2001 Kia Sephia TSBs

*TT

CERTAIN MODELS INCLUDING ALL RIOS. *SLC

TRANSMISSION FLUIDS THAT ARE REQUIRED FOR EACH KIA MODEL. REFER TO THE SHOP MANUAL ON KGIS FOR THE SPECIFIC KIA MODEL, THEN REFERENCE THE AUTOMATIC TRANSAXLE SYSTEM/ REPAIR PROCEDURES/ INSPECTION AND ADJUSTMENT SECTION FOR THE CORRECT ATF CHECK/FILL PROCEDURES.

New/revised sections of this bulletin are indicated by a black bar in the margin area. This bulletin provides information relating to some Kia models that may exhibit fogging, condensation, and/or moisture inside a headlamp assembly. Generally, a fogging condition is considered normal and can be eliminated by turning on the headlamps with the engine running for up to 30 minutes or during normal driving conditions. Headlamp assembly replacement WILL NOT be necessary in most cases.

considered serviceable, and should be thoroughly cleaned and transferred to the new engine.

once fully attached, are utilized in various Kia models and are strictly intended for ?one time use.? Some examples are: axle shaft nuts with stake collar, cotter pins, washers with locking tabs and other similar hardware, including threaded fasteners with pre-applied ?thread-locking adhesives.? It is critical for technicians to be aware that ALL such locking fasteners, regardless of type, are for ?one time use? only.

strictly intended for ?one time use?. Though not limited to the following, some examples are: axle shaft nuts with stake collar, cotter pins, washers with locking tabs and other similar hardware, including threaded fasteners with pre-applied ?thread-locking adhesives.?

*ET

*ET

BULB; REAR STOP LAMP/TAIL LAMP BULB UTILIZED ON MULTIPLE KIA MODELS. *PE

*TT