2003 Ic Bus Resb TSBs
46 Technical Service Bulletins across 12 categories
Categories
Other
15 bulletinsIC Bus Operator's Manuals
This document will guide the user through understanding Prop Shaft Codes and understanding the variations of prop codes.
Read full bulletin
(Metric Prop codes start with the number a 4 and Non metric Prop codes start with a 2.)
Title: Driveline Information Center and Troubleshooting Procedures Applies To: All Vehicles
Title: Fan belt replacement guidelines for frayed edges Applies To: All Models
J1939 Data Link Source Address Information
J1939 Data link source address information
Pico Scope CCOS (Crankcase Separator Test)
PicoScope Test One Channel RCT
PicoScope Test Resistance and Ohmmeter
PicoScope Test for Datalink (CAN) Health Shorts & opens
Driveline Information Center and Troubleshooting Procedures
Cleaning and Disinfecting Trucks and Buses
J1939 Data Link Troubleshooting
NEW Ultrasonic DEF Tank Sending Unit; only models with SCR Aftertreatment system.
RADIATOR INTERNAL RESTRICTION AND FLUSH PROCEDURE
Engine
10 bulletinsEngine replacements for all International engines will need to follow this procedure.
In some geographic areas, ambient temperatures reaching below 15F (-10 C), including high levels of humidity, an...
Read full bulletin
operator may experience engine stalling, low performance, and or poor aftertreatment performance. This is caused by condensation accumulating and freezing within the Charge Air Cooler (CAC); affecting air flow into the engine. This article lists all the currently available winter front covers that can be installed on the front grille and bumper to reduce cold air flow to the engine compartment.
Title: Vehicle Programming Information for Engine: Single Box 1998-2004 I6 & V8 Applies To: Single Box 1998-2004 I6 & V8
Title: How to Request a Horsepower Quote Applies To: All International and Cummins Electronic engines
How to request a horsepower quote; all International and Cummins engines
Starter diagnostics and warranty claim procedure for all engines and all chassis EXCLUDING vehicles equipped with PSI...
Read full bulletin
engines or Cummins ISB engine with Allison transmissions
Engine Oil Capacities.
Read full bulletin
All International electronic engines 1994 to present and Cummins ISB, ISM, or ISX engines
Oil Capacities; All Electronic International Engines 1994 - Present.
Read full bulletin
Cummins ISB, ISM & ISX
Engine Oil Capacities All Electronic International Engines 1994 - Present.
Read full bulletin
Cummins ISB, ISM & ISX
Urea Quality Sensor (UQS) Supplemental Diagnostic and Service Information; only models with SCR Aftertreatment system...
Read full bulletin
and N9, N10, N13, A26 or Cummins ISB, ISL, ISX engines built from January 2016
Electrical
5 bulletinsPicoScope Test - Battery Loss of Charge - Parasitic Draw Test
General wheel speed sensor troubleshooting
Codes 141, 142, and 621 in a 2-box ECM/IDM; only models with 2-box ECM/IDM from 2003-2007
Sound Off Bus Monitor Lamps Not Illuminating While Circuits and Exterior Lights are Operating and Test Good
HVAC fault 2609-19 with 4th Gen BCM; Only models equipped with 4th generation BCM
Transmission
3 bulletinsTitle: Steering Gear Seal Repair Guidelines Applies To: Steering gears
Power Steering Diagnostics Flow / Pressure Specifications For Power Steering Gears and Power Steering Pumps
This article is for adding additional protection to the driver's area of the bus to help mitigate the transmission of...
Read full bulletin
germs.
Body & Paint
3 bulletinsThis article addresses chassis lean conditions on all chassis.
Read full bulletin
This does not include any diagnostics for body leans such as a cab lean. Keep in mind that a chassis lean may cause or accentuate a cab lean. Filling out the printable form and using the notes in blue will help you to determine the source of the lean and identify the action and parts required to correct the lean.
Aftertreatment Clamp Corrosion; Single Can Aftertreatment Systems
Bus Body Entry Door Switch, LH Panel Mounted
Infotainment
2 bulletinsThis tool is designed to compare Diamond Logic feature data across multiple vehicle configuration files.
Read full bulletin
It allows users to quickly load files either manually or directly from the Diamond Logic Builder Vehicles folder using VIN-based selection. As files are added or removed, the comparison runs automatically with no manual action required. The program presents results in an interactive table that shows feature codes, descriptions, access levels, and whether each feature is present in each selected file. Built-in search, filtering, and sorting make it easy to locate specific features or focus only on differences between files. Column visibility can be customized to show or hide descriptions and access information as needed. Users can remove files individually or clear all files at once, with results updating instantly. The tool also includes reporting and export options that reflect exactly what is visible on screen, allowing results to be printed, copied, saved as text, or exported to CSV for use in Excel or other spreadsheet tools. Overall, the program streamlines the process of comparing vehicle feature configurations, helping users quickly identify differences, validate setups, and document results without manual comparison or external tools.
Radio Diagnostics and Information
HVAC & Climate
2 bulletinsTitle: A/C Refrigerant and Oil Capacities Applies To: All current models
Title: Factory Installed Air Conditioning, EC4.0 System BE, CE, FE, RE Bus Models
Lighting
2 bulletinsRepair Procedures for Vehicles Struck by Lightning
Bus Strobe Light Replacements
Brakes
1 bulletinThis document will guide the user through a step-by-step procedure for detecting water leaks in vehicle cabs and...
Read full bulletin
windshields using an ultrasonic sound detector.
Pre-Delivery & Maintenance
1 bulletinTitle: Service Portal iKNow Feedback Case Types Applies To: All
Tires & Wheels
1 bulletinSuggested alignment target values when performing a vehicle axle alignment.
Suspension
1 bulletinSuspension Lean Diagnostics; All models