2009 Hyundai Genesis TSBs

combination lamp, daytime running lamp (DRL), or fog lamp. This TSB illustrates the various causes of condensation inside the lamp assembly. Lamp assembly replacement is NOT necessary in most cases. This condition can be eliminated by turning on the lamps with the engine running for several minutes or during normal driving operation.

Poor fuel quality may lead to cold engine startability issues, hesitation at idle or during acceleration, and/or poor driveability. In addition, prolonged vehicle operation with poor quality fuel may result in damage to the fuel system and formation of engine deposits. The BG Fuel Test Kit can be used to determine the following aspects of the fuel: Sediment / Water Contamination Inspection Specific Gravity Alcohol Content

combination lamp, daytime running lamp (DRL), or fog lamp. This TSB illustrates the various causes of condensation inside the lamp assembly. Lamp assembly replacement is NOT necessary in most cases. This condition can be eliminated by turning on the lamps with the engine running for several minutes or during normal driving operation.

capacity information indicated on tire placards when the vehicle weight has been increased before retail sale. This limit is the lesser of 1.5% of the Gross Vehicle Weight Rating or 100 pounds. If the total added weight exceeds the lesser of the limit, a label (See Figure 1) must be added to the driver-side B-pillar within 25mm (1 inch) of the original tire placard. NOTE: Effective immediately, all ports will stop the installation of the Load Capacity Label when there are no port accessories installed.

load carrying capacity information indicated on tire placards when vehicle weight has been increased before retail sale. This limit is the lesser of 1.5% of GVWR or 100 pounds. If the total added weight exceeds the lesser of the limit, a label must be added to the driver-side B-pillar within 25mm (1 inch) of the original tire placard.

system accordingly during engine short block or sub-assembly replacement.

revision to indicate DOT 4 brake fluid only. This bulletin describes the procedure to replace the master cylinder reservoir cap and apply a sticker to the owners manual with the revised brake fluid specification.

Perform the procedure outlined in this bulletin to fulfill the Bearing Clearance Test inspection requirements to determine next required steps.

combination lamp, daytime running lamp (DRL), or fog lamp. The TSB illustrates the various causes of condensation inside the lamp assembly. Lamp assembly replacement is NOT necessary in most cases. This condition can be eliminated by turning on the lamps with the engine running for several minutes, or during normal driving operation.

Engine Control Module (ECM) or Powertrain Control Module (PCM). Once the VIN has been programmed to the ECM/PCM, it cannot be removed or overwritten.

belt assemblies on 2009-14 Model Year Genesis sedan and 2011-16 Equus vehicles. Service Campaign T2R provides a service procedure to install warning labels on the front seat belt assemblies.

YEARS FROM THE DATE OF ORIGINAL DELIVERY OR THE DATE OF FIRST USE, OR 100,000 MILES, WHICHEVER OCCURS FIRST. THE WINDSHIELD WIPER MOTOR MAY EITHER FUNCTION INTERMITTENTLY OR STOP FUNCTIONING."

THERE IS A MALFUNCTION LIGHT LIT WITH TROUBLE CODES FOR A MISFIRE OR EVAPORATION SYSTEM LEAK. *RM

SOME 2.7L, 3.3L OR 3.8L ENGINES IN MODELS IDENTIFIED IN THE APPLICABILITY LIST MAY EXPERIENCE ONE OR MORE OF THE CONDITIONS LISTED. *PE

recommended safe chemical products.

chemical products.

Compliance with this bulletin ensures that the GDS data files are correctly transferred and matched with a Techline Case number.

Equus (VI) vehicles for repairs and replacement has been extended to 15 years with unlimited miles from the date of original retail delivery or date of first use and is valid for original and subsequent owners.

for repairs and replacement has been extended to 15 years with unlimited miles from the date of original retail delivery or date of first use, and is valid for original and subsequent owners.

for repairs and replacement has been extended to 15 years with unlimited miles from the date of original retail delivery or date of first use, and is valid for original and subsequent owners.

State of Charge (SOC) at or below 50%. A 30 Day alert - vehicle has not started and reported an SOC in 30 days.

from the following vehicles by using two magnetic wave radar sensors attached in the rear bumper. The BSD/BCW detects vehicles within the blind spot zone and gives off an alarm (visual and audible). The two magnetic radar sensors provide these functions for BSD/BCW: ? Senses other vehicles in the BSD/BCW zone and turns on the BSD/BCW warning lamp for the driver. The warning lamp starts blinking, along with an audible sound, when the driver turns on the turn signal lamp to enter the lane where another vehicle is driving.

MODELS UP TO 2013 GENESIS. *PE

SOME VEHICLES MAY EXPERIENCE MALFUNCTION INDICATOR LAMP ILLUMINATION FOR DTC P0456 (EVAPORATIVE EMISSION SYSTEM-VERY SMALL LEAK DETECTED). *PE

VEHICLE'S WARNING LIGHT FLASHES WITH DTC B2326 DETECTED, REPLACE THE AFLS ECU AS DESCRIBED. MODEL GENESIS. *PE

MIL ON WITH DTC P0456. SOME VEHICLES MAY EXPERIENCE A MALFUNCTION INDICATOR LAMP ILLUMINATION FOR DTC P0456 (EVAPORATIVE EMISSION SYSTEM - VERY SMALL LEAK DETECTED). *PE

PROVIDES INFORMATION ABOUT ECU REPLACEMENT PART AVAILABILITY FOR THE VEHICLE ADAPTIVE FRONT LIGHTING SYSTEM (AFLS) ECU CHANGE. NO MODEL YEARS LISTED. *PE

TO IMPROVE THE DTC P2135 THROTTLE POSITION SENSORS 1/2 VOLTAGE CORRELATION DIAGNOSTIC LOGIC ON SOME VEHICLES SOFTWARE UPDATE. *PE

(transmission clutch slip in gear above limit) listed on Page 2.

OEM (new) and remanufactured automatic transmissions:

THIS BULLETIN PROVIDES THE PROCEDURES NECESSARY TO RESET (ERASE) AND RELEARN THE PCM/TCM ADAPTIVE VALUES. AFTER THE FOLLOWING REPAIRS HAVE BEEN COMPLETED, THE PCM/TCM ADAPTIVE VALUES MUST BE RESET IN ORDER TO PROVIDE OPTIMUM SHIFT QUALITY. IF THE PROCEDURE IS NOT PERFORMED, THE TRANSMISSION MAY EXPERIENCE A SHIFT FLARE OR HARSH SHIFT. H REPLACE AUTOMATIC TRANSAXLE OR PCM/TCM H REPROGRAM OR EXCHANGE A PCM/TCM FROM ANOTHER VEHICLE"

THERE IS ALSO A HARSH SHIFT OUT OF PARK OR NO SHIFT OUT OF PARK. *RM

BULLETIN PROVIDES THE PROCEDURE FOR REPLACING THE MANUAL TRANSMISSION GEAR SHIFT KNOB. *PE

VIBRATION OR SHUDDER FROM THE AUTOMATIC TRANSMISSION DURING THE LIGHT ACCELERATION FROM 50-62MPH. *PE

MODELS 2010-2012 VI EQUUS, 2008-2012 BH GENESIS. *PE UPDATED 9/20/13. *PE

SOME VEHICLES MAY EXPERIENCE THE STOP LAMPS BLINKING ON AND OFF EVEN WHEN THE BRAKES ARE NOT APPLIED. IF THE Z01 DIODE IS SUSPECTED AS THE CAUSE OF THE STOP LAMP MALFUNCTION, THE Z01 DIODE MUST BE INSPECTED ACCORDING TO PROCEDURES. IF THERE IS NO TROUBLE WITH THE Z01 DIODE AFTER INSPECTION, CARRY OUT OTHER NECESSARY REPAIRS AND DO NOT REPLACE THE Z01 DIODE. NO MODEL YEARS LISTED. *PE

SOME VEHICLES MAY EXPERIENCE THE STOP LAMPS BLINKING ON AND OFF EVEN WHEN THE BRAKES ARE NOT APPLIED. NO MODEL YEARS LISTED. *PE

2. This bulletin presents guidelines to inspect for common Android Auto and Apple CarPlay connection conditions. 3. This bulletin provides physical differences between the USB 2.0 port and USB 3.0 port.

*PE

THE INSTALLATION PROCEDURE TO UPATE THE DIS A/V NAVIGATION SYSTEM TO THE LATEST PRODUCTION LEVEL SOFTWARE. *PE

THE S/W SOFTWARE INSTALLATION PROCEDURE TO UPDATE DIS A/V NAVIGATION SYSTEM TO THE LATEST PRODUCTION LEVEL SOFTWARE. *PE

SOME VEHICLES EQUIPPED WITH THE MID GRADE LEXICON 6 DISC AUDIO SYSTEM, MAY EXHIBIT INTERMITTENT AUDIO OUT PUT. *PE

It provides a barrier between the paint and contaminants, such as rail dust, acid rain, and industrial fallout. In rare cases, the paint can become clouded under the PPF. These spots are the result of moisture trapped between the PPF and the paint.

As a preventative measure, a cavity wax coating is applied to the internal surfaces of underbody components and an undercoating spray is applied to exterior surfaces of specified underbody components. The service campaign describes the procedure to perform this preventative service on certain 2009-2014MY Genesis Sedan (BH), 2011-2016MY Equus (VI), and 2010-2016MY Genesis Coupe (BK) vehicles.

As a preventative measure, cavity wax coating is applied to the internal surfaces of underbody components, and an undercoating spray is applied to the bottom exterior surfaces of specified underbody components. This bulletin describes the procedure to perform this preventative service on certain Genesis Sedan (BH), Equus (VI), and Genesis Coupe (BK) vehicles.

*LJ

For all wheel/tire balance claims, the Tire Balance Data Sheet must be fully completed including imbalance and Road Force Variation (RFV) data. The Data Sheet can be found at the end of this bulletin.

maximize tire life and performance.

diagnosing and conducting alignment-related repairs for all models and model years.

EFFECTIVE 6/2/08, FMVSS 110 (FMVSS 110) SETS A THRESHOLD FOR CORRECTING LOAD CAPACITY INFORMATION INDICATED ON TIRE PLACARDS WHEN VEHICLE WEIGHT HAS BEEN INCREASED BEFORE RETAIL SALE. ALL MODELS INCLUDED AFTER 6/2/08. *PE

If the protective cover is not removed correctly, there is a possibility of the rubber insert and rail spring becoming partially separated on the inner side of the wiper blade, which could lead to poor wiping performance and/or possible scratching of the windshield glass. Follow the procedure in this bulletin to properly remove the windshield wiper blade protective cover on all new wiper blades.

original retail delivery or date of first use, whichever occurs first. This warranty coverage applies to both the original and subsequent owners. Refer to the warranty and service parts information outlined in this bulletin whenever clock spring replacement is required.

THIS CAMPAIGN APPLIES TO DEALER STOCK VEHICLES ONLY. DEALERS MUST PERFORM THIS CAMPAIGN ON ALL AFFECTED VEHICLES PRIOR TO CUSTOMER RETAIL DELIVERY. *PE

During vehicle assembly, the anchor pretensioner is fastened to the front seat frame prior to being connected to the seat belt linkage. If, during vehicle repair, the connector does not fully latch when the linkage was pressed onto the connector, the seat belt can detach from the anchor pretensioner. If the seat belt linkage detaches from the anchor pretensioner in a collision, the risk of injury to the occupant is increased. This bulletin describes the procedure to install warning labels on the driver's and/or passenger's seat belt assemblies to prevent potential improper reattachment of the anchor pretensioners.

THIS TSB PROVIDES REPROGRAMMING INSTRUCTIONS FOR GDS ONLY. *PE

*KB

2009-2011 GENESIS. *RM

REPLACE THE CENTER CONSOLE ARMREST ASSEMBLY WITH THE NEWLY IMPROVED ONE. *PE UPDATED 9/3/10. *PE

*PE