Powered byNHTSA|EPA|Community Reports|Updated
HomeTSBsKeystone2020 Avalanche

2020 Keystone Avalanche TSBs

6 Technical Service Bulletins across 3 categories

Other

4 bulletins
10248985

Revision of KSB-210122.

Read full bulletin

It has been determined the units in this KSB population may develop sidewall cracks at both front slideouts. Only units that develop a crack will require this repair, if the sidewall is not cracked, no repair is needed.

10245576

It has been determined the units in this KSB population may develop sidewall cracks at both front slideouts.

Read full bulletin

Only units that develop a crack will require this repair, if the sidewall is not cracked, no repair is needed.

10209261

It has been determined the units in this KSB population may develop sidewall cracks at both front slideouts.

Read full bulletin

Only units that develop a crack will require this repair, if the sidewall is not cracked, no repair is needed.

10174991

This process describes how to replace a Furrion Antenna head with a Winegard 360 for Over The Air (OTA) channels.

Lighting

1 bulletin
10187956

Attached are the updated repair instructions for KSB-200305.

Read full bulletin

The information and instructions in a Keystone Service Bulletin (KSB) are intended to inform RV dealership Service Managers/Technicians of situations that may occur with some Recreational vehicles so dealership personnel can perform proper and efficient service. KSBs are intended to be used by trained RV technicians with the knowledge, tools and equipment to do the job properly and safely, not do-it-yourselfers. Information is not presented as a repair guaranteed to be covered by warranty. Keystones P & P (Policy & Procedures) must be followed for any requested warranty work. Do not assume this repair is covered by warranty. This process describes how to replace a Furrion Antenna head with a Winegard 360 for Over The Air (OTA) channels.

Fuel System

1 bulletin
10172607

This is the repair instructions, dealer letter, and owner letter for advisory 20-375.

Read full bulletin

It has been determined certain Kinro frameless windows were manufactured with a poor adhesive bond between the glass and aluminum frame, and attachments on crank out and egress windows. The remedy is to perform a pull test on the frameless windows at the vent and replace the vent portion if the glue bond fails during the pull test.