2011 Mercury Milan TSBs

versions of Motorcraft Premium ATF and can be used going forward. Mixing Motorcraft Premium ATF and MERCON V in the same transmission is acceptable. After 31-Jan-2024, Motorcraft Premium ATF will no longer be manufactured and will only be available until inventory depletes.

steering (EPAS), a remanufactured replacement steering gear (MU2Z-3V504-ARM) is available which is significantly less expensive than a new replacement gear. When conducting repairs that are customer pay, offer the customer a remanufactured gear when possible. This would include vehicles not included in field service action (FSA) 15N01 (built on or before 7-Sep-2010) or vehicles included in FSA 15N01 that have exceeded the 10 year/150,000 mile terms of the program.

reduced electric vehicle operation and increased gasoline engine operation around 10 years of vehicle age and beyond. This may be due to software in the battery energy control module (BECM) and the powertrain control module (PCM). To correct the condition, follow the Service Procedure to reprogram the BECM and PCM.

Edge & MKX Vehicles Driver & Passenger Airbag Module Quality Control Inspection: Ford Motor Company has determined that some vehicles claimed by dealers as repaired under Takata Airbag Safety Recalls 15S21, 17S42, 18S02, 19S01, and 21S12 may not have received the claimed repairs. The propellant in certain Takata airbag inflators can experience an alteration over time with exposure to certain climate conditions. A combination of time, high temperature fluctuations, and humidity contribute to the degradation of the propellant in the inflators. This degradation can cause the propellant to burn too quickly, creating high pressure inside the inflator, and in extreme cases causing the inflator to rupture in the event of a crash necessitating airbag deployment. A ruptured inflator can send inflator parts toward vehicle occupants resulting in serious injury or death. Additional information regarding Takata recalls can be found at www.nhtsa.gov and www.safercar.gov.

reduced electric vehicle operation and increased gasoline engine operation around 10 years of vehicle age and beyond. This may be due to software in the battery energy control module (BECM) and the powertrain control module (PCM). To correct the condition, follow the Service Procedure to reprogram the BECM and PCM.

Motorcraft Multi-Purpose Grease Spray XL-5-A even if grease was not applied from the factory. Also verify that the engine/transmission alignment dowel pins are present as well as the engine crankshaft dowel pin, if equipped, when installing the transmission. Failure to adequately lubricate the converter hub greatly increases the likelihood of the flexplate cracking in the future. Missing dowels may cause a misalignment issue also resulting in a premature failure. Refer to Workshop Manual (WSM), Section 307-01.

BRAKES AND SUSPENSION CATEGORY INDICATING SERVICE IS REQUIRED DUE TO A BRAKE SYSTEM WARNING LAMP BEING ILLUMINATED. IF THE PARK BRAKE WAS APPLIED WHEN THE VHR WAS GATHERING DATA FROM THE MAJOR VEHICLE SYSTEMS, THE BRAKES AND SUSPENSION MESSAGE WILL BE REPORTED AS THE VHR LOOKS FOR ANY WARNING LAMPS ILLUMINATED IN THE INSTRUMENT CLUSTER. RERUN THE VHR WITH THE ENGINE ON AND VEHICLE IN PARK, AND ENSURE THE PARK BRAKE IS DISENGAGED. IF THE SYNC VHR IS STILL REPORTING A CONCERN TO THE CUSTOMERS SYNC OWNERS ACCOUNT, REFER TO THE APPROPRIATE WORKSHOP MANUAL SECTION FOR DIAGNOSIS BY DTC OR SYMPTOM. STARTING IN 2015 NOT ALL SYNC EQUIPPED VEHICLES SUPPORT VHR, REFER TO THE OWNERS MANUAL FOR VHR OPERATION.

BRAKES AND SUSPENSION CATEGORY INDICATING SERVICE IS REQUIRED DUE TO A BRAKE SYSTEM WARNING LAMP BEING ILLUMINATED. IF THE PARK BRAKE WAS APPLIED WHEN THE VHR WAS GATHERING DATA FROM THE MAJOR VEHICLE SYSTEMS, THE BRAKES AND SUSPENSION MESSAGE WILL BE REPORTED AS THE VHR LOOKS FOR ANY WARNING LAMPS ILLUMINATED IN THE INSTRUMENT CLUSTER. RERUN THE VHR WITH THE ENGINE ON AND VEHICLE IN PARK, AND ENSURE THE PARK BRAKE IS DISENGAGED. IF THE SYNC VHR IS STILL REPORTING A CONCERN TO THE CUSTOMERS SYNC OWNERS ACCOUNT, REFER TO THE APPROPRIATE WORKSHOP MANUAL SECTION FOR DIAGNOSIS BY DTC OR SYMPTOM. STARTING IN 2015 NOT ALL SYNC EQUIPPED VEHICLES SUPPORT VHR, REFER TO THE OWNERS MANUAL FOR VHR OPERATION.

*LJ

CONNECTIVITY, CAUSING MALFUNCTION INDICATOR LAMP (MIL) OR WRENCH LIGHT TO BE ILLUMINATED. MODEL 2009-2012 FUSION, MILAN, ESCAPE, MARINER. *PE UPDATED 11/18/14. *PE

CONNECTIVITY AND MALFUNCTION INDICATOR LAMP (MIL) OR WRENCH LIGHT WILL ILLUMINATE. MODEL 2009-2013 FUSION, MILAN, ESCAPE, MARINER. *PE UPDATED 5/7/14. *PE

CONDITION OR POSSIBLE MISFIRE OR ROUGHNESS AT IDLING THROUGH 2000RPM OR A LACK OF ACCELERATION. MODELS 2009-12 ESCAPE, 2009-11 MARINER, MILAN, 2010-12 FUSION, 2011-14 MUSTANGS, 2013 C-MAX, FUSION, MKZ HYBRID. *PE

THAT IS CAUSING DIAGNOSTIC TROUBLE CODES (DTCS). *PE

THE MALFUNCTION LIGHT MAY BE ON WITH OR WITHOUT STORED TROUBLE CODES. *RM

THE ENGINE LIGHT MAY ALSO BE ON WITH A STORED TROUBLE CODE. PROGRAMMING ISSUE. 2010-2011 FUSION/MERUCRY MILAN/LINCOLN MKZ. *RM

THE PROBLEM MAY HAVE TO DO WITH CAMSHAFT TIMING. 2010-2011 FUSION/ESCAPE/MILAN/MARINER. *RM

systems may or may not come with a wallet card containing the master code. Unlike the integrated wired keypad, the accessory wireless keypad master code cannot be retrieved from the vehicle using a diagnostic scan tool or from the label printed on the body control module (BCM). The Factory Keyless Entry Code application within the diagnostic scan tool will not provide an applicable master code for the accessory wireless keypad. If the wallet card for an accessory keypad is not available, the "Wireless RF Keypad Diagnosis Guide" can be referenced and provides direction on how to retrieve the master code. This guide is located under the Workshop Manual tab > Accessories > Installation > Wireless RF Keypad Diagnosis Guide > PPT C > Step C2.<br /><br /> Note: The only available keypad for some vehicles from the assembly plant is the accessory wireless keyless entry keypad. The integrated wired keypad cannot be installed on vehicles not equipped from the factory with a wired keyless entry k

If the accessory keypad was factory installed, this card will be placed in the glove box and should be handed to the vehicles owner during initial delivery. Unlike the integrated (wired) factory keypad, the accessory keypad master code cannot be retrieved from the vehicle using a diagnostic scan tool. If the wallet card for an accessory keypad is lost, follow these steps to recover the code. Dealer Key Code access is granted through the Dealer Program Enrollment System (DPES); dealership management can authorize users. The authorized user must go to FMCDealer.com > Parts and Service > Parts Product Line Information > Keys/Entry Devices > Aftermarket Keyless Entry Keypad Code Access. Follow the instructions on the screen to obtain the master code for the accessory keypad.

The master code for the Accessory (Wireless) Keyless Entry Keypad can be retrieved from FMCDealer - Parts and Service - Parts Product Line Information - Keys/Entry Devices - Aftermarket Keyless Entry Keypad Code Access. Access to this site is granted through Dealer Program Enrollment System (DPES) and Dealer Principal, General Manager or Parts and Service Director can authorize users. Once authorized the retrieval process for master code can be obtained. The master code for the Accessory Keyless Entry Keypad cannot be retrieved from the body control module(BCM) with a diagnostic tool.

The master code for the Accessory (Wireless) Keyless Entry Keypad can be retrieved from FMCDealer - Parts and Service - Parts Product Line Information - Keys/Entry Devices - Aftermarket Keyless Entry Keypad Code Access. Access to this site is granted through Dealer Program Enrollment System (DPES) and Dealer Principal, General Manager or Parts and Service Director can authorize users. Once authorized the retrieval process for master code can be obtained. The master code for the Accessory Keyless Entry Keypad cannot be retrieved from the body control module(BCM) with a diagnostic tool.

*PE

2007-2010 Edge & MKX Vehicles Driver & Passenger Airbag Module Quality Control Inspection REASON FOR THIS SUPPLEMENT Updated Ranger Technical Information to include images of a pass and fail airbag inflator inspection for 2007-2011 model years.

The ETC_ACT and ETC_DSD PIDs should not used to diagnose possible ETB concerns. The IDS has a limited refresh rate when reading these PIDs and cannot display quickly enough to validate a concern. The PCM automatically monitors these inputs more accurately and will set diagnostic trouble codes (DTCs) when appropriate. Using these PIDs for diagnostics will lead to inaccurate results and improper ETB replacements. If a concern is intermittent and no DTCs are present, refer to historical DTCs and the PC/ED, Section 3 No DTCs Present Index chart for further information.

INDICATOR LAMP (MIL) ILLUMINATED IN PRESENT OF BATTERY ENERGY CONTROL MODULE (BECM) DTC P0A7E AND BECM NEEDS REPLACED, AND REPROGRAM. MODEL 2010-12 FUSION, MILAN, MKZ. *PE

DIAGNOSTIC TROUBLE CODES (DTCS) P2111, P2112 MAY OR MAY NOT BE STORED IN POWERTRAIN CONTROL MODULE (PCM). MODELS 2009-12 ESCAPE, MARINER, FUSION, MILAN. *PE

Escape, 2009-2011 Mariner, 2010-2014 Fusion, 2010-2011 Milan, 2012-2014 Edge/Explorer, and 2013-2014 Taurus/MKT/MKZ vehicles built on or before 10/14/2013 and equipped with a 6F35 automatic transmission may exhibit a fluid leak from the left hand (LH) transmission halfshaft seal due to wear on the transmission case bushing.

TRANSMISSION AND A SERVICE KIT IS AVAILABLE NOW, FOR REPAIR. MODEL 2009-2012 ESCAPE, MARINER, FUSION, MILAN. *PE

MODEL 2009-2012 ESCAPE, 2009-2011 MARINER, 2010-2012 FUSION, 2010-2011 MILAN. *PE

(MIL) WITH DIAGNOSTIC TROUBLE CODES (DTCS) P0030 AND/OR P0130. FOLLOW THE SERVICE PROCEDURE STEPS TO CORRECT THE CONDITION.

10 YEARS OR 150,000 MILES WARRANTY. *LJ

*LJ

DRIVE UNITS (RDU) AND FLUID, ON OCCASION, WOULD BURP OUT. *PE

This is caused by hydrofluoric acid which is used in some car wash solutions as a cleaning agent. Hydrofluoric acid can attack the glass and cause visual distortion and/or discoloration on the outer surface which cannot be removed by further cleaning. If this type of distortion is found, inspect the area of the glass that is covered by the cowl and/or molding. The portion of glass that is covered by the cowl or molding will not be affected by the acid. Hydrofluoric acid damage is not a defect in material or workmanship and is not a warrantable condition.

PLEASE USE AT YOUR DISCRETION. VARIOUS 2010-2015 VEHICLES MAY EXPERIENCE A TURBULENCE NOISE, SIMILAR TO AN HELICOPTER NOISE, AT HIGHWAY SPEEDS WHEN THE REAR DOOR WINDOW(S) OR SUNROOF ARE OPEN. *TA

EXTERIOR DOOR HANDLE MAY STICK WHEN OPENING OR WILL NOT BE FLUSH WHEN CLOSED. *RM

original SYNC/Navigation parts to provide additional features is not recommended nor supported on any Ford, Mercury or Lincoln vehicle. Only approved Genuine Ford accessories or originally installed systems are supported and certified to function correctly with other vehicle systems. If you suspect a system has been modified, the following resources can be used to verify original equipment: Monroney Label (Window Sticker), Professional Technician Society (PTS) OASIS tab  select SYNC or HVBOM. For Genuine Ford accessories use: PTS Workshop Tab  select Dealer Installed Accessory or Accessory Installation.

ORIGINAL SYNC/NAVIGATION PARTS TO PROVIDE ADDITIONAL FEATURES IS NOT RECOMMENDED NOR SUPPORTED ON ANY FORD, MERCURY OR LINCOLN VEHICLE. ONLY APPROVED GENUINE FORD ACCESSORIES OR ORIGINALLY INSTALLED SYSTEMS ARE SUPPORTED AND CERTIFIED TO FUNCTION CORRECTLY WITH OTHER VEHICLE SYSTEMS. IF YOU SUSPECT A SYSTEM HAS BEEN MODIFIED, THE FOLLOWING RESOURCES CAN BE USED TO VERIFY ORIGINAL EQUIPMENT: MONRONEY LABEL (WINDOW STICKER), PROFESSIONAL TECHNICIAN SOCIETY (PTS) OASIS TAB  SELECT SYNC OR HVBOM. FOR GENUINE FORD ACCESSORIES USE: PTS WORKSHOP TAB  SELECT DEALER INSTALLED ACCESSORY OR ACCESSORY INSTALLATION.

THE WORKSHOP MANUAL (WSM) DIAGNOSTIC PROCEDURES HAVE BEEN UPDATED IN SECTION 211-02. WHEN DIAGNOSING AND REPAIRING EPAS STEERING NOISES USE THE UPDATED PROCEDURES.

2010-2011 FUSION/MILAN/MKZ. THIS COULD BE NORMAL. *RM

As of an update released on 1/15/2018 Spotify will no longer be supporting their AppLink integration. No repair attempts should be attempted to correct this concern.

AND/OR HAVE A DIAGNOSTIC TROUBLE CODE, NO START CONDITION. *PE