2010 Kia Sportage TSBs

Parking Distance Warning (PDW) alerts and repairs involving ultrasonic sensors. The PDW system alerts the driver while parking, by calculating distance based on the difference in signal transmission and reception times between the vehicle (ultrasonic sensor) and an object. The membrane film of the ultrasonic sensor is used for object detention and can be damaged by stone chips or foreign substances while driving. Damage to the cover of the ultrasonic sensor can also lead to damage to the internal circuit. As a result of this external damage, the PDW system may not receive the proper signal from the ultrasonic sensor. In some cases, the system may cause a false alarm, no alert, or phantom warnings by a Warning Lamp to be displayed on the cluster. The ultrasonic sensor membrane film should be always inspected for external damage and if any part replacement should be treated as a general repair, not as a warranty claim repair for this concern. (Please note that this Pitstop only applies to models/trims that are equipped with the ultrasonic sensors.)

New/revised sections of this bulletin are indicated by a black bar in the margin area. This bulletin provides information relating to the correct transmission fluid type and fill quantity requirement for each Kia model. A flush is required ONLY when a transmission is replaced, and the transmission oil cooler is transferred to the new transmission.

A flush is required ONLY when a transmission is replaced.

correct transmission fluid type and fill quantity requirement for each Kia model. A flush is required ONLY when a transmission is replaced, refer to applicable vehicles in the chart starting on page 2.

SPORTAGE AND SEDONA VEHICLES, PRODUCED FROM APRIL 01, 2009 TO SEPTEMBER 16, 2011, WHICH MAY EXPERIENCE A NO-START CONDITION, UNEVEN ENGAGEMENT WHEN SHIFTING GEARS AND/OR P0705 STORED IN THE POWER-TRAIN CONTROL MODULE (PCM). TO CORRECT THIS CONCERN, INSTALL THE INHIBITOR SWITCH BRACKET ON THE INHIBITOR SWITCH BY FOLLOWING THE SERVICE PROCEDURE OUTLINED BELOW.

PROCEDURE FOR THE INHIBITOR SWITCH TO HAVE AN INHIBITOR SWITCH BRACKET INSTALLED ON IT. MODELS 2010-2012 SPORTAGE, SEDONA. *PE

New/revised sections of this bulletin are indicated by a black bar in the margin area. This bulletin provides information relating to some Kia models that may exhibit fogging, condensation, and/or moisture inside a headlamp assembly. Generally, a fogging condition is considered normal and can be eliminated by turning on the headlamps with the engine running for up to 30 minutes or during normal driving conditions. Headlamp assembly replacement WILL NOT be necessary in most cases.

considered serviceable, and should be thoroughly cleaned and transferred to the new engine.

is conducting a Voluntary Service Campaign to add additional anti-corrosion wax and undercoating to the underbody of certain 2005-2010 MY Sportage vehicles.

is conducting a Voluntary Service Campaign on certain 2005-2010 MY Sportage vehicles produced from June 24, 2004 through January 26, 2010, to add additional anti-corrosion materials to the vehicle underbody.

will be conducting a voluntary service campaign, as a preventative measure, to apply additional anti-corrosion material to the vehicle underbody on certain 2005-2010 MY Sportage vehicles, manufactured from June 24, 2004 through January 26, 2010.

Voluntary Service Campaign

satisfaction, Kia is launching this bulletin to apply additional anti-corrosion protection to various vehicle underbody components on some Sportage (KM) vehicles, built from June 24, 2004 through January 26, 2010.

DEBRIS ACCUMULATION ON THE WINDSHIELD WASHER PUMP INLET FILTER. OVER TIME, SOME KIA VEHICLES MAY EXHIBIT A LIMITED APPLICATION OF WINDSHIELD WASHER FLUID WHEN THE WASHER FUNCTION IS USED. LIMITED APPLICATION OF WINDSHIELD WASHER FLUID CAN BE CAUSED BY FOREIGN DEBRIS ON THE WASHER PUMP INLET FILTER. TO CORRECT THIS CONDITION, REPLACE THE WASHER PUMP INLET FILTER AND PERFORM THE WINDSHIELD WASHER RESERVOIR FLUSHING PROCEDURE OUTLINED IN THIS TSB.

06/04/14*LJ

PROVIDES INFORMATION RELATING TO CERTAIN VEHICLES FOR PROCEDURE TO APPLY ADDITIONAL ANTICORROSION PROTECTION TO THE REAR FLOOR SIDE AND CROSS MEMBERS. *PE

substance found on some Kia vehicles, due to possible excess assembly oil applied during assembly.

once fully attached, are utilized in various Kia models and are strictly intended for ?one time use.? Some examples are: axle shaft nuts with stake collar, cotter pins, washers with locking tabs and other similar hardware, including threaded fasteners with pre-applied ?thread-locking adhesives.? It is critical for technicians to be aware that ALL such locking fasteners, regardless of type, are for ?one time use? only.

strictly intended for ?one time use?. Though not limited to the following, some examples are: axle shaft nuts with stake collar, cotter pins, washers with locking tabs and other similar hardware, including threaded fasteners with pre-applied ?thread-locking adhesives.?

USB ports and 12V power outlets to connect/charge mobile phones. Customers may experience issues with their head units that may be related to the use of aftermarket USB charging cables, including; * Electrical interference and limited or no functionality when attempting to play music, or when charging a device through the USB port * Excessive static or noise when listening to the audio source * Malfunctions and screen freeze of the head unit screen * Slow down of the system response while device is plugged in * Music will not play from iPhone 5 or 6 with Kia iPod cable and aftermarket adapter * No or limited functionality when trying to play music from an Apple device

THIS SPECIAL SERVICE TOOL (SST) WAS DEVELOPED TO IMPROVE THE EFFICIENCY AND EFFECTIVENESS OF UPDATING 2010MY, AND LATER, KIA AUDIO HEAD UNITS USING A GDS, AND NOW, THE SAME FUNCTIONALITY IS AVAILABLE ON KDS. SOME TECHNICIANS MAY NOT BE AWARE OF THE BENEFITS THE AUM TOOL HAS TO OFFER. THE AUM ELIMINATES THE NEED FOR MULTIPLE USB FLASH DRIVES FOR SPECIFIC VEHICLE MODELS AND APPLICATIONS WHICH, IF MISAPPLIED, MAY RESULT IN AN IMPROPER AUDIO SYSTEM SOFTWARE UPDATE AND/OR LOCKED UP HEAD UNIT. ADDITIONALLY, FIELD REPORTS HAVE INDICATED THAT USB DRIVES FOR AUDIO UPDATES ARE EASILY LOST OR MISPLACED.

incorporate a defogging logic to prevent the interior windows from becoming excessively fogged. Depending on the specific model, the HVAC control head monitors ambient temperature and/or cabin humidity to determine which settings will best prevent the windows from fogging. If the system detects lower ambient temperature or higher cabin humidity, the defogging logic may automatically switch ON the A/C, and/or set the air intake mode to Fresh Air. If the user changes these settings, the defogging logic will take control again after 3 to 5 minutes, depending on the procedure in this publication.

RELATED TO CAMPAIGN SC098 AND HAS DETERMINED THAT AT TIMES DEALER STAFF MAY HAVE DIFFICULTY IN QUICKLY AND EASILY IDENTIFYING THE CORRECT SWITCHES WHILE ORDERING PARTS, PREPARING TO PERFORM THE STOP LAMP REPLACEMENT OR WHILE PREPARING TO RETURN REPLACED SWITCHES TO KMA (IN CASE OF AN EXISTING MANDATORY PART RETURN (MPR) REQUEST). TO FACILITATE FASTER AND EASIER IDENTIFICATION OF THE CORRECT PARTS, A PICTURE GUIDE AS SHOWN ON PAGE 2 IS PROVIDED. THE GUIDES CONTENT WAS PURPOSELY FORMATTED TO FIT ON ONE PAGE SO IT CAN BE EASILY PRINTED AND KEPT ON OR NEAR A WORKSTATION, PARTS COUNTER OR TOOL BOX.

*RM