1997 Mazda RX-7 TSBs
13 Technical Service Bulletins across 7 categories
Categories
Electrical
3 bulletinsMAINTENANCE FREE BATTERY - DIAGNOSTIC AND CHARGING PROCEDURE.
Read full bulletin
*TW
This service bulletin provides testing and charging procedures in order to promote proper battery maintenance, to...
Read full bulletin
deliver new vehicles with fully charged batteries, and to reduce unnecessary battery replacement cost. For new vehicles in stock at the dealer, inspect and maintain the battery periodically according to the repair procedure.
The Mazda DCA-8000PM is required for all warranty battery testing.
Read full bulletin
If the Mazda DCA-8000PM is not used, incorrect battery testing may result in unnecessary battery replacement. Use the following test procedures in this Service Bulletin to test Mazda vehicle batteries and to generate a Warranty Code.
Other
3 bulletinsSpeedometer replacement procedure
In accordance with Federal regulations, follow the procedure listed below when replacing a speedometer
In support of the new MRT distribution, Mazda will ship to dealers a new Dual Purpose Diagnostic Leak Detector beginning March, 2019.
Read full bulletin
Training videos will be posted to MGSS shortly and Workshop Manual procedures will be revised gradually.
Body & Paint
2 bulletinsPRE-PAINTING PREPARATIONS FOR FRONT AND REAR BUMPERS.
Read full bulletin
*YC
Paint damage Mazda pocket paint guide
Engine
2 bulletinsWIPER MOTOR INOPERATIVE - CIRCUIT BREAKER ACTIVATION.
Read full bulletin
*TW
In accordance with Federal regulations, follow the procedure listed below when replacing a speedometer.
Read full bulletin
NOTE: Tampering with a motor vehicle odometer is strictly prohibited by Federal, and State laws. It is the dealers responsibility to comply with Federal, State, and local laws concerning odometer and related documentation requirements when providing a repair or replacement. Mazda vehicles are manufactured with tamper-proof speedometers. When a speedometer is replaced, the new speedometer will read zero (0) miles. This procedure is extremely important to accurately represent actual vehicle mileage. Prior to speedometer removal, complete the information required on the Speedometer Replacement Label. Labels can only be ordered through Mazda eStore. In an effort to achieve a higher level of Customer Experience and retain the value of Mazdas vehicles, MNAO Warranty Operations is allowing all Mazda dealers to utilize a third party, SPECMO Enterprises, Inc., for Instrument Panel Cluster (IPC) odometer setting service. With the use of SPECMOs services, it is possible that the odometer will be set between 10 to 31 miles over the odometer mileage at the time of replacement for both warranty and customer pay repairs. Please make sure that the customer is aware that there may be a slight variance to the odometer, in which case the customer may have to accept the slightly higher mileage. Since odometer setting service is not part of the warranty repair, it is not warrantable nor required, but optional. However, Mazda Warranty policy provides after- warranty assistance (AWA) or DSA that can be utilized to cover this service expense.
Air Bags & Safety
1 bulletinPARTS REPLACEMENT AFTER AIRBAG DEPLOYMENT.
Read full bulletin
*TW
HVAC & Climate
1 bulletinUSE OF A/C TRACER DYE.
Read full bulletin
*TW
Pre-Delivery & Maintenance
1 bulletinThis service bulletin provides information regarding the proper use of the drivers floor mat to avoid any potential interference with the foot pedals.
Read full bulletin
The following are possible causes of floor mat interference, which can be avoided with proper usage.