2005 Land Rover Range Rover Sport TSBs

CAUSE: THIS MAY BE CAUSED BY THE MOLDING'S RETAINING CLIPS LOSING TENSION."

CAUSE: THIS MAY BE CAUSED BY THE MOLDING'S RETAINING CLIPS LOSING TENSION."

incorrectly changed for knock issues when the front bush is cracked and should have been replaced as per Technical Service Bulletins LTB00204v4 and LTB00123v4.

Any of the following DTCs (indicating an air intake system leak) could be stored in the Powertrain Control Module (PCM) ? P2187, P2189, P0505, P0507.

Diagnostic Trouble Code (DTC) B1B87-31, stored in Driver Seat Module (DSM) or Passenger Seat Module (PSM) Note that the seat height motor is supplied as part of the cushion sub-assembly or motor sub-assembly (depending on model)

ROVER / RANGE ROVER VEHICLES IN WARRANTY. CAUSE: UNKNOWN ENGINEERING INVESTIGATION ON-GOING."

HIGHER TIME IN SERVICE VEHICLES, WHERE INSUFFICIENT PERFORMANCE OF THE AIR CONDITIONING COMPRESSOR HAS BEEN FOUND TO BE THE ROOT CAUSE OF THE ISSUE. COMPRESSOR PART NO. LR010723 & LR013934 ACTION: THE COMPRESSOR SUPPLIER IN CONJUNCTION WITH LAND ROVER ENGINEERING HAVE MADE IMPROVEMENTS TO THE COMPRESSORS TO IMPROVE THEIR SERVICE LIFE AND RELIABILITY, AND TWO IMPROVED COMPRESSORS HAVE BEEN SUPPLIED TO PARTS OPERATIONS LR010723 SUPERSEDES TO LR056364 LR013934 SUPERSEDES TO LR056365 PLEASE ENSURE THAT THE LATER PART NUMBER IS FITTED TO ANY VEHICLE THAT IS SUFFERING FROM LACK OF COMPRESSOR PERFORMANCE."

CAUSE: LAND ROVER ENGINEERING HAVE RECENTLY VISITED DEALERSHIPS WHERE A REQUEST HAS BEEN MADE TO REPLACE THE STEERING GEAR FOR AN OIL LEAK IN THE AREA OF THE PINION HOUSING, CASTING, YOKE PLUG OR THE GAITER ADJACENT TO THE PINION HOUSING. FOLLOWING INVESTIGATION THE SOURCE OF THE LEAK PATH WAS IDENTIFIED AS BEING FROM THE SUPPLY AND RETURN HOSE O-RING SEALS. SEE ATTACHED DOCUMENT FOR EXAMPLES."

CUSTOMER EXPERIENCES THE ENGINE OVERHEATING. CAUSE: THE REFILL PROCEDURE HAS NOT BEEN COMPLETED CORRECTLY, RESULTING IN INSUFFICIENT COOLANT IN THE ENGINE."

CAUSE: WHEN CHARGING A BATTERY (BOTH PRIMARY AND SECONDARY) WITH A BMS (BATTERY MONITORING SYSTEM) FITTED, THE EARTH FROM THE CHARGER MUST BE CONNECTED TO A SUITABLE CHASSIS OR ENGINE EARTH (CHECK TOPIX FOR APPROPRIATE LOCATION). THIS ALLOWS THE BMS TO SEE THE CURRENT GOING INTO THE BATTERY. HOWEVER WHEN USING A DIAGNOSTIC CHARGER FROM MIDTRONICS SUCH AS GR1, GRX GR8(110 VOLTS)THIS CONNECTION PROCESS CAN CAUSE AN INCORRECT BATTERY ANALYSIS DUE TO THE EXTRA RESISTANCE IN THE WIRING WHEN CONNECTED TO A CHASSIS OR ENGINE EARTH."

CAUSE: LAND ROVER ENGINEERING HAVE RECENTLY VISITED DEALERSHIPS WHERE A REQUEST HAS BEEN MADE TO REPLACE THE STEERING GEAR FOR AN OIL LEAK IN THE AREA OF THE PINION HOUSING, CASTING, YOKE PLUG OR THE GAITER ADJACENT TO THE PINION HOUSING. FOLLOWING INVESTIGATION THE SOURCE OF THE LEAK PATH WAS IDENTIFIED AS BEING FROM THE SUPPLY AND RETURN HOSE O-RING SEALS."

to respond or no functionality at all.

The Audio/Video button on touch-screen home page may also be greyed out.

to respond or no functionality at all.

CAUSE: INCORRECT DIAGNOSIS."

CAUSE THE ROOT CAUSE WAS FOUND TO BE THAT ANTI RUST OIL RESIDUE REMAINS ON THE SUPPLIER'S TOOLING AT THE START OF A PRODUCTION RUN."

(HLDF) on occasions may fail to download software correctly resulting in no communications with the module and blank screen.

THE VEHICLE SEAT MEMORY MODULE LOGS U1A4C 00, BUILD END OF LINE MODE ACTIVE CAUSE THE SEAT MODULE HAS BEEN INCORRECTLY CONFIGURED TO THE VEHICLE."

This applies to both high line and low line rear camera.

Fault codes U210A - 16 and C1A24 - 67 may also be stored.

point.

CAUSE: THIS MAY BE CAUSED BY A ROAD WHEEL/TIRE ASSEMBLY IMBALANCE AND/OR TEMPORARY TIRE FLAT-SPOTTING.

BECOME ILLUMINATED ON THE INSTRUMENT PACK OF THEIR VEHICLE. *JS

VEHICLES MAY EXHIBIT ONE OR MORE OF THE FOLLOWING: A RUBBING/SQUEAK NOISE FROM THE REAR/PARKING BRAKE WHEN THE VEHICLE IS MOVING; EVIDENCE OF PARKING BRAKE SHOE DRAG (HEAT BUILD UP/EXCESSIVE PARKING BRAKE SHOE LINING WEAR; AND A SCREECH NOISE WHEN APPLYING OR RELEASING THE ELECTRIC PARKING BRAKE (EPB) WHILE THE VEHICLE IS STATIONARY.) *PE