2014 Mitsubishi Fuso FEC52 TSBs

residue.

capacity be affixed to vehicles when the total net weight of accessories is more than 1.5 percent of the vehicle's gross vehicle weight rating (GVWR) or 100 lbs.

100 use.

It covers various topics and reviews the previous months publications.

The injector code is an eight character, alphanumeric code found etched into the plastic at the top of the injector, as shown below. When this number is entered into the EEC using the FD Tool, DO NOT include the ?D? at the end of the injector code, enter only the fi rst seven characters. If the entire code is entered, an error will be displayed stating that the code is invalid.

FEC72, FEC92, FGB72 produced prior to August 1, 2013 DESCRIPTION: EEC Software flashing is required to complete the C10084 Oil & Hydrocarbon emissions recall. During EEC programming it critical that all installation instructions are followed, should the technician skip step 37 Select the item 028 TYPE OF DRIVE, the check engine warning lamp may illuminate during the final road test or after customer handover. Using the Fuso Diagnostic Tool (FD) scan for active/stored codes, the DTC1623-19 The CAN message from component instrument panel is faulty indicates re-flashing instructions were not followed. Please note that MFTA Warranty will not reimburse dealers to correct this condition resulting from omitting programming steps that trigger DTCs. Follow the steps attached to the printer friendly version to remedy the issue. Upon completion, the recovery steps be sure to recheck for codes and conduct a final road test to confirm effectiveness.

Mitsubishi Motors Corporation (MMC) about the effects of the Waterborne (WB) paint process on Mitsubishi vehicles.

FEC7T, FECZT, FEC9T DESCRIPTION: Engines replaced under warranty must be held for 60 days from claim payment, unless otherwise instructed to return the engine to MFTA or one of its suppliers. At the conclusion of the 60-day warranty retention period, in order to ensure that engines comply with current US EPA regulations, we ask that you follow the procedures outlined on the following pages to ensure that the engine block is damaged and rendered useless for repair or remanufacturing. The Environmental Protection Agency, in regulation 40 C.F.R. 1068.240(b)(3), requires manufacturers to destroy the old engine block (or confirm that it has been destroyed) so that prevention of the engine from re-entering commerce is guaranteed. After the engine is destroyed, take a photo of the damaged portion and the engine serial # and email them to MFTA with your Dealer Code, the VIN and the Engine Serial # in the header of the email. Send the email to mfta_service@daimler.com. IMPORTANT! Failure to properly scrap an engine assembly and notify MFTA may result in claim chargeback.

LUBRICANT AND SPRAY TO PREVENT BUILD UP OF RUST. MODELS INCLUDES: FEC52, FEC72, FEC92, FGB72. *LJ

AN ENGINE PROTECTION SYSTEM (EPS) THAT DETECTS LOW OIL PRESSURE WITH A BUZZER SOUND. *PE

technician quiz for 2023.

technician quiz for 2023.

MODEL 2012-2014 FE, FG CANTER. *PE

the transportation film.due to improper installation of the film.This TSB instructs the dealers of the repair procedure for removal of the stain.

DESCRIPTION: When MFTA Service requests that a PQR part to be returned, please follow the instructions below: Package all requested parts into one shipping container. Complete and attach the label on page two of this bulletin to the shipment. For light shipments (less than 150 lbs): Return all requested PQR parts less than 150 lbs via FedEx Ground Freight Collect using Account # 212016110. For heavy truck shipments (over 150 lbs): Contact your Product Support Manager for shipping instructions.

speakers in Mitsubishi vehicles equipped with original equipment audio components.

KITS ARE TO PROTECT INSTALLED TRANSMISSION AGAINST INTRUSION OF METAL CONTAMINATION. FILTER KITS TO BE INSTALLED AT TIME OF DUONIC REPLACEMENT. *CN

UPDATE ON PCV COLD WEATHER KIT WILL MATCH THE IMPROVED TECHNOLOGY AVAILABLE. *LJ