2022 Hyundai Santa Fe Hybrid TSBs

combination lamp, daytime running lamp (DRL), or fog lamp. This TSB illustrates the various causes of condensation inside the lamp assembly. Lamp assembly replacement is NOT necessary in most cases. This condition can be eliminated by turning on the lamps with the engine running for several minutes or during normal driving operation.

experience an engine oil leak originating from the Continuous Variable Valve Duration (CVVD) Actuator Oil Seal. Follow the service procedure below to replace the CVVD Oil Seal.

or symptoms listed below, refer to the Service Procedure to diagnose the condition. DIAGNOSTIC TROUBLE CODES: P070500 - Transmission range sensor circuit malfunction P070512 - Transmission range sensor circuit malfunction P070514 - Transmission range sensor circuit malfunction P07051C - Transmission range sensor circuit malfunction P070600 - Transmission range sensor circuit range/performance P070661 - Transmission range sensor circuit range/performance P070696 - Transmission range sensor circuit range/performance SYMPTOMS: Malfunction Indicator Light (MIL) illuminated 5th gear fail-safe Intermittently wont shift into D or R Intermittently wont shift out of Park Intermittent ly no engine cr ank/n o start in P or N with or without MIL or DTC.

Hybrid (TM PHEV) and Santa Fe Hybrid (TM HEV) vehicles to improve the following DTC and symptoms:

that the engine cannot run due to poor immobilizer function (although driving with electric motor is possible) HCU function setting error

combination lamp, daytime running lamp (DRL), or fog lamp. This TSB illustrates the various causes of condensation inside the lamp assembly. Lamp assembly replacement is NOT necessary in most cases. This condition can be eliminated by turning on the lamps with the engine running for several minutes or during normal driving operation.

the Service Procedure and replace the valve body internal harness and the input/output speed sensor.

load carrying capacity information indicated on tire placards when vehicle weight has been increased before retail sale. This limit is the lesser of 1.5% of GVWR or 100 pounds. If the total added weight exceeds the lesser of the limit, a label must be added to the driver-side B-pillar within 25mm (1 inch) of the original tire placard.

system accordingly during engine short block or sub-assembly replacement.

the Service Procedure and replace the related solenoid and harness.

HEV) / Santa Fe Plug-In Hybrid (TM PHEV) and Tucson Hybrid (NX4 HEV) / Tucson Plug-In Hybrid (NX4 PHEV) vehicles to revise the following DTC logic: P1441(PCSV rear and hose missing) P1A77(HSG Belt slip) P00B7(Excessive ITM motor operating current) P2118 (ETC target position failure) P0401 (EGR gas flow insufficient) P0236 (Turbocharger boost sensor range abnormal) P0299 (Turbocharger boost pressure too low)

the Service Procedure and replace the harness with an integrated oil temperature sensor.

The changes may vary depending on vehicle type, model, and navigation system as described in this TSB.

system.

The changes may vary depending on vehicle type, model, and navigation system. Refer to the 2024 2nd Navigation Map and Software Update Improvements section in this TSB for a list of specific changes. The software can be downloaded via Navigation Updater (NAU) and updated by USB. The NAU website is https://update.hyundai.com/US/EN/navigationUpdate. For certain models equipped with a relevant Bluelink package, the software may be downloaded and applied via OTA update.

system.

system.

system.

the under hood blue coolant reservoir is found to be at normal level (not below MIN marking on the reservoir bottle). This may be caused by poor flow of antifreeze inside the low-conductivity coolant pipe from internal debris, resulting in unusual high EWP operation being detected. Follow the procedure outlined in this bulletin to flush/discharge debris from the cooling system and replace the blue coolant. To effectively resolve, the flushing must be performed section by section as instructed. After flushing of the cooling system is done, updated BSC-2 coolant will be installed.

Hyundai is extending the warranty coverage for the horn replacement under this condition to 10 years or 120,000 miles from the date of original retail delivery or date of first use (whichever occurs first) and is valid for original and subsequent owners. If a horn needs to be replaced, follow the instructions within this Technical Service Bulletin (TSB) 26-BE-001H-1 to install the latest design. Please note that any vehicles under 10 years/120,000 miles are covered by this TSB, even if vehicle is with original warranty of 5 years/60,000 miles.

Hyundai is extending the warranty coverage for the horn replacement under this condition to 10 years or 120,000 miles from the date of original retail delivery or date of first use (whichever occurs first) and is valid for original and subsequent owners. If a horn needs to be replaced, follow the instructions within this TSB to install the latest design. Please note that any vehicles under 10 years/120,000 miles are covered by this TSB, even if vehicle is within original warranty of 5 years/60,000 miles.

Hyundai is extending the warranty coverage for the horn replacement under this condition to 10 years or 120,000 miles from the date of original retail delivery or date of first use (whichever occurs first) and is valid for original and subsequent owners. If a horn needs to be replaced, follow the instructions within Technical Service Bulletin (TSB) to install the latest design. Please note that any vehicles under 10 years/120,000 miles are covered by this TSB, even if vehicle is within original warranty of 5 years/60,000 miles.

This may be due to an irregular disconnection on Verizons communication network. Follow the procedure in this TSB to reestablish the connection via the AVN pinhole reset method.

This may be due to an irregular disconnection on Verizon's communication network. If you are experiencing issues with remote commands, or other Bluelink services, please see the instructions below to reestablish the connection via the AVN pinhole reset method.

This may be due to an irregular disconnection on Verizons communication network. Follow the procedure in this TSB to reestablish the connection via the AVN pinhole reset method.

(transmission clutch slip in gear above limit) listed on Page 2.

If replacement of the SBW button is required due to one or more button plating peeling, replace the button(s) with a new one. Do not replace the complete SBW lever.

The current version of Google Maps has 10 times the data transmission compared to the previous version. As a countermeasure, an update with a frame skip logic has been added to resolve the data congestion with Google Maps.

or symptoms listed below, refer to the Service Procedure to diagnose the condition.

If you are servicing a vehicle with any symptoms or DTC listed below, follow the Service Procedure, Page 2.

panels: hood, fender(s), roof, door(s), quarter panel(s), and tailgate/trunk. This warranty extension only applies to factory-applied paint and does not cover collision-related paint repairs or vehicles with a salvaged title. Hyundai is extending the warranty coverage for certain white paint colors under these conditions from 3 years and 36,000 miles, to 10 years and unlimited miles from the date of original retail delivery or date of first use, and is valid for original and subsequent owners.

Santa Fe Sport, 2019 model year Santa Fe, 2021 2023 model year Santa Fe Hybrid, and 2020 2023 model year Palisade vehicles may exhibit excessive paint peeling or bubbling of the primer/paint film on the exterior metal body panels: hood, fender(s), roof, door(s), quarter panel(s), and tailgate/trunk. This warranty extension only applies to factory-applied paint and does not cover collision-related paint repairs or vehicles with a salvaged title. Hyundai is extending the warranty coverage for certain white paint colors under these conditions from 3 years and 36,000 miles, to 10 years with unlimited miles from the date of original retail delivery or date of first use, and is valid for original and subsequent owners.

hood, fender(s), roof, door(s), quarter panel(s), and tailgate/trunk. The paint warranty coverage for affected vehicles has been extended to 10 years/unlimited miles from the date of original retail delivery or date of first use, and is valid for original and subsequent owners. The warranty extension does NOT apply to any vehicle that has ever been declared a total loss or sold for salvage by a financial institution or insurer, or has a branded or similar title under any states law.

fender(s), roof, door(s), quarter panel(s), and tailgate/trunk. The paint warranty coverage for affected vehicles has been extended to 10 years/unlimited miles from the date of original retail delivery or date of first use, and is valid for original and subsequent owners. The warranty extension does NOT apply to any vehicle that has been previously declared a total loss, and/or sold for salvage by a financial institution or insurer, and/or has a branded or similar title under any states law.

It provides a barrier between the paint and contaminants, such as rail dust, acid rain, and industrial fallout. In rare cases, the paint can become clouded under the PPF. These spots are the result of moisture trapped between the PPF and the paint.

which may be accompanied by a warning message (e.g., Coolant Supplement, Refill Inverter Coolant) in the cluster. No related DTCs are stored, and coolant level is normal in the reservoir tank. The coolant flow may be restricted by debris, causing abnormally high Electric Water Pump (EWP) speed. This TSB contains instructions for confirming high RPMs in the EWP, then using the Coolant Flushing Equipment Set to flush and clean debris from the various cooling system circuits. The existing blue coolant, Electric Vehicle Battery System Coolant (BSC-2), will be used to flush the system. Then the coolant will be replaced with new pink coolant (LLC-10).

following problem: Refill Inverter Coolant warning light displayed on the cluster No DTCs present Normal level of coolant in Inverter Reservoir Tank Measured EWP Speed > 2,800 RPM The cause of the warning light is due to increased EWP Speed due to poor flow of coolant inside the cooling circuit. The coolant in the system will be discharged and any foreign substances in the circuit will be flushed out with new coolant added in the end. A new reservoir cap label will be added.

following problem: Refill Inverter Coolant warning light displayed on the cluster No DTCs present Normal level of coolant in Inverter Reservoir Tank Measured EWP Speed > 2,800 RPM The cause of the warning light is due to increased EWP Speed due to poor flow of coolant inside the cooling circuit. The coolant in the system will be discharged and any foreign substances in the circuit will be flushed out with new coolant added in the end. A new reservoir cap label will be added.

caused by foreign substances causing internal parts to oxidize. Hyundai is extending the warranty coverage for the horn replacement under this condition to 10 years or 120,000 miles from the date of original retail delivery or date of first use (whichever occurs first) and is valid for original and subsequent owners. If a horn needs to be replaced, follow the instructions within this TSB to install the latest design. Please note that any vehicles under 10 years/120,000 miles are covered by this TSB, even if vehicle is within original warranty of 5 years/60,000 miles.

caused by foreign substances causing internal parts to oxidize. Hyundai is extending the warranty coverage for the horn replacement under this condition to 10 years or 120,000 miles from the date of original retail delivery or date of first use (whichever occurs first) and is valid for original and subsequent owners. If a horn needs to be replaced, follow the instructions within this TSB to install the latest design.

If the protective cover is not removed correctly, there is a possibility of the rubber insert and rail spring becoming partially separated on the inner side of the wiper blade, which could lead to poor wiping performance and/or possible scratching of the windshield glass. Follow the procedure in this bulletin to properly remove the windshield wiper blade protective cover on all new wiper blades.

This bulletin describes the procedure to inspect the brakes, resurface or replace and perform a brake burnishing procedure.

correct information regarding the coolant used in the cooling system.

steering left vs right on some Palisade (LX2), Santa Fe Hybrid (TM HEV), and Santa Fe Plug-In Hybrid (TM PHEV) vehicles.

and newer Santa Fe (TMA), 2021MY and newer Santa Fe Hybrid (TM HEV), 2022MY and newer Santa Fe Plug-In Hybrid (TM PHEV), and 2019MY and newer Palisade (LX2) vehicles equipped with surround view monitoring (SVM) system.