2023 Ic Bus Cesb TSBs
88 Technical Service Bulletins across 13 categories
Categories
Other
21 bulletinsIC Bus Operator's Manuals
This document will guide the user through understanding Prop Shaft Codes and understanding the variations of prop codes.
Read full bulletin
(Metric Prop codes start with the number a 4 and Non metric Prop codes start with a 2.)
Title: Driveline Vibration w/SPL170 Applies To: 2021 - 2025 International IC Bus Electric CE Series
Title: Driveline Information Center and Troubleshooting Procedures Applies To: All Vehicles
Title: Fan belt replacement guidelines for frayed edges Applies To: All Models
Title: 6090/6091 Connector Damage Applies To: IC Bus Electric CE Series, International eMV Series
Applies To: Units built 12/20/2022 - 11/11/2024 On the following models with Feature Codes: CE Bus- 0510234 LT RH-...
Read full bulletin
001MBS & 0510234 LT RH- 008TRR or 0510234 & 001LRM or 001LRV or 001LRN or 001LRL
J1939 Data Link Source Address Information
Diagnosis of chassis wander complaints.
Luggage rack upholstery repair; only busses equipped with luggage rack.
J1939 Data Link Source Address Information
J1939 Data Link Troubleshooting
Telematics installation guidelines - Only units with 500K data link
J1939 Data link source address information
Pico Scope CCOS (Crankcase Separator Test)
PicoScope Test One Channel RCT
PicoScope Test Resistance and Ohmmeter
PicoScope Test for Datalink (CAN) Health Shorts & opens
Certain 2022 and 2023 CE and RE school buses built with feature code 0008TXK or 0008TXM (Bendix Wingman Prewire option)...
Read full bulletin
may have been built without the warning label to notify the driver that the collision mitigation system is not operational, as
J1939 Data Link Source Address Information
Greenhouse Gas Phase 2 Regulatory Compliance Implementation
Engine
19 bulletinsThe purpose of this article is to provide updated repair guidelines for the engine oil pan leak on all 8.8L gasoline and LPG engines.
Read full bulletin
Engine oil can leak from the rear of the engine oil pan due to an excessive gap in the sealing area between the engine oil pan and the engine block.
The purpose of this article is to provide updated repair guidelines for the engine oil pan leak on all 8.8L gasoline and LPG engines.
Read full bulletin
Engine oil can leak from the rear of the engine oil pan due to an excessive gap in the sealing area between the engine oil pan and the engine block.
This document provides guidance for assessing the feasibility of implementing a customer-requested change to an engine or vehicle parameter/feature.
Read full bulletin
Customer requested changes will be approved in accordance with the requirements specified in 40 CFR Part 1037 to ensure continued compliance with greenhouse gas (GHG) regulations.
This document provides guidance for assessing the feasibility of implementing a customer-requested change to an engine or vehicle parameter/feature.
Read full bulletin
Customer requested changes will be approved in accordance with the requirements specified in 40 CFR Part 1037 to ensure continued compliance with greenhouse gas (GHG) regulations.
New CARB Idle Reduction Change Request
Engine replacements for all International engines will need to follow this procedure.
In some geographic areas, ambient temperatures reaching below 40F (4C), including high levels of humidity, an operator...
Read full bulletin
may experience engine stalling, low performance, and/or poor aftertreatment performance. This is caused by condensation accumulating and freezing within the Charge Air Cooler (CAC); affecting air flow into the engine. This article lists currently available winter front covers that can be installed on the front grille and bumper to reduce cold air flow to the engine compartment.
In some geographic areas, ambient temperatures reaching below 15F (-10 C), including high levels of humidity, an...
Read full bulletin
operator may experience engine stalling, low performance, and or poor aftertreatment performance. This is caused by condensation accumulating and freezing within the Charge Air Cooler (CAC); affecting air flow into the engine. This article lists all the currently available winter front covers that can be installed on the front grille and bumper to reduce cold air flow to the engine compartment.
Title: How to Request a Horsepower Quote Applies To: All International and Cummins Electronic engines
This document will guide a user to replace and reroute Charge Air Cooler (CAC) for vehicles built with the Cummins ISB...
Read full bulletin
and B6.7 engines.
How to request a horsepower quote; all International and Cummins engines
CE Bus Engine Cover Sealing
Per agreement with EPA and CARB, Cummins, Inc.
Read full bulletin
provided an emergency calibration for Cummins ISB, B6.7, ISL9, L9, and X15 engines when a DEF Quality Sensor (DQS) was not available. This action addressed the Diesel Exhaust Fluid (DEF) Quality Sensor failures in the field and the unavailability of parts due to the worldwide chip shortage. This recall is step two of this program designed to revert all affected vehicles back to the certified calibration and to provide them with the latest improved DQS and Coolant Control Valve (CCV) designs. Additionally, the emergency calibration and the restoration to the certified calibration with the latest improved DQS and Coolant Control Valve (CCV) designs have no effect on vehicle Emissions.
Cummins Programming guide and fault codes285 & 265; only vehicles built with Cummins B6.7, X15, or L9 engines
Starter diagnostics and warranty claim procedure for all engines and all chassis EXCLUDING vehicles equipped with PSI...
Read full bulletin
engines or Cummins ISB engine with Allison transmissions
QLS Emergency ECM Calibration; only models equipped with Cummins B6.7, X15, L9, or International A26 engines
QLS Emergency Calibration.
Read full bulletin
applies to 2016 and newer Cummins B6.6, X15, and L9 engines and all A26 engines
In cold weather, especially during engine warmup, the engine may experience a misfire condition resulting in setting the...
Read full bulletin
Malfunction Indicator Lamp (MIL) and possible increase in emissions. Only models with Generation II PSI 8.8L LP engines.
With the vehicle in motion, the engine control module (ECM) may set a fault code resulting in engine shut down without...
Read full bulletin
warning; Only models built with PSI gasoline or LPG engines
Electrical
11 bulletinsThis document will guide the user through installing 12V disconnect label to the battery door.
Certain International trucks and IC BusTM CE Series buses may have out of date BCM programing that may cause erroneous...
Read full bulletin
fault codes after a vehicle sits for 2 or 3 days.
Certain International trucks and IC BusTM CE Series buses may have out of date BCM programing that may cause erroneous...
Read full bulletin
fault codes after a vehicle sits for 2 or 3 days.
This document will guide the user through inspecting the air conditoning cube fuse at the low-voltage (LV) battery for the correct amperage rating.
Read full bulletin
It has been found, that certain Electric CE Series Buses had a 75A rating cube fuse installed vs the correct 150A rating needed.
Title: Next Gen CE Bus Starter Interlock Dash Chime Applies To: Next Gen CE Bus with starter interlock feature built...
Read full bulletin
prior to 2/19/25
This document details the procedure that must be followed to ensure proper alternator troubleshooting.
This document covers battery diagnostics, maintenance and storage requirement.
Cummins B6.7 Grid Heater Relay
General Wheel Speed Sensor Troubleshooting
PicoScope Test - Battery Loss of Charge - Parasitic Draw Test
Certain Electric CE buses may have been built without the proper high voltage Identification labels
Body & Paint
7 bulletinsEntrance door set screw may loosen over time and with use.
Entrance door set screw may loosen over time and with use.
This document will guide the user through repairing a Next Gen CE Bus Driver's Window with loose, displaced, or falling-out upper or lower seals.
Read full bulletin
See symptoms below for an example of the issue.
This document provides guidance for troubleshooting issues with the entrance door.
This article addresses chassis lean conditions on all chassis.
Read full bulletin
This does not include any diagnostics for body leans such as a cab lean. Keep in mind that a chassis lean may cause or accentuate a cab lean. Filling out the printable form and using the notes in blue will help you to determine the source of the lean and identify the action and parts required to correct the lean.
These certain buses may have roof water leaks resulting from incorrect assembly described in Roof Joint Recalls 23501...
Read full bulletin
and 23502.
Bus roof leaks
Hybrid & EV
5 bulletinsTitle: Electric Vehicle Air Dryer Operation
Electric vehicle charging concerns; electric vehicles only
Electric vehicle charging concerns
Electric vehicle enters no torque mode
Electric Vehicle Electric Heat Operation
HVAC & Climate
5 bulletinsTitle: A/C Refrigerant and Oil Capacities Applies To: All current models
Title: Servicing Air Conditioning Systems on Electric Vehicles
Title: Factory Installed Air Conditioning, EC4.0 System BE, CE, FE, RE Bus Models
These certain buses may have a rear A/C system compressor mounting bracket with insufficient clearance between the...
Read full bulletin
compressor and bracket that could result in rear A/C compressor lock up.
Air Compressor Inlet Hose Chaffing / Leaking
Fuel System
4 bulletinsThis document provides guidance for troubleshooting issues with the entrance door of the Next Gen CE Bus.
Read full bulletin
While the primary focus is on achieving a properly adjusted latching entrance door, it also includes additional helpful tips. Please note that this document is not exhaustive and only addresses some common issues and their resolutions. For more detailed information, refer to Service Manual 0001283373. Also, please check the Service Portal for any open field campaigns for door improvements, such as AFC 26901 for a larger set screw. If this article or the Service Manual does not cover the topic, please create a case file for more specific assistance.
This document is for Diesel buses MY2020, MY2021, MY2022, MY2023, and MY2024 specifically built between 11/30/20 and...
Read full bulletin
5/18/23 that are experiencing fuel leaks at the fuel tank cap for not being seated fully, and for MY2024 and MY2025 buses built between 1/2/24 and 9/19/25 for fuel necks being loose.
This document will instruct the user on installing and programming a fuel water separator heater system for a Next Gen...
Read full bulletin
Bus built without the heater option.
Bus Diesel fuel Cap Leaks; only models built 11/30/2020 through 05/18/2023
Transmission
4 bulletinsTitle: Steering Gear Seal Repair Guidelines Applies To: Steering gears
The steering gears may have been assembled with less than the required input shaft ball bearings and can result in a...
Read full bulletin
fracture of the input shaft and loss of steering.
As reported by R. H. Sheppard Co., Inc in their defect report to NHTSA (Recall 22E-047), an anomaly in the steering gear...
Read full bulletin
recirculating ball insertion operation occurred during assembly. Subsequent rework processes and inspections did not detect the missing recirculating balls.
Power Steering Diagnostics Flow / Pressure Specifications For Power Steering Gears and Power Steering Pumps
Infotainment
3 bulletinsThis tool is designed to compare Diamond Logic feature data across multiple vehicle configuration files.
Read full bulletin
It allows users to quickly load files either manually or directly from the Diamond Logic Builder Vehicles folder using VIN-based selection. As files are added or removed, the comparison runs automatically with no manual action required. The program presents results in an interactive table that shows feature codes, descriptions, access levels, and whether each feature is present in each selected file. Built-in search, filtering, and sorting make it easy to locate specific features or focus only on differences between files. Column visibility can be customized to show or hide descriptions and access information as needed. Users can remove files individually or clear all files at once, with results updating instantly. The tool also includes reporting and export options that reflect exactly what is visible on screen, allowing results to be printed, copied, saved as text, or exported to CSV for use in Excel or other spreadsheet tools. Overall, the program streamlines the process of comparing vehicle feature configurations, helping users quickly identify differences, validate setups, and document results without manual comparison or external tools.
Title: Radio Clock is Freezing Applies To: Next Gen CE Bus
Certain buses may have outdated radio software that could interfere with the operation of the Public Address (PA)...
Read full bulletin
external speakers.
Brakes
3 bulletinsThis document will guide the user through a step-by-step procedure for detecting water leaks in vehicle cabs and...
Read full bulletin
windshields using an ultrasonic sound detector.
This document is to guide users to eliminate brake pedal rattle noise.
The rear axle brake chambers may be installed in the incorrect mounting slot which could lead to long term durability...
Read full bulletin
issues.
Pre-Delivery & Maintenance
3 bulletinsTitle: Service Portal iKNow Feedback Case Types Applies To: All
Bus seat back foam inspection guidelines
Webasto Thermo Pro 90 Service and Repair Manual; Only CE bus with feature code 0049JAN or 0049JAP
Software & Calibration
2 bulletins3/25/2025 - Updated service part numbers and addressed typos
QLS Emergency Calibration Revert Process
Steering
1 bulletinThe steering wheel retaining nut may not have been torqued properly during assembly and may allow the steering wheel to...
Read full bulletin
loosen, and possibly separate from the steering column shaft.