2002 Mazda Mazda6 TSBs
15 Technical Service Bulletins across 6 categories
Body & Paint
5 bulletinsSome vehicles may experience exterior trim heat damage when parked near a glass building or Low-E windows.
Read full bulletin
This may be caused by the sun's reflection.
Some vehicles may experience exterior trim heat damage when parked near a glass building or Low-E windows.
Read full bulletin
This may be caused by the sun's reflection.
Paint damage Mazda pocket paint guide
Some vehicles may exhibit the inner cloth (A) falling down at the rear end causing a poor appearance and obstructing the...
Read full bulletin
view of the back window.
When encountering a vehicle with paint damage, refer to the "Mazda Paint Warranty Guide" to determine cause, prevention,...
Read full bulletin
remedy, and warranty coverage (if applicable).
Lighting
3 bulletinsThis Service Alert supersedes the previously issued SA listed below: The changes are noted in Red.
Read full bulletin
SA-011/24 02/12/24, 06/06/24, 07/29/24 DESCRIPTION Mazda has developed factory recommended scheduled maintenance services that support all major vehicle systems. Mazda recommends dealers follow the scheduled maintenance tables as cited in the vehicle-specific workshop manual or owner's manual. Services performed outside of Mazda's factory scheduled maintenance are not recommended. These services are unnecessary and create unneeded expenses for your customers. SCHEDULED MAINTENANCE Refer to the applicable Workshop Manual or Owner's Manual for vehicle -specific manufacturer scheduled maintenance. Workshop Manual - Refer to section 00-00 SCHEDULED MAINTENANCE. Owner's Manual - Refer to section 8 Maintenance and Care. b. Note: Please refer to the information below outlining the services not included in Mazda's Factory Scheduled Maintenance: IMPORTANT: Recommending fluid flushes when not necessary can lead to customer confusion and dissatisfaction. Fluid flushing for preventive maintenance purposes is strongly discouraged, unless otherwise specified in a published procedure (Owners Manual, Workshop Manual, Technical Service Bulletin, etc.).
Mazda has developed factory recommended scheduled maintenance services that support all major vehicle systems.
Read full bulletin
Mazda recommends dealers follow the scheduled maintenance tables as cited in the vehicle-specific workshop manual or owner's manual. Services performed outside of Mazda's factory scheduled maintenance are not recommended. These services are unnecessary and create unneeded expenses for your customers.
Mazda has developed factory recommended scheduled maintenance services that support all major vehicle systems.
Read full bulletin
Mazda recommends dealers follow the scheduled maintenance tables as cited in the vehicle specific workshop manual or owner's manual. Services performed outside of Mazda's factory scheduled maintenance are not recommended. These services are unnecessary and create unneeded expenses for your customers.
Pre-Delivery & Maintenance
2 bulletinsProduct Quality Information (PQI) DESCRIPTION Service Information MT-041/12 is no longer valid.
Read full bulletin
It has been unpublished and superseded by the Field Quality Information Report (FQIR) reporting system.
This service bulletin provides information regarding the proper use of the drivers floor mat to avoid any potential interference with the foot pedals.
Read full bulletin
The following are possible causes of floor mat interference, which can be avoided with proper usage.
Other
2 bulletinsSpeedometer replacement procedure
In accordance with Federal regulations, follow the procedure listed below when replacing a speedometer
Electrical
2 bulletinsThis service bulletin provides testing and charging procedures in order to promote proper battery maintenance, to...
Read full bulletin
deliver new vehicles with fully charged batteries, and to reduce unnecessary battery replacement cost. For new vehicles in stock at the dealer, inspect and maintain the battery periodically according to the repair procedure.
The Mazda DCA-8000PM is required for all warranty battery testing.
Read full bulletin
If the Mazda DCA-8000PM is not used, incorrect battery testing may result in unnecessary battery replacement. Use the following test procedures in this Service Bulletin to test Mazda vehicle batteries and to generate a Warranty Code.
Engine
1 bulletinIn accordance with Federal regulations, follow the procedure listed below when replacing a speedometer.
Read full bulletin
NOTE: Tampering with a motor vehicle odometer is strictly prohibited by Federal, and State laws. It is the dealers responsibility to comply with Federal, State, and local laws concerning odometer and related documentation requirements when providing a repair or replacement. Mazda vehicles are manufactured with tamper-proof speedometers. When a speedometer is replaced, the new speedometer will read zero (0) miles. This procedure is extremely important to accurately represent actual vehicle mileage. Prior to speedometer removal, complete the information required on the Speedometer Replacement Label. Labels can only be ordered through Mazda eStore. In an effort to achieve a higher level of Customer Experience and retain the value of Mazdas vehicles, MNAO Warranty Operations is allowing all Mazda dealers to utilize a third party, SPECMO Enterprises, Inc., for Instrument Panel Cluster (IPC) odometer setting service. With the use of SPECMOs services, it is possible that the odometer will be set between 10 to 31 miles over the odometer mileage at the time of replacement for both warranty and customer pay repairs. Please make sure that the customer is aware that there may be a slight variance to the odometer, in which case the customer may have to accept the slightly higher mileage. Since odometer setting service is not part of the warranty repair, it is not warrantable nor required, but optional. However, Mazda Warranty policy provides after- warranty assistance (AWA) or DSA that can be utilized to cover this service expense.