2010 Hyundai Genesis Coupe TSBs

combination lamp, daytime running lamp (DRL), or fog lamp. This TSB illustrates the various causes of condensation inside the lamp assembly. Lamp assembly replacement is NOT necessary in most cases. This condition can be eliminated by turning on the lamps with the engine running for several minutes or during normal driving operation.

Poor fuel quality may lead to cold engine startability issues, hesitation at idle or during acceleration, and/or poor driveability. In addition, prolonged vehicle operation with poor quality fuel may result in damage to the fuel system and formation of engine deposits. The BG Fuel Test Kit can be used to determine the following aspects of the fuel: Sediment / Water Contamination Inspection Specific Gravity Alcohol Content

combination lamp, daytime running lamp (DRL), or fog lamp. This TSB illustrates the various causes of condensation inside the lamp assembly. Lamp assembly replacement is NOT necessary in most cases. This condition can be eliminated by turning on the lamps with the engine running for several minutes or during normal driving operation.

capacity information indicated on tire placards when the vehicle weight has been increased before retail sale. This limit is the lesser of 1.5% of the Gross Vehicle Weight Rating or 100 pounds. If the total added weight exceeds the lesser of the limit, a label (See Figure 1) must be added to the driver-side B-pillar within 25mm (1 inch) of the original tire placard. NOTE: Effective immediately, all ports will stop the installation of the Load Capacity Label when there are no port accessories installed.

load carrying capacity information indicated on tire placards when vehicle weight has been increased before retail sale. This limit is the lesser of 1.5% of GVWR or 100 pounds. If the total added weight exceeds the lesser of the limit, a label must be added to the driver-side B-pillar within 25mm (1 inch) of the original tire placard.

system accordingly during engine short block or sub-assembly replacement.

Perform the procedure outlined in this bulletin to fulfill the Bearing Clearance Test inspection requirements to determine next required steps.

combination lamp, daytime running lamp (DRL), or fog lamp. The TSB illustrates the various causes of condensation inside the lamp assembly. Lamp assembly replacement is NOT necessary in most cases. This condition can be eliminated by turning on the lamps with the engine running for several minutes, or during normal driving operation.

Engine Control Module (ECM) or Powertrain Control Module (PCM). Once the VIN has been programmed to the ECM/PCM, it cannot be removed or overwritten.

PROVIDED, DUE TO DEPOSITS FOUND AT VALVE-TO-BORE INTERFACE. MODELS 2011-2013 ELANTRA, 2010-2013 GENESIS COUPE, 2010-2013 SANTA FE, 2006-2013 SONATA, 2010-2013 TUCSON. *PE

(transmission clutch slip in gear above limit) listed on Page 2.

OEM (new) and remanufactured automatic transmissions:

THIS BULLETIN PROVIDES THE PROCEDURES NECESSARY TO RESET (ERASE) AND RELEARN THE PCM/TCM ADAPTIVE VALUES. AFTER THE FOLLOWING REPAIRS HAVE BEEN COMPLETED, THE PCM/TCM ADAPTIVE VALUES MUST BE RESET IN ORDER TO PROVIDE OPTIMUM SHIFT QUALITY. IF THE PROCEDURE IS NOT PERFORMED, THE TRANSMISSION MAY EXPERIENCE A SHIFT FLARE OR HARSH SHIFT. H REPLACE AUTOMATIC TRANSAXLE OR PCM/TCM H REPROGRAM OR EXCHANGE A PCM/TCM FROM ANOTHER VEHICLE"

THERE IS ALSO A HARSH SHIFT OUT OF PARK OR NO SHIFT OUT OF PARK. *RM

PROVIDES THE PROCEDURE FOR REPLACING THE MANUAL TRANSMISSION OIL OF SOME GENESIS COUPE (BK) 2.0L AND 3.8L VEHICLES WITH M6VR1 AND M6VR2 TYPE MANUAL TRANSMISSION. *PE

PROVIDES INSTRUCTIONS FOR REPLACING THE 3.8L AUTOMATIC TRANSMISSION SHIFT CABLE END ROD BOOT. *PE

BULLETIN PROVIDES THE PROCEDURE FOR REPLACING THE MANUAL TRANSMISSION GEAR SHIFT KNOB. *PE

PROVIDES THE PROCEDURE FOR REPLACING THE MANUAL TRANSMISSION GEAR SHIFT LEVER ASSEMBLY AND TRANSMISSION OIL. *PE

State of Charge (SOC) at or below 50%. A 30 Day alert - vehicle has not started and reported an SOC in 30 days.

from the following vehicles by using two magnetic wave radar sensors attached in the rear bumper. The BSD/BCW detects vehicles within the blind spot zone and gives off an alarm (visual and audible). The two magnetic radar sensors provide these functions for BSD/BCW: ? Senses other vehicles in the BSD/BCW zone and turns on the BSD/BCW warning lamp for the driver. The warning lamp starts blinking, along with an audible sound, when the driver turns on the turn signal lamp to enter the lane where another vehicle is driving.

REPLACING OF THE PCM AND A POSSIBLE WARRANTY CLAIM. MODELS 2011-2013 ELANTRA, 2010-2013 GENESIS COUPE, 2010-2013 SANTA FE, 2006-2013 SONATA, 2010-2013 TUCSON. *PE

IF THE SUPPLEMENTAL RESTRAINT SYSTEM CONTROL MODULE (SRSCM) IN THE VEHICLE IS REPLACED DURING SERVICE OR ACCIDENT REPAIR, THE UNIT MUST BE PROGRAMMED USING THE HYUNDAI GLOBAL DIAGNOSTIC SYSTEM (GDS) BEFORE THE VEHICLE IS RELEASED TO THE CUSTOMER. NO MODEL YEARS LISTED. *PE

DTC P0605 OR SLOW RPM DROP WHEN RELEASING THROTTLE. *PE

IF THE SUPPLEMENTAL RESTRAINT SYSTEM CONTROL MODULE (SRSCM) IN THE VEHICLES IS REPLACED DURING SERVICE OR ACCIDENT REPAIR, THE UNIT MUST BE PROGRAMMED USING THE HYUNDAI GLOBAL DIAGNOSTIC SYSTEM (GDS) BEFORE THE VEHICLE IS RELEASED TO THE CUSTOMER. NO MODEL YEARS LISTED. *PE

It provides a barrier between the paint and contaminants, such as rail dust, acid rain, and industrial fallout. In rare cases, the paint can become clouded under the PPF. These spots are the result of moisture trapped between the PPF and the paint.

As a preventative measure, a cavity wax coating is applied to the internal surfaces of underbody components and an undercoating spray is applied to exterior surfaces of specified underbody components. The service campaign describes the procedure to perform this preventative service on certain 2009-2014MY Genesis Sedan (BH), 2011-2016MY Equus (VI), and 2010-2016MY Genesis Coupe (BK) vehicles.

As a preventative measure, cavity wax coating is applied to the internal surfaces of underbody components, and an undercoating spray is applied to the bottom exterior surfaces of specified underbody components. This bulletin describes the procedure to perform this preventative service on certain Genesis Sedan (BH), Equus (VI), and Genesis Coupe (BK) vehicles.

When diagnosing and repairing the outside mirror, do not replace the entire assembly. Refer to page 2 of this TSB for replacement of individual parts.

*LJ

For all wheel/tire balance claims, the Tire Balance Data Sheet must be fully completed including imbalance and Road Force Variation (RFV) data. The Data Sheet can be found at the end of this bulletin.

maximize tire life and performance.

diagnosing and conducting alignment-related repairs for all models and model years.

EFFECTIVE 6/2/08, FMVSS 110 (FMVSS 110) SETS A THRESHOLD FOR CORRECTING LOAD CAPACITY INFORMATION INDICATED ON TIRE PLACARDS WHEN VEHICLE WEIGHT HAS BEEN INCREASED BEFORE RETAIL SALE. ALL MODELS INCLUDED AFTER 6/2/08. *PE

recommended safe chemical products.

chemical products.

Compliance with this bulletin ensures that the GDS data files are correctly transferred and matched with a Techline Case number.

*RM

2. This bulletin presents guidelines to inspect for common Android Auto and Apple CarPlay connection conditions. 3. This bulletin provides physical differences between the USB 2.0 port and USB 3.0 port.

*PE

ADJUST THE CLOCK) ON SOME VEHICLES. *PE

UPDATE FOR DEALER STOCK VEHICLES ONLY. *PE

If the protective cover is not removed correctly, there is a possibility of the rubber insert and rail spring becoming partially separated on the inner side of the wiper blade, which could lead to poor wiping performance and/or possible scratching of the windshield glass. Follow the procedure in this bulletin to properly remove the windshield wiper blade protective cover on all new wiper blades.

SEAT IS OCCUPIED, AND IF SO, DETECT THE PRESENCE OF A CHILD RESTRAINT SYSTEM OR SMALL STATURED OCCUPANT. IN CERTAIN CASES, THE FRONT PASSENGER AIRBAG IS DEACTIVATED TO HELP PREVENT AIRBAG-RELATED INJURIES TO THE FRONT PASSENGER. IF OBJECTS ARE PLACED UNDER THE FRONT PASSENGER SEAT THAT CONTACT THE OCS CONNECTOR, THE CONNECTOR CAN BECOME DISCONNECTED, ILLUMINATING THE AIR BAG WARNING LAMP IN THE INSTRUMENT CLUSTER. IF THIS OCCURS, THE FRONT PASSENGER AIRBAG WILL DEPLOY IN A FRONTAL COLLISION REGARDLESS OF THE FRONT PASSENGER SEAT OCCUPANT. ADDITIONALLY, THE SYSTEMS SECOND STAGE AIRBAG WILL NOT DEPLOY IN MORE SEVERE COLLISIONS.

PROVIDES INFORMATION REGARDING THE FUEL FILTER SERVICE KIT FOR VEHICLES. THE FUEL FILTER SERVICE KIT OUTLINED IN THIS BULLETIN SHOULD BE USED WHENEVER IT IS NECESSARY TO REPLACE THE FUEL FILTER. *PE

*PE