Powered byNHTSA|EPA|Community Reports|Updated

1996 Mazda MPV TSBs

30 Technical Service Bulletins across 8 categories

Other

9 bulletins
603906

SOME VEHICLES MAY EXPERIENCE HLA NOISE.

Read full bulletin

*YC

603875

SUBJECT PERTAINING TO TACH NEEDLE WHICH IS STUCK ON WRONG SIDE OF STOPPER PIN.

Read full bulletin

*YC

600334

COMPLAINTS OF TACH NEEDLE STUCK ON WRONG SIDE OF STOPPER PIN.

Read full bulletin

*YC

600148

CONCERNS WITH HLA NOISE HEARD AFTER A COLD START.

Read full bulletin

*YC

52509

TACH NEEDLE STUCK ON WRONG SIDE OF STOPPER PIN.

Read full bulletin

*TW

52508

KEYLESS ENTRY TRANSMITTER INOPERATIVE.

Read full bulletin

*TW

52505

SLIPPAGE IN FORWARD AND REVERSE DUE TO LOW ATF LEVEL.

Read full bulletin

*TW

10213425

Speedometer replacement procedure

10009424

SPEEDOMETER REPLACEMENT PROCEDURE.

Read full bulletin

*TT

Engine

8 bulletins
621310

SOME VEHICLES MAY EXHIBIT A NO START, ROUGH IDLE AND / OR LACK OF POWER AFTER A 60,000 MILE TIMING BELT REPLACEMENT INTERVAL.

Read full bulletin

*TT

52492

WIPER MOTOR INOPERATIVE - CIRCUIT BREAKER ACTIVATION.

Read full bulletin

*TW

46704

CYLINDER HEAD GASKET MODIFICATION.

Read full bulletin

*SD

10170661

In accordance with Federal regulations, follow the procedure listed below when replacing a speedometer.

Read full bulletin

NOTE: Tampering with a motor vehicle odometer is strictly prohibited by Federal, and State laws. It is the dealers responsibility to comply with Federal, State, and local laws concerning odometer and related documentation requirements when providing a repair or replacement. Mazda vehicles are manufactured with tamper-proof speedometers. When a speedometer is replaced, the new speedometer will read zero (0) miles. This procedure is extremely important to accurately represent actual vehicle mileage. Prior to speedometer removal, complete the information required on the Speedometer Replacement Label. Labels can only be ordered through Mazda eStore. In an effort to achieve a higher level of Customer Experience and retain the value of Mazdas vehicles, MNAO Warranty Operations is allowing all Mazda dealers to utilize a third party, SPECMO Enterprises, Inc., for Instrument Panel Cluster (IPC) odometer setting service. With the use of SPECMOs services, it is possible that the odometer will be set between 10 to 31 miles over the odometer mileage at the time of replacement for both warranty and customer pay repairs. Please make sure that the customer is aware that there may be a slight variance to the odometer, in which case the customer may have to accept the slightly higher mileage. Since odometer setting service is not part of the warranty repair, it is not warrantable nor required, but optional. However, Mazda Warranty policy provides after- warranty assistance (AWA) or DSA that can be utilized to cover this service expense.

10153339

In accordance with Federal regulations, follow the procedure listed below when replacing a speedometer.

Read full bulletin

NOTE: Tampering with a motor vehicle odometer is strictly prohibited by Federal, and State laws. It is the dealer's responsibility to comply with Federal, State, and local laws concerning odometer and related documentation requirements when providing a repair or replacement. Mazda vehicles are manufactured with tamper-proof speedometers. When a speedometer is replaced, the new speedometer will read zero (0) miles. This procedure is extremely important to accurately represent actual vehicle mileage. Prior to speedometer removal, complete the information required on the "Speedometer Replacement Label". Labels can only be ordered through Mazda eStore. In an effort to achieve a higher level of Customer Experience and retain the value of Mazda's vehicles, MNAO Warranty Operations is allowing all Mazda dealers to utilize a third party, SPECMO Enterprises, Inc., for Instrument Panel Cluster (IPC) odometer setting service. With the use of SPECMO's services, it is possible that the odometer will be set between 10 to 31 miles over the odometer mileage at the time of replacement for both warranty and customer pay repairs. Please make sure that the customer is aware that there may be a slight variance to the odometer, in which case the customer may have to accept the slightly higher mileage. Since odometer setting service is not part of the warranty repair, it is not warrantable nor required, but optional. However, Mazda Warranty policy provides after-warranty assistance (AWA) or DSA that can be utilized to cover this service expense.

10148072

In accordance with Federal regulations, follow the procedure listed below when replacing a speedometer.

Read full bulletin

NOTE: Tampering with a motor vehicle odometer is strictly prohibited by Federal, and State laws. It is the dealer's responsibility to comply with Federal, State, and local laws concerning odometer and related documentation requirements when providing a repair or replacement. Mazda vehicles are manufactured with tamper-proof speedometers. When a speedometer is replaced, the new speedometer will read zero (0) miles. This procedure is extremely important to accurately represent actual vehicle mileage. Prior to speedometer removal, complete the information required on the "Speedometer Replacement Label". Labels can only be ordered through Mazda eStore. In an effort to achieve a higher level of Customer Experience and retain the value of Mazda's vehicles, MNAO Warranty Operations is allowing all Mazda dealers to utilize a third party, SPECMO Enterprises, Inc., for Instrument Panel Cluster (IPC) odometer setting service. With the use of SPECMO's services, it is possible that the odometer will be set between 10 to 31 miles over the odometer mileage at the time of replacement for both warranty and customer pay repairs. Please make sure that the customer is aware that there may be a slight variance to the odometer, in which case the customer may have to accept the slightly higher mileage. Since odometer setting service is not part of the warranty repair, it is not warrantable nor required, but optional. However, Mazda Warranty policy provides after- warranty assistance (AWA) or DSA that can be utilized to cover this service expense.

10144333

In accordance with Federal regulations, follow the procedure listed below when replacing a speedometer.

Read full bulletin

NOTE: Tampering with a motor vehicle odometer is strictly prohibited by Federal, and State laws. It is the dealer's responsibility to comply with Federal, State, and local laws concerning odometer and related documentation requirements when providing a repair or replacement. Mazda vehicles are manufactured with tamper-proof speedometers. When a speedometer is replaced, the new speedometer will read zero (0) miles. This procedure is extremely important to accurately represent actual vehicle mileage. Prior to speedometer removal, complete the information required on the "Speedometer Replacement Label". Labels can only be ordered through Mazda eStore. In an effort to achieve a higher level of Customer Experience and retain the value of Mazda's vehicles, MNAO Warranty Operations is allowing all Mazda dealers to utilize a third party, SPECMO Enterprises, Inc., for Instrument Panel Cluster (IPC) odometer setting service. With the use of SPECMO's services, it is possible that the odometer will be set between 10 to 31 miles over the odometer mileage at the time of replacement for both warranty and customer pay repairs. Please make sure that the customer is aware that there may be a slight variance to the odometer, in which case the customer may have to accept the slightly higher mileage. Since odometer setting service is not part of the warranty repair, it is not warrantable nor required, but optional. However, Mazda Warranty policy provides after-warranty assistance (AWA) or DSA that can be utilized to cover this service expense.

10118467

In accordance with Federal regulations, follow the procedure listed below when replacing a speedometer.

Read full bulletin

NOTE: Tampering with a motor vehicle odometer is strictly prohibited by Federal, and State laws. It is the dealer?s responsibility to comply with Federal, State, and local laws concerning odometerand related documentation requirements when providing a repair or replacement. Mazda vehicles are manufactured with tamper-proof speedometers. When a speedometer is replaced, the new speedometer will read zero (0) miles. This procedure is extremely important to accurately represent actual vehicle mileage. Prior to speedometer removal, complete the information required on the ?SpeedometerReplacement Label?.Labels can only be ordered through Mazda eStore. In an effort to achieve a higher level of Customer Experience and retain the value of Mazda?s vehicles, MNAO Warranty Operations is allowing all Mazda dealers to utilize a third party, SPECMO Enterprises, Inc., for Instrument Panel Cluster (IPC) odometer setting service.With the use of SPECMO?s services, a Mazda dealer can get the odometer setting updated to reflect the correct mileage at the time of replacement for both warranty and customer pay repairs, therefore resulting in a higher level of customer satisfaction. Since odometer setting service is not part of the warranty repair, it is not warrantable nor required, but optional. However, Mazda Warranty policy provides after- warranty assistance (AWA) or DSA that can be utilized to cover this service expense.

Body & Paint

3 bulletins
608126

SUBJECT REGARDING PAINT DAMAGE - IRON PARTICLES / INDUSTRIAL FALLOUT / ACID RAIN.

Read full bulletin

*TT

603914

SUBJECT ON WATER LEAKS FROM SLIDING SUNROOF.

Read full bulletin

*YC

10098367

IN ACCORDANCE WITH FEDERAL REGULATIONS, FOLLOW THE PROCEDURE LISTED BELOW WHEN REPLACING A SPEEDOMETER.NOTE:MAZDA...

Read full bulletin

VEHICLES ARE MANUFACTURED WITH TAMPER-PROOF SPEEDOMETERS.WHEN A SPEEDOMETER IS REPLACED, THE NEW SPEEDOMETER WILL READ ZERO (0) MILES.THIS PROCEDURE IS EXTREMELY IMPORTANT TO ACCURATELY REPRESENT ACTUAL VEHICLE MILEAGE.PRIOR TO SPEEDOMETER REMOVAL, COMPLETE THE INFORMATION REQUIRED ON THE SPEEDOMETER REPLACE-MENT LABEL. LABELS CAN ONLY BE ORDERED THROUGH MSTORE, NOT MDCS.

Air Bags & Safety

3 bulletins
603854

INFORMATION REGARDING SEAT BELT EXTENDERS.

Read full bulletin

*YC

52520

PARTS REPLACEMENT AFTER AIRBAG DEPLOYMENT.

Read full bulletin

*TW

10021000

NON GENUINE ACCESSORIES AFFECT AIR BAG OPERATION.

Read full bulletin

*KB

Electrical

3 bulletins
52503

MAINTENANCE FREE BATTERY - DIAGNOSTIC AND CHARGING PROCEDURE.

Read full bulletin

*TW

52487

REPLACEMENT CONNECTORS FOR ECAT SOLENOID HARNESS.

Read full bulletin

*TW

10009427

BATTERY TEST PROCEDURE REQUIREMENTS.

Read full bulletin

*TT

Pre-Delivery & Maintenance

2 bulletins
609949

SUBJECT REGARDING 60,000 MILE SERVICE, INSPECTION AND / OR REPLACEMENT OF THE TENSIONER PULLEY.

Read full bulletin

*TT

52499

SPORTS APPEARANCE PACKAGE SERVICE INSTALLATION INSTRUCTIONS.

Read full bulletin

*TW

Steering

1 bulletin
603891

CONDITIONS WITH STEERING WHEEL SLIGHTLY OFF CENTER.

Read full bulletin

*YC

HVAC & Climate

1 bulletin
52497

USE OF A/C TRACER DYE.

Read full bulletin

*TW