2025 Ic Bus Evsb TSBs
40 Technical Service Bulletins across 12 categories
Categories
Electrical
10 bulletinsThis document will guide the user through diagnosing a failed high-voltage battery when there is a suspected concern...
Read full bulletin
indicated by symptom or fault code.
Certain International trucks and IC BusTM CE Series buses may have out of date BCM programing that may cause erroneous...
Read full bulletin
fault codes after a vehicle sits for 2 or 3 days.
Certain IC BusTM Electric CE Series buses may have incorrect suction and discharge pressure sensors.
Certain International trucks and IC BusTM CE Series buses may have out of date BCM programing that may cause erroneous...
Read full bulletin
fault codes after a vehicle sits for 2 or 3 days.
This document will walk the user through correcting the battery State of Charge (SOC) calibration.
Read full bulletin
It has been found on some electric vehicles that the SOC calibration can become incorrect over time. Often times this is from the vehicle sitting a long period without use or charging the batteries. This will result in the SOC value on the cluster becoming inaccurate compared to the SOC value in the battery packs. This may also result in a low value for the vehicle range estimate on the EGC.
This document will guide the user through determining why the vehicle is not able to enable the high voltage system or...
Read full bulletin
enter Drive Ready mode.
This document will guide the user through the TPIM HV ( High Voltage ) DC Cable installation with proper shielding...
Read full bulletin
position.
Title: eCE EV Bus Sealed Relay Kit
Certain IC Bus Electric CE Series buses may have the front and rear A/C evaporator temperature sensor harness routed...
Read full bulletin
incorrectly.
DEFECT DESCRIPTION: Certain IC Bus Electric CE Series buses may have an A/C Relay Board that was incorrectly assembled.
Software & Calibration
6 bulletinsIC Bus Electric CE Series and International eMV Series VCU calibration release information
IC Bus Electric CE Series and International eMV Series VCU calibration release information
IC Bus Electric CE Series and International eMV Series VCU calibration release information
IC Bus Electric CE Series and International eMV Series VCU calibration release information:
Certain IC Bus Electric CE Series school buses may need to have the VCU calibrated to the latest calibration.
IC Bus Electric CE Series and International eMV Series VCU calibration release information
Engine
6 bulletinsThis document provides guidance for assessing the feasibility of implementing a customer-requested change to an engine or vehicle parameter/feature.
Read full bulletin
Customer requested changes will be approved in accordance with the requirements specified in 40 CFR Part 1037 to ensure continued compliance with greenhouse gas (GHG) regulations.
New CARB Idle Reduction Change Request
Engine replacements for all International engines will need to follow this procedure.
In some geographic areas, ambient temperatures reaching below 40F (4C), including high levels of humidity, an operator...
Read full bulletin
may experience engine stalling, low performance, and/or poor aftertreatment performance. This is caused by condensation accumulating and freezing within the Charge Air Cooler (CAC); affecting air flow into the engine. This article lists currently available winter front covers that can be installed on the front grille and bumper to reduce cold air flow to the engine compartment.
In some geographic areas, ambient temperatures reaching below 15F (-10 C), including high levels of humidity, an...
Read full bulletin
operator may experience engine stalling, low performance, and or poor aftertreatment performance. This is caused by condensation accumulating and freezing within the Charge Air Cooler (CAC); affecting air flow into the engine. This article lists all the currently available winter front covers that can be installed on the front grille and bumper to reduce cold air flow to the engine compartment.
Title: How to Request a Horsepower Quote Applies To: All International and Cummins Electronic engines
HVAC & Climate
4 bulletinsHVAC control may experience shut off cycles during operation.
This document will guide the user through information required to know before servicing air conditioning systems on an...
Read full bulletin
electric vehicle
Title: Air Conditioning Software Versions Applies To: IC Bus Electric CE Series
Title: A/C Refrigerant and Oil Capacities Applies To: All current models
Body & Paint
4 bulletinsCertain 2025 thru 2027 IC Bus CE Series school buses and IC Bus Electric CE Series school buses entrance doors may fall...
Read full bulletin
out of adjustment over time and with use. A door that is not adjusted properly may result in an improperly closed door and trigger an open door warning light on the dashboard.
This document will guide the user through adding a water deflector above the exterior entrance door switch for all Next...
Read full bulletin
Gen Buses MY2024 through MY2026
Title: Next Gen Bus Air Entrance Door Exterior Switch
This article addresses chassis lean conditions on all chassis.
Read full bulletin
This does not include any diagnostics for body leans such as a cab lean. Keep in mind that a chassis lean may cause or accentuate a cab lean. Filling out the printable form and using the notes in blue will help you to determine the source of the lean and identify the action and parts required to correct the lean.
Other
4 bulletinsIC Bus Operator's Manuals
This document will guide the user through understanding Prop Shaft Codes and understanding the variations of prop codes.
Read full bulletin
(Metric Prop codes start with the number a 4 and Non metric Prop codes start with a 2.)
Title: Driveline Information Center and Troubleshooting Procedures Applies To: All Vehicles
Title: Fan belt replacement guidelines for frayed edges Applies To: All Models
Infotainment
1 bulletinThis tool is designed to compare Diamond Logic feature data across multiple vehicle configuration files.
Read full bulletin
It allows users to quickly load files either manually or directly from the Diamond Logic Builder Vehicles folder using VIN-based selection. As files are added or removed, the comparison runs automatically with no manual action required. The program presents results in an interactive table that shows feature codes, descriptions, access levels, and whether each feature is present in each selected file. Built-in search, filtering, and sorting make it easy to locate specific features or focus only on differences between files. Column visibility can be customized to show or hide descriptions and access information as needed. Users can remove files individually or clear all files at once, with results updating instantly. The tool also includes reporting and export options that reflect exactly what is visible on screen, allowing results to be printed, copied, saved as text, or exported to CSV for use in Excel or other spreadsheet tools. Overall, the program streamlines the process of comparing vehicle feature configurations, helping users quickly identify differences, validate setups, and document results without manual comparison or external tools.
Brakes
1 bulletinThis document will guide the user through a step-by-step procedure for detecting water leaks in vehicle cabs and...
Read full bulletin
windshields using an ultrasonic sound detector.
Pre-Delivery & Maintenance
1 bulletinTitle: Service Portal iKNow Feedback Case Types Applies To: All
Suspension
1 bulletinTitle : Correct Driveline Angles and Their Relationship with the Truck Suspension Applies To : all truck & bus...
Read full bulletin
(including BEV / EV)
Transmission
1 bulletinTitle: Steering Gear Seal Repair Guidelines Applies To: Steering gears
Hybrid & EV
1 bulletinTitle: Electric Vehicle State of Charge Calibration Applies To: All Electric Vehicles