Powered byNHTSA|EPA|Community Reports|Updated

1997 Mazda 323 TSBs

9 Technical Service Bulletins across 8 categories

Engine

2 bulletins
52492

WIPER MOTOR INOPERATIVE - CIRCUIT BREAKER ACTIVATION.

Read full bulletin

*TW

10170661

In accordance with Federal regulations, follow the procedure listed below when replacing a speedometer.

Read full bulletin

NOTE: Tampering with a motor vehicle odometer is strictly prohibited by Federal, and State laws. It is the dealers responsibility to comply with Federal, State, and local laws concerning odometer and related documentation requirements when providing a repair or replacement. Mazda vehicles are manufactured with tamper-proof speedometers. When a speedometer is replaced, the new speedometer will read zero (0) miles. This procedure is extremely important to accurately represent actual vehicle mileage. Prior to speedometer removal, complete the information required on the Speedometer Replacement Label. Labels can only be ordered through Mazda eStore. In an effort to achieve a higher level of Customer Experience and retain the value of Mazdas vehicles, MNAO Warranty Operations is allowing all Mazda dealers to utilize a third party, SPECMO Enterprises, Inc., for Instrument Panel Cluster (IPC) odometer setting service. With the use of SPECMOs services, it is possible that the odometer will be set between 10 to 31 miles over the odometer mileage at the time of replacement for both warranty and customer pay repairs. Please make sure that the customer is aware that there may be a slight variance to the odometer, in which case the customer may have to accept the slightly higher mileage. Since odometer setting service is not part of the warranty repair, it is not warrantable nor required, but optional. However, Mazda Warranty policy provides after- warranty assistance (AWA) or DSA that can be utilized to cover this service expense.

Steering

1 bulletin
603891

CONDITIONS WITH STEERING WHEEL SLIGHTLY OFF CENTER.

Read full bulletin

*YC

Body & Paint

1 bulletin
54319

PRE-PAINTING PREPARATIONS FOR FRONT AND REAR BUMPERS.

Read full bulletin

*YC

Air Bags & Safety

1 bulletin
52520

PARTS REPLACEMENT AFTER AIRBAG DEPLOYMENT.

Read full bulletin

*TW

Electrical

1 bulletin
52503

MAINTENANCE FREE BATTERY - DIAGNOSTIC AND CHARGING PROCEDURE.

Read full bulletin

*TW

HVAC & Climate

1 bulletin
52497

USE OF A/C TRACER DYE.

Read full bulletin

*TW

Pre-Delivery & Maintenance

1 bulletin
10200527

This service bulletin provides information regarding the proper use of the drivers floor mat to avoid any potential interference with the foot pedals.

Read full bulletin

The following are possible causes of floor mat interference, which can be avoided with proper usage.

Other

1 bulletin
10186703

In accordance with Federal regulations, follow the procedure listed below when replacing a speedometer