2005 Jaguar S-Type TSBs

IF CONDITION IS FOUND, REPLACE THE DIRECTIONAL INDICATOR SWITCH. NO MODEL YEARS LISTED. *PE

THE REMOTE CONTROL KEY FOB FAILS TO OPERATE LEADING TO CUSTOMERS USING THE MECHANICAL KEY BLADE TO LOCK/UNLOCK THE VEHICLE, AND TO TURN OFF THE ALARM. CSC LETTER WAS RECEIVED. *PE

SHOULD THE EXISTING FUEL TANK REQUIRE REPLACEMENT, IT WILL BE NECESSARY TO PERFORM A CONVERSION SO THE NEW SERVICE PART CAN BE USED. THIS CONVERSION IS ONLY NECESSARY ONCE; FOR ANY POSSIBLE FUTURE REPAIRS TO THE FUEL TANK, ONLY THE AFFECTED COMPONENTS WILL REQUIRE REPAIR / REPLACEMENT."

SHOULD THE EXISTING FUEL TANK REQUIRE REPLACEMENT, IT WILL BE NECESSARY TO PERFORM A CONVERSION SO THE NEW SERVICE PART CAN BE USED. THIS CONVERSION IS ONLY NECESSARY ONCE; FOR ANY POSSIBLE FUTURE REPAIRS TO THE FUEL TANK, ONLY THE AFFECTED COMPONENTS WILL REQUIRE REPAIR / REPLACEMENT."

CALIBRATION VERIFICATION, IN USE MONITOR PERFORMANCE RATIO, AND AN EMISSION ISSUE RELATING TO OPEN LOOP SMOOTHING HAVE BEEN IDENTIFIED. *PE

*KB

*TT FUEL LEVEL SENDER-AVAILABLE SEPARATELY FROM PUMP-REPLACEMENT PROCEDURE. *SC

*TT

DUE TO A CHANGE IN DESIGN, THE REAR DIFFERENTIAL HAS A NEW SERVICE PART. AS A RESULT, SHOULD THE REAR DIFFERENTIAL REQUIRE REPLACEMENT IT WILL BE NECESSARY TO CONVERT THE DRIVELINE SYSTEM TO USE THE NEW DIFFERENTIAL. *PE UPDATED 11/7/11. *PE

WARNING LIGHTS AND MESSAGES APPEAR IN THE (IPK) AND A CONSTANT BEEPING TONE FROM PARK BRAKE WARNING FROM THE (IPK), DIAGNOSTIC TROUBLE CODES (DTCS) RECORDED ARE: POWERTRAIN CONTROL MODULE (PCM) & PARK BRAKE MODULE (PBM)"

MODEL S TYPE (X200). NO MODEL YEAR. *PE

*RM UPDATED 10/17/14. *PE

*AK

*TT

RECALL R-171. *TT

*TT

*EH THIS SERVICE BULLETIN REPLACES XT20408 DATED 02/04. *EH THIS SERVICE BULLETIN REPLACES XT20408 DATED 03/04. *KB

ANALYSIS PLEASE ENSURE THAT YOU HAVE THE FOLLOWING INFORMATION AVAILABLE BEFORE CONTACTING JAGUAR CARS: VIN VEHICLE TYPE AND MODEL DATE ACM WAS FITTED TO THE VEHICLE A CONCISE DESCRIPTION OF THE PROBLEM AND ITS REGULARITY OF OCCURANCE THE SOFTWARE LEVEL AND BUILD DATE COSE OF THE ACM FITTED. WORK PERFORMED ON THE VEHICLE TO SOLVE THE PROBLEM TO DATE IS THIS A PROBLEM SEEN IMMEDIATELY AFTER INSTALLATION IS IT PERMANENT HOW DOES THE PROBLEM DEMONSTRATE ITSELF WHAT I-POD IS THE CUSTOMER USING...ETC MANY THANKS FOR YOUR HELP TOPIX - SSM39290 - AUDIO CONNECTIVITY MODULE (ACM) PAGE 1 OF 1 HTTP://"

THE FUEL SENDERS ARE OPEN CIRCUIT. THIS DIAGNOSIS MAY BE INCORRECT DEPENDING ON THE MULTIMETER SETTINGS SELECTED BY THE TECHNICIAN DURING MEASUREMENT. CAUSE: THE MULTI METER RANGE MAYBE SET AT 'AUTO' AND DURING A SWEEP OF THE SENDER FROM 50OHMS TO 998OHMS THE MULTI METER HAS TO CHANGE ITS MEASUREMENT RANGE. FOR APPROXIMATELY 1 SECOND, DURING THE RANGE SWITCH OVER POINT, THE MULTI METER DISPLAY INDICATES AN OPEN CIRCUIT. THIS IS INCORRECTLY BEING DIAGNOSED AS A SENDER FAULT"

CONCERN BEING TRACKED VIA THE EPQR SYSTEM. USERS REPORT DVD133 IS UNABLE TO FULLY COMMUNICATE WITH PCM ON LEGACY JAGUAR VEHICLES, AND REGARDLESS OF PCM STATUS ICON DISPLAYED ON NETWORK SUMMARY SCREEN, SDD MAY NOT DISPLAY DTCS FROM THE PCM CAUSE: THIS ISSUE IS CURRENTLY UNDER INVESTIGATION IN THE UK AND WILL BE ADDRESSED ON A FUTURE SDD SOFTWARE UPDATE."

*TT

FAILURE SENSING ARE NOT COMPATIBLE WITH TRAILER LIGHT BOARDS THAT HAVE LED BASED ILLUMINATION. AS A RESULT OF THIS THE LED LIGHTING ON THE TRAILER BOARD MAY FLICKER DURING THE SENSING FUNCTION. (THIS ISSUES WILL ALSO PRESENT ITSELF IF FITTING LED REAR LIGHT CLUSTERS AVAILABLE IN THE AFTERMARKET(NON-JAGUAR APPROVED ACCESSORY) BASED UPON THIS WE RECOMMEND THAT TRAILER LIGHT BOARDS WITH STANDARD INCANDESCENT BULBS ONLY ARE FITTED."

WARNING LIGHT OR OTHER SUGGESTION OF A FAULT.

WITH THE POSSIBILITY OF DIAGNOSTIC TROUBLE CODE(S) (DTC) P0300, P0301 TO P0306, P1313, P1314 OR P1316 STORED. *TT

CAUSE: POOR FUEL QUALITY OR FUEL CONTAMINANTS BLOCKING THE HOLES IN THE FUEL INJECTOR."

CRANKED, CORRUPTING THE B2B FIBRE OPTIC NETWORK RING. *TT

*EH UPDATE. *TT

*KB

*KB

SERVICE ACTION S516. *EH

*TT

DA J2534 SOFTWARE DRIVER LEVEL V4.0 (MUST BE UPDATED TO THIS LEVEL ON ALL SDD MACHINES THAT USE THIS DEVICE) DA APP HUB LEVEL V2.4.0 (MUST BE UPDATED TO THIS LEVEL ON ALL SDD MACHINES THAT USE THIS DEVICE) DA FIRMWARE LEVEL V57. (ONLY NEEDS TO BE UPDATED ONCE TO EACH DEVICE, BECAUSE THIS IS HELD ON THE DEVICE ITSELF)"

INSTALL A NEW AXLE ASSEMBLY AND AXLE HOUSING BUSHING. *KB

SERVICE ACTION S163. *EH

- SERVICE ACTION S518. *EH

*TT