2025 Jeep Cherokee TSBs

The instrument cluster should not be replaced based solely on the presence of stored or pending DTCs in the IPC. Replacement should only be considered if the stored or pending DTC becomes active during the troubleshooting and diagnostic process.

Upon further investigation the technician may find the following Diagnostic Trouble Code (DTC): - P152E Engine -Hood Switch 2 Circuit High. - DTC P152F Customers may also experience: - Start/Stop system warning light. - Start/Stop inoperable. - Remote start inoperable. Diagnosis: - Using a Scan Tool (wiTECH) with the appropriate Diagnostic Procedures available in DealerCONNECT/Service Library, verify all related systems are functioning as designed. If DTCs or symptom conditions, other than the one listed are present, record the issues on the repair order and repair as necessary before proceeding further with this bulletin. - If any vehicle exhibits any of the symptoms listed above in the customer symptom section, perform the Repair Procedure. - Special Tools/Equipment: wiTECH or equivalent. Repair Procedure: 1. Open the hood and locate the hood switch 2. Push in on the two locking tabs and pull them out. 3. Disconnect the wire connector from the switch. 4. Connect the wires to the same hood switch. 5. Push the switch back into the hold until both lock tab are engaged. 6. Clear all DTCs that may have been set in any module during this repair procedure. 7. In case the P152F/P152E DTCs persist, repeat the procedure with a new/spare/known good switch and repeat steps 5 and 6. 8. Replace switch installed during previous step for the original switch of the vehicle. If DTCs P152F/P152E are not present, leave the original switch installed and do not document the change of the switch in the repair process/narrative.

Part numbers affected: 68630089AA 68630088AB 68649038AA Welcome Green LED turns on for 1 second after multiple IGN ON/OFF without sleep cycle and no phone on the charging pad. Intent of this condition is to notify the customer/dealership that the Wireless Charging Pad is ready to charge. Do not report as warranty claim, no impact to wireless charger functionality. Part numbers affected: 68630089AB 68630088AD 68649038AB Advice to dealership: Do no replace wireless charger PNs 68630089AA,68630088AB,68649038AA if no Welcome GREEN LED is seen after multiple IGN ON/OFF without sleep cycle and no phone on the charging pads. This feature is available in the successor NIKs, no impact to wireless charger functionality.