2018 Kia Optima Hybrid TSBs

New/revised sections of this bulletin are indicated by a black bar in the margin area. This bulletin provides the procedure to improve the logic of the Battery Management System (BMS), Oil Pump Control Unit (OPU) and Motor Control Unit (MCU) on some 2017-2019MY Optima (JF P/HEV) vehicles, produced from August 25, 2016 through September 13, 2018 (refer to page 8) in order to improve the BMS diagnosis logic, OPU judgment logic for DTC P1B77 (High Voltage Battery Pre-Charging fault) and MCU communication logic.

the small bearing of the Column Motor Driven Power Steering (C-MDPS) unit on the vehicles listed below, which may exhibit an abnormal noise when steering left and right. This may be caused by foreign substances in the MDPS worm shaft small bearing. On some vehicles when the steering wheel is rotated a scraping noise can be heard originating from the lower bearing on the Worm Gear Small Bearing and does not affect the steering effort.

bulletin has been revised to include additional information. New/revised sections of this bulletin are indicated by a black bar in the margin area. This bulletin provides information regarding the partial repair of the Motor Driven Power Steering (MDPS) Motor, Electronic Control Unit (ECU), Steering Column Housing, or Worm Gear Assembly. When the steering wheel is rotated a scraping noise can be heard originating from the lower bearing on the Worm Gear Assembly on some 2010MY~ Kia models listed on page 8, equipped with a Column Motor Driven Power Steering (C-MDPS) unit. On some vehicles when the steering wheel is rotated a scraping noise can be heard originating from the lower bearing on the Worm Gear Assembly and does not affect the steering effort.

New/revised sections of this bulletin are indicated by a black bar in the margin area. This bulletin provides information relating to some Kia models that may exhibit fogging, condensation, and/or moisture inside a headlamp assembly. Generally, a fogging condition is considered normal and can be eliminated by turning on the headlamps with the engine running for up to 30 minutes or during normal driving conditions. Headlamp assembly replacement WILL NOT be necessary in most cases.

bulletin has been revised to include additional information. New/revised sections of this bulletin are indicated by a black bar in the margin area. This bulletin provides information regarding the partial repair of the Motor Driven Power Steering (MDPS) Motor, Electronic Control Unit (ECU), Steering Column Housing, or Worm Gear Assembly. When the steering wheel is rotated a scraping noise can be heard originating from the lower bearing on the Worm Gear Assembly on some 2010MY~ Kia models listed on page 8, equipped with a Column Motor Driven Power Steering (C-MDPS) unit.

bulletin has been revised to include additional information. New/revised sections of this bulletin are indicated by a black bar in the margin area. This bulletin provides information regarding the partial repair of the Motor Driven Power Steering (MDPS) Motor, Electronic Control Unit (ECU), Worm Gear Assembly or Steering Column Housing on some 2010MY~ Kia models listed on page 8, equipped with a Column Motor Driven Power Steering (C-MDPS) unit.

bulletin has been revised to include additional information. New/revised sections of this bulletin are indicated by a black bar in the margin area. This bulletin provides information regarding the partial repair of the Motor Driven Power Steering (MDPS) Motor, Electronic Control Unit (ECU), Worm Gear Assembly or Steering Column Housing on some 2010MY~ Kia models listed on page 8, equipped with a Column Motor Driven Power Steering (C-MDPS) unit.

to improve the logic of the Battery Management System (BMS), Oil Pump Control Unit (OPU) and Motor Control Unit (MCU) on some 2017-2019MY Optima (JF P/HEV) vehicles, produced from August 25, 2016 through September 13, 2018 (refer to page 8) in order to improve the BMS diagnosis logic, OPU judgment logic for DTC P1B77 (High Voltage Battery Pre-Charging fault) and MCU communication logic.

revised to include additional information.This bulletin provides information regarding the partial repair of the Motor Driven Power Steering (MDPS) Motor, Electronic Control Unit (ECU) or Steering Column Housing on some 2010MY~ Kia models listed on page 5 equipped with a Column Motor Driven Power Steering (C-MDPS) unit. Follow the MDPS Flowchart (page 2) along with the MDPS DTC Table (page 3) procedure outlined in this bulletin before replacing the C-MDPS Motor, ECU or Steering Column Housing.

has been revised to include additional information.This bulletin provides information regarding the partial repair of the Motor Driven Power Steering (MDPS) Motor, Electronic Control Unit (ECU) or Steering Column Housing on some 2010MY~ Kia models listed on page 5 equipped with a Column Motor Driven Power Steering (C-MDPS) unit.

the lower engine service cover on 2016-2020MY Optima 2.4L and 2.0L equipped vehicles. The lower engine service cover is secured by seven (7) retaining bolts. Installation of the two (2) long bolts in the incorrect location may cause puncture or damage to the oil pan in the event that the vehicle is bottomed out while driving. If the oil pan is damaged or punctured, the engine oil may leak, possibly causing engine damage. This

This bulletin provides information related to extracting in use performance tracking emissions data from the Engine Control Unit (ECU) of certain vehicles sold in California.

This bulletin provides information regarding the partial repair of the Motor Driven Power Steering (MDPS) Motor, Electronic Control Unit (ECU) or Steering Column Housing on the Kia models listed on the chart below with a column mounted C-MDPS unit.

extracting "in use performance tracking" emissions data from the Engine Control Unit (ECU) of certain vehicles sold in California. The California Air Resources Board (CARB) requires the emissions data from vehicles with a minimum of 3,000 accumulated miles without reprogramming or resetting.

This bulletin provides information relating to all Kia vehicles equipped with Gasoline Direct Injection (GDI) engines. In these engines highly pressurized gasoline is injected via a common fuel rail and injectors that deliver fuel directly into the combustion chamber of each cylinder. In comparison, in a conventional Multi-Point Fuel Injection (MPI) engine, the gasoline is injected into the intake port of each cylinder at a relatively low pressure. Due to high fuel pressure in a GDI system, servicing the GDI system requires special attention and handling procedures. This bulletin provides special service information and specifications for the GDI fuel system components.

This bulletin provides information related to extracting ?in use performance tracking? emissions data from the Engine Control Unit (ECU) of certain vehicles sold in California.

considered serviceable, and should be thoroughly cleaned and transferred to the new engine.

extracting ?in use performance tracking? emissions data from the Engine Control Unit (ECU) of certain vehicles sold in California.

New/revised sections of this bulletin are indicated by a black bar in the margin area. This bulletin provides information regarding partial repair of the Air Conditioning (A/C) compressor assembly on some 2011MY~ Optima Hybrid (TF HEV, JF HEV/PHEV), 2015MY~ Soul EV (PS EV), 2017MY~ Niro (DE HEV/PHEV/EV), 2022MY~ EV6 (CV), 2021MY~ Sorento (MQ4 HEV/PHEV), 2023MY~ Sportage (NQ5 HEV/PHEV), and 2023MY~ Niro (SG2 EV/HEV/PHEV) vehicles.

New/revised sections of this bulletin are indicated by a black bar in the margin area. This bulletin outlines the ordering and return procedure for high-voltage Lithium-ion batteries equipped on EV/hybrid vehicles (hereafter referred to as "high-voltage batteries" or HVBs).

New/revised sections of this bulletin are indicated by a black bar in the margin area. This bulletin outlines the ordering and return procedure for high-voltage Lithium-ion batteries equipped on EV/hybrid vehicles (hereafter referred to as "high-voltage batteries" or HVBs).

alignment on 2014MY and later vehicles that may exhibit a warning light ON related to radar sensor alignment errors in the Forward Collision-Avoidance Assist (FCA)/Smart Cruise Control (SCC) system.

partial repair of the Air Conditioning (A/C) compressor assembly on some 2011MY~ Optima (TF HEV, JF HEV/PHEV/EV), Soul (PS EV) and Niro (DE HEV/PHEV/EV) vehicles.

parasitic draw and, if necessary, replace one or both rear door latches on some of the following vehicles which may experience a discharged 12v battery.

gauge on all Kia Hybrid P/HEV) vehicles. Normal operation of the HEV SOC gauge is between 40-60%. This is to allow for regeneration and degeneration of the HEV battery.

and Niro (DE HEV) vehicles are equipped with a replaceable 30A fuse for the eCompressor. This fuse is easily accessible under a cover between the power cable connector and inverter cable, as shown below. However, the housing for the fuse is internally bolted to the HPCU assembly and is only available as part of the HPCU assembly. Forcibly removing the fuse housing assembly will result in damaging the internal HPCU terminals which will require replacement of the entire HPCU assembly and is not covered under Warranty.Follow the procedure in this ublication to inspect and/or replace the fuse, or refer to the ?Hybrid Control System ? Hybrid Control System ? DC Fuse ? Repair procedures? chapter in the applicable Shop Manual on KGIS.

Parking Distance Warning (PDW) alerts and repairs involving ultrasonic sensors. The PDW system alerts the driver while parking, by calculating distance based on the difference in signal transmission and reception times between the vehicle (ultrasonic sensor) and an object. The membrane film of the ultrasonic sensor is used for object detention and can be damaged by stone chips or foreign substances while driving. Damage to the cover of the ultrasonic sensor can also lead to damage to the internal circuit. As a result of this external damage, the PDW system may not receive the proper signal from the ultrasonic sensor. In some cases, the system may cause a false alarm, no alert, or phantom warnings by a Warning Lamp to be displayed on the cluster. The ultrasonic sensor membrane film should be always inspected for external damage and if any part replacement should be treated as a general repair, not as a warranty claim repair for this concern. (Please note that this Pitstop only applies to models/trims that are equipped with the ultrasonic sensors.)

New/revised sections of this bulletin are indicated by a black bar in the margin area. This bulletin provides information relating to the correct transmission fluid type and fill quantity requirement for each Kia model. A flush is required ONLY when a transmission is replaced, and the transmission oil cooler is transferred to the new transmission.

A flush is required ONLY when a transmission is replaced.

correct transmission fluid type and fill quantity requirement for each Kia model. A flush is required ONLY when a transmission is replaced, refer to applicable vehicles in the chart starting on page 2.

This bulletin provides information relating to the correct transmission fluid type and fill quantity requirement for each Kia model. A flush is required ONLY when a transmission is replaced, refer to applicable vehicles on page 2. Refer to the shop manual on KGIS for the specific Kia model for the correct transmission fluid check/fill procedures.

of intermittent ?No-Start?.

This bulletin provides information regarding axle shaft serviceability for Kia vehicles equipped with a six-speed automatic transmission.

New/revised sections of this bulletin are indicated by a black bar in the margin area. This bulletin provides the repair procedure for the Integrated Brake Actuation Unit (iBAU) system on some 2014-2019MY EV/Hybrid/Plug-In Hybrid vehicles listed (see table), which may exhibit a "honking" (Hissing) noise due to air remaining in the brake fluid system.

substance found on some Kia vehicles, due to possible excess assembly oil applied during assembly.

This bulletin provides the repair procedure for the Integrated Brake Actuation Unit (iBAU) system on some 2014-2019MY EV/Hybrid/Plug-In Hybrid vehicles listed (see table), which may exhibit a Honking (Hissing) noise due to air remaining in the brake fluid system.

Integrated Brake Actuation Unit (iBAU) system on some 2014-2019MY Kia EV/Hybrid/Plug-In Hybrid vehicles listed (see table), which may exhibit a Honking (hissing) noise due to air remaining in the brake fluid system.

This bulletin provides the repair procedure for the Integrated Brake Actuation Unit (iBAU) system on some 2014-2019MY EV/Hybrid/Plug-In Hybrid vehicles listed (see table), which may exhibit a "Honking" (Hissing) noise due to air remaining in the brake fluid system.

New/revised sections of this bulletin are indicated by a black bar in the margin area. This pitstop provides the KDS service procedure for mileage setting on the models listed below with newly replaced instrument clusters. Certain models allow for mileage setting with the KDS, which prevents the need to send out the instrument cluster to a 3rd party for mileage adjustment (refer to PS264). After a new cluster is installed, cluster (variant) coding may also need to be conducted using the KDS. Make sure the KDS software is also updated to the latest version. Mileage setting should be performed by using the KDS only, as described in this bulletin.

regarding the procedure to repair the bulb connector on some 2010MY~ vehicles listed on the table below, which may exhibit a bulb connector concern. To correct this concern, replace the connector with a new and improved part.

provides information to properly test the evaporative emissions system in all Kia 2011MY~ Hybrid (HEV) and Plug-In Hybrid (PHEV) model vehicles. A smoke machine should NEVER be used when testing the evaporative system in a HEV/PHEV model vehicle.

provides the procedure to perform an evaporative leak test and replace the fuel tank air filter, and, if necessary, the Natural Vacuum Leak Detector (NVLD) on some Optima (JF HEV) vehicles, produced from June 27, 2016 through January 7, 2019, which may experience an evaporative leak concern with DTC P0456.

operation of Multi-Function Camera (MFC) on some Kia vehicles. When normal operation is not possible due to certain outside environment conditions (such as sunlight glare, heavy rain, sunlight, snow, fog and/or substance/debris) causing a temporary concern. This stops operation causing Warning Lamp ON and/or Pop-up Message displayed on the cluster. This is a normal operation of the ADAS and once environment conditions improve and/or substance/debris are removed, the system will clear itself and operate normally.

the clock on UVO eServices (UVO 3.0) head units installed on 2017-2018MY vehicles.

New/revised sections of this bulletin are indicated by a black bar in the margin area.This bulletin provides information on setting the "Service Interval Reminder" feature available on most 2014-2023MY Kia vehicles (refer to model list on page 2). If the service interval reminder is set, the customer will be informed to have the next maintenance service performed, which can positively affect vehicle longevity and performance. Refer to TSB ENG241 for 2023MY~ vehicles equipped with the Oil Life Management System (OLMS) feature not included in table on page 2.

A/C system leak detection dye to be used in all EV, HEV, and PHEV models equipped with an electric A/C compressor.

information regarding Eco-Coasting Guide (eCoasting) and Eco-Driving Assistant System (DAS) found on 2017-18MY Niro (DE HEV), Niro Plug-in (DE PHEV), Optima Hybrid (JF HEV), and Optima Plug-in (JF PHEV) vehicles.