Manuals to update diagnostics for ETACS-ECU CAN timeout with DTC U0141.

It provides dealers instructions for reprogramming the ETACS ECU with updated software to resolve the issue on certain vehicles experiencing dome light flickering when the vehicle's doors are opened or dome light is switched to "ON."

affected Service Manuals, to provide replacement instructions when installing the new ETACS ECU to replace the old ETACS ECU.

FRONT IMPACT SENSOR(S).

IMPACT SENSOR(S).

MODEL 2008-2012 LANCER, SPORTBACK, EVOLUTION, OUTLANDER. *PE

MODEL 2009-2014 OUTLANDER, LANCER, LANCER SPORTBACK, LANCER EVOLUTION. *PE

SENSOR (SAS) IS NOT PART OF THE CLOCKSPRING. *PE

assembly removal and installation of the roll stopper bracket.

This TSB provides the necessary steps to complete diagnosis, clutch assembly replacement, and complete "Teach-in" procedures for the TCM. This TSB is used together with the Service Manual, TSB-16-22-003: "TC-SST Transmission and Mechatronic Assembly Diagnosis and Repair," and TSB-13-22-003: "TC-SST Diagnosis and Overhaul - Service Manual Revision," to provide procedures for the complete and accurate diagnosis and repair of the TC-SST transmission.

The bulletin updates the Power Steering section of the affected Service Manuals to correct the tightening torque for the power steering gear box, power steering control unit (EPS-ECU), steering shaft, power steering oil pump assembly and the power steering hoses.

The bulletin updates the Manual Transaxle section of the affected Service Manuals to correct the tightening torque for the transaxle assembly.

The bulletin updates the Clutch section of the affected Service Manuals to correct the tightening torque for the clutch fluid air bleeding nipple.

TO REVISE SPECIFIC STEPS FOR SELECTING REPROGRAMMING DATA IN THE PROGRAM NEW TRANSMISSION CONTROL MODULE (TCM) AND REPROGRAM 2008 LANCER EVOLUTION TCM WITH CORRECT SOFTWARE SECTIONS.

the service manuals of affected vehicles. This TSB provides updated caution statements.

This bulletin supercedes TSB-14-22-003, issued September, 2014, to update the labor operation code in Warranty Information.

This bulletin supersedes TSB-18-00-003, issued April, 2018, to add updated information for Carrying Capacity Reduced Label.

The bulletin updates the Interior section of the affected Service Manuals to correct the tightening torque for the floor console assembly.

The bulletin updates the Rear Axle section of the affected Service Manuals to correct the tightening torque for the differential carrier assembly.

a natural phenomenon, and water penetration caused by improper sealing or a defective/broken part.

manuals.

This bulletin instructs dealers how to re-register vehicle keys for affected vehicles. Affected vehicles may experience a condition of the door(s) inability to be locked or unlocked using the Remote Keyless Entry (RKE) function. Dealers are instructed to re- register the ley using "Customer Key Programming" procedure in the Owner's Manual. This bulletin also provides Summary Table for Function Customization & Key Programming.

The bulletin updates the Body section of the affected Service Manuals to correct the tightening torque for the loose panel.

HAS BEEN AFFECTED FOR THE AWC HYDRAULIC UNIT FROM FAILURE DUE TO CORROSION. *LJ

technician quiz for 2023.

technician quiz for 2023.

Remote Keyless Entry (RKE) integrated key case and FAST Key Transmitter case repair kits are now available. If the plastic parts of the key are broken or missing, but the key functions properly, use the appropriate service parts kit instead of replacing the entire key assembly. When replacing only the key case, it is not necessary to program immobilizer, RKE and OSS functions. For integrated RKE keys, once the electronic components are transferred to the new case, the key can be cut to the vehicle's key code.

CERTAIN EXHAUST FASTENERS.

THE VEHICLES HAVE A REDESIGNED FUEL RETURN PIPE WHICH HAS TWO ADDITIONAL BRACKETS. THIS BULLETIN PROVIDES UPDATED FUEL RETURN PIPE REMOVAL AND INSTALLATION SERVICE MANUAL PROCEDURES FOR THE AFFECTED VEHICLES, AND FOR REPLACEMENT FUEL RETURN PIPES INSTALLED SINCE 9/22/09. *PE

This TSB provides updated caution statements.

Customers may report the front seat belt fraying as a result of being caught under the seat reclining adjusting lever. This TSB instructs dealers how to replace the front seat belt and reclining adjusting lever (driver and/or passenger side) with a countermeasure part, to prevent fraying of the seat belt should it get caught under the lever, on affected vehicles.

OTHER MODELS' SERVICE MANUALS ARE UPDATED WITH INFORMATION FOR THE OUTER SEAT BELT ON THE FRONT PASSENGER'S SIDE SEAT TO CLARIFY THE FRONT SEAT BELT INSTALLATION AND REMOVAL PROCEDURE.

A SOFTWARE ERROR IS CAUSING A MIS-DETECTION OF A FAULT. 2008-2011 LANCER EVOLUTION. *RM

speakers in Mitsubishi vehicles equipped with original equipment audio components.

The bulletin updates the Steering section of the affected Service Manuals to update the lubricant, sealant, special tools, and procedures used in replacement of the Tie Rod End Ball Joint Dust Cover, which are now serviceable parts, for vehicles with hydraulic power steering.

INSTALLATION OF THE ABS AND ASC HYDRAULIC UNIT. ALSO INCUDED LANCER 2008-2014, LANCER SPORTBACK 2009-2014, OUTLANDER, AND SPORT/RVR 2011-2014. *JS UPDATED 12/16/13. *PE