1996 Mazda 323 TSBs
8 Technical Service Bulletins across 7 categories
Engine
2 bulletinsWIPER MOTOR INOPERATIVE - CIRCUIT BREAKER ACTIVATION.
Read full bulletin
*TW
In accordance with Federal regulations, follow the procedure listed below when replacing a speedometer.
Read full bulletin
NOTE: Tampering with a motor vehicle odometer is strictly prohibited by Federal, and State laws. It is the dealers responsibility to comply with Federal, State, and local laws concerning odometer and related documentation requirements when providing a repair or replacement. Mazda vehicles are manufactured with tamper-proof speedometers. When a speedometer is replaced, the new speedometer will read zero (0) miles. This procedure is extremely important to accurately represent actual vehicle mileage. Prior to speedometer removal, complete the information required on the Speedometer Replacement Label. Labels can only be ordered through Mazda eStore. In an effort to achieve a higher level of Customer Experience and retain the value of Mazdas vehicles, MNAO Warranty Operations is allowing all Mazda dealers to utilize a third party, SPECMO Enterprises, Inc., for Instrument Panel Cluster (IPC) odometer setting service. With the use of SPECMOs services, it is possible that the odometer will be set between 10 to 31 miles over the odometer mileage at the time of replacement for both warranty and customer pay repairs. Please make sure that the customer is aware that there may be a slight variance to the odometer, in which case the customer may have to accept the slightly higher mileage. Since odometer setting service is not part of the warranty repair, it is not warrantable nor required, but optional. However, Mazda Warranty policy provides after- warranty assistance (AWA) or DSA that can be utilized to cover this service expense.
Steering
1 bulletinCONDITIONS WITH STEERING WHEEL SLIGHTLY OFF CENTER.
Read full bulletin
*YC
Body & Paint
1 bulletinPRE-PAINTING PREPARATIONS FOR FRONT AND REAR BUMPERS.
Read full bulletin
*YC
Air Bags & Safety
1 bulletinPARTS REPLACEMENT AFTER AIRBAG DEPLOYMENT.
Read full bulletin
*TW
Electrical
1 bulletinMAINTENANCE FREE BATTERY - DIAGNOSTIC AND CHARGING PROCEDURE.
Read full bulletin
*TW
HVAC & Climate
1 bulletinUSE OF A/C TRACER DYE.
Read full bulletin
*TW
Brakes
1 bulletinSome customers may complain about the following message displayed in the Multi-Information Display: In the following...
Read full bulletin
cases, the MRCC with Stop & Go function system is canceled when the vehicle is traveling at 19 mph (30 km/h) or less: The Forward Sensing Camera (FSC) cannot detect target objects due to one of the following: The windshield is dirty The FSC lens is foggy There is low visibility due to rain, fog or snow It is at night and there is not enough light There is direct or reflected sunlight on the FSC There is problem with the FSC There is a problem with the AUTOHOLD control function. There is a problem with the electric parking brake (EPB).