2009 Isuzu Npr TSBs

IDLING EMISSIONS STANDARD OF 30 GRAMS PER HOUR OF OXIDES OF NITROGEN (NOX) WITH NO INCREASE IN THE EMISSION OF OTHER REGULATED POLLUTANTS. AS A RESULT THESE VEHICLES HAVE BEEN APPROVED AS "CERTIFIED CLEAN IDLE" AND ARE "EXEMPT" FROM THE ENGINE SHUTDOWN SYSTEM (ESS) REQUIREMNET PURSUANT OT SECTION 1956.8 OF TITLE 13, CALIFORNIA CODE OF REGULATIONS. AS REQUIRED BY THE ESS REGULATION, FOR "CERTIFICED CLEAN IDLE" VEHICLES, ISUZU HAS INTRODUCED A TAMPER RESISTANCE "CERTIFIED CLEAN IDLE" LABEL LOCATED ON THE DRIVER'S SIDE DOOR PANEL. IT IS IMPORTANT THAT THIS LABEL REMAIN, PERMANENTLY, ON THE VEHICLE TO IDENTIFY IT AS "CERTIFIED CLEAN IDLE." CARB REQUIRES THIS LABEL AS EVIDENCE THAT, AT HTE TIME OF MANUFACTURE, THE ENGINE INSTALLED MET THE APPLICABLE EMISSION STANDARDS. SHOULD THE LABEL BE FOUND MISSING OR DAMGED DURING AN INSPECTION, A CITATION AND PENALTIES MAY BE ISSUED. IF THE VEHICLE IS OPERATED IN CALIFORNIA WITH A DAMAGED OR MISSING CLEAN IDLE LABEL, ISUZU RECOMMENDS VEHICLE OPERATORS FOLLOW THE 5 MINUTE ESS REQUIREMENT BY MANUALLY TURNING OFF THE ENGINE. FOLLOWING THIS ESS REQUIREMNET WILL KEEP THE VEHICLE OPERATION COMPLIANT UNTIL A REPLACEMENT LABEL CAN BE INSTALLED. "CLEAN AIR IDLE" LABELS ARE PRINTED WITH A SERIAL NUMBER AND REGISTERED TO AN INDIVIDUAL VIN. AS A RESULT, A REPLACEMNET LABEL WILL ALSO INCLUDE A NEW SERIAL NUMBER WHICH MUST BE REGISTERED TO THE VEHICLE'S VIN BY THE MANUFACTURER. THE BELOW INFORMATION IS PROVIDED TO ASSIT IN ACQUIRING, REPLACING AND REGISTERING A REPLACEMENT LABEL.

AND A LACK OF POWER DUE TO POSSIBLE OPERATION CONDITION OF SUCTION CONTROL VALVE (SCV)/FUEL RAIL PRESSURE (FRP) REGULATOR BEING INTERMITTENT. MODELS 2004-2010 CHEVROLET/GMC C, T, W SERIES AND ISUZU F, H, N SERIES. *PE

*RM

MODELS EQUIPPED WITH DIESEL PARTICULATE FILLER (DPF) AND WHOLESALED BEFORE 12/03/09, WERE BUILT WITH AN INCORRECT ENGINE OIL DIPSTICK CALIBRATION. THE INCORRECT CALIBRATION CAUSES AN OVERFILLED CONDITION OF APPROXIMATELY 1.5QTS WHEN AT THE FULL MARK. *PE

THE FOLLOWING TABLE CONTAINS MANY POSSIBLE CAUSES FOR THE FOLLOWING SYMPTOMS. HARD START/NO START; ROUGH, MISFIRE, UNSTABLE OR INCORRECT IDLE; SURGES, LACK OF POWER, HESITATION, LAG OR STUMBLE. WHILE SOME OF THESE SYMPTOMS MAY LEAD TO COMPONENT REPLACEMENT, THE REPLACEMENT SHOULD NOT BE CONSIDERED A COMPLETED REPAIR. THESE TYPES OF SYMPTOMS HAVE A HIGH PROBABILITY FOR A REPEAT REPAIR SINCE THE TRUE SOURCE OF THE FAILURE IS TYPICALLY FUEL CONTAMINATION. *PE UPDATED 3/23/12. *PE

(ICTA) is providing the following procedural recommendations to improve dealer efficiency when submitting Parts Warranty claims. We strongly recommend dealers follow these procedures in order to avoid delays in Parts Warranty claim payments and/or claim chargeback. This bulletin was revised to add a Parts Warranty Form

(ICTA) is providing the following procedural recommendations to improve dealer efficiency when submitting Parts Warranty claims. We strongly recommend dealers follow these procedures in order to avoid delays in Parts Warranty claim payments and/or claim chargeback.

Isuzu dealer technicians repairing Isuzu vehicles in and out of vehicle warranty. A TAC case number will be issued solely for information tracking purposes and future contact reference.

DIPSTICK TUBE, AND A NEW BREATHER HOSE VENT WAS DESIGNED TO REDUCE THIS CONDITION. MODELS 2007-2012 N SERIES, 2007-2010 W SERIES. *PE

THE ABS/TRANSMISSION/MALFUNCTION LIGHTS MAY BE ON. WATER INTRUSION IN WIRING HARNESSES MAY BE CAUSING THE PROBLEM. *RM

TECHNICIANS MAY FIND DTCS P0894 OR P0218 STORED EITHER CURRENT OR IN HISTORY. THESE CONDITIONS MAY BE CAUSED BY FRICTION MATERIAL DEBONDING FROM THE TORQUE CONVERTER CLUTCH. HARSH OR DELAYED SHIFTS, NO DRIVE, NO REVERSE, SLIPS AND THE SES/MIL MAY BE ILLUMINATED. *PE UPDATED 9/15/10. *PE

If a Threebond product is unavailable, we recommend that you utilize the chart below to find equivalent of similar products (when available) from Loctite and Permatex.

This bulletin provides instructions with regard to the Isuzu Commercial Vehicle (CV) Warranty Parts Center on the topics of parts retention, parts preparation for shipping, and administration.

The Exchange Program must be used when any Alpine radio or other component covered by this bulletin is repaired under warranty and may also be used for radio and component repairs not covered under warranty. Contact Alpine directly for pricing and payment methods applicable to radio and component repairs not covered under warranty.

AT PORT TO BOTH RADIATOR AND SURGE TANK. *PE

SOME UP-FITTER APPLICATIONS, WHICH INCLUDE THE USE OF LED BRAKE LIGHTS, MAY CAUSE THE FACTORY CRUISE CONTROL TO BECOME INOPERATIVE. THIS CONDITION IS CREATED WHEN THE FACTORY FILAMENT STYLE BRAKE LAMP BULBS IS REPLACED WITH LED TYPE BULBS. *PE

VEHICLES MAY HAVE A LOOSE OR UNSECURED CAB STAY JOINT PIN. CSC LETTER WAS RECEIVED. *PE