2009 Kia Sportage TSBs

New/revised sections of this bulletin are indicated by a black bar in the margin area. This bulletin provides information relating to some Kia models that may exhibit fogging, condensation, and/or moisture inside a headlamp assembly. Generally, a fogging condition is considered normal and can be eliminated by turning on the headlamps with the engine running for up to 30 minutes or during normal driving conditions. Headlamp assembly replacement WILL NOT be necessary in most cases.

considered serviceable, and should be thoroughly cleaned and transferred to the new engine.

is conducting a Voluntary Service Campaign to add additional anti-corrosion wax and undercoating to the underbody of certain 2005-2010 MY Sportage vehicles.

is conducting a Voluntary Service Campaign on certain 2005-2010 MY Sportage vehicles produced from June 24, 2004 through January 26, 2010, to add additional anti-corrosion materials to the vehicle underbody.

will be conducting a voluntary service campaign, as a preventative measure, to apply additional anti-corrosion material to the vehicle underbody on certain 2005-2010 MY Sportage vehicles, manufactured from June 24, 2004 through January 26, 2010.

IF AT ANY TIME OCV IS SUSPECTED AS A CAUSE OF ROUGH IDLING, POOR ACCELERTION, CAMSHAFT TIMING MISALIGNMENT RELATED TROUBLE CODES, MISFIRE RELATED TROUBLE CODES ETC., ON THE VEHICLE EQUIPPED WITH THE CVVT SYSTEM, BE SURE TO PERFORM THE OCV INSPECTION PROCEDURE BELOW BEFORE REPLACEMENT. NO MODEL YEARS SPECIFIED. *PE

Voluntary Service Campaign

satisfaction, Kia is launching this bulletin to apply additional anti-corrosion protection to various vehicle underbody components on some Sportage (KM) vehicles, built from June 24, 2004 through January 26, 2010.

DEBRIS ACCUMULATION ON THE WINDSHIELD WASHER PUMP INLET FILTER. OVER TIME, SOME KIA VEHICLES MAY EXHIBIT A LIMITED APPLICATION OF WINDSHIELD WASHER FLUID WHEN THE WASHER FUNCTION IS USED. LIMITED APPLICATION OF WINDSHIELD WASHER FLUID CAN BE CAUSED BY FOREIGN DEBRIS ON THE WASHER PUMP INLET FILTER. TO CORRECT THIS CONDITION, REPLACE THE WASHER PUMP INLET FILTER AND PERFORM THE WINDSHIELD WASHER RESERVOIR FLUSHING PROCEDURE OUTLINED IN THIS TSB.

06/04/14*LJ

PROVIDES INFORMATION RELATING TO CERTAIN VEHICLES FOR PROCEDURE TO APPLY ADDITIONAL ANTICORROSION PROTECTION TO THE REAR FLOOR SIDE AND CROSS MEMBERS. *PE

New/revised sections of this bulletin are indicated by a black bar in the margin area. This bulletin provides information relating to the correct transmission fluid type and fill quantity requirement for each Kia model. A flush is required ONLY when a transmission is replaced, and the transmission oil cooler is transferred to the new transmission.

A flush is required ONLY when a transmission is replaced.

correct transmission fluid type and fill quantity requirement for each Kia model. A flush is required ONLY when a transmission is replaced, refer to applicable vehicles in the chart starting on page 2.

once fully attached, are utilized in various Kia models and are strictly intended for ?one time use.? Some examples are: axle shaft nuts with stake collar, cotter pins, washers with locking tabs and other similar hardware, including threaded fasteners with pre-applied ?thread-locking adhesives.? It is critical for technicians to be aware that ALL such locking fasteners, regardless of type, are for ?one time use? only.

strictly intended for ?one time use?. Though not limited to the following, some examples are: axle shaft nuts with stake collar, cotter pins, washers with locking tabs and other similar hardware, including threaded fasteners with pre-applied ?thread-locking adhesives.?

*RM

PROVIDING INFORMATION FOR THE NEW REQUIREMENTS RELATED TO LOAD CARRYING CAPACITY (LCC) WHEN CERTAIN ACCESSORIES ARE ADDED TO A COMPLETED VEHICLE PRI0R TO FIRST RETAIL SALE. *PE

USB ports and 12V power outlets to connect/charge mobile phones. Customers may experience issues with their head units that may be related to the use of aftermarket USB charging cables, including; * Electrical interference and limited or no functionality when attempting to play music, or when charging a device through the USB port * Excessive static or noise when listening to the audio source * Malfunctions and screen freeze of the head unit screen * Slow down of the system response while device is plugged in * Music will not play from iPhone 5 or 6 with Kia iPod cable and aftermarket adapter * No or limited functionality when trying to play music from an Apple device

RELATED TO CAMPAIGN SC098 AND HAS DETERMINED THAT AT TIMES DEALER STAFF MAY HAVE DIFFICULTY IN QUICKLY AND EASILY IDENTIFYING THE CORRECT SWITCHES WHILE ORDERING PARTS, PREPARING TO PERFORM THE STOP LAMP REPLACEMENT OR WHILE PREPARING TO RETURN REPLACED SWITCHES TO KMA (IN CASE OF AN EXISTING MANDATORY PART RETURN (MPR) REQUEST). TO FACILITATE FASTER AND EASIER IDENTIFICATION OF THE CORRECT PARTS, A PICTURE GUIDE AS SHOWN ON PAGE 2 IS PROVIDED. THE GUIDES CONTENT WAS PURPOSELY FORMATTED TO FIT ON ONE PAGE SO IT CAN BE EASILY PRINTED AND KEPT ON OR NEAR A WORKSTATION, PARTS COUNTER OR TOOL BOX.