2000 Hyundai Elantra TSBs
48 Technical Service Bulletins across 11 categories
Categories
Transmission
13 bulletinsAUTOMATIC TRANSAXLE PULSE GENERATOR DIAGNOSTIC TROUBLE CODES P0717 AND P0722 - REVISED.
Read full bulletin
*JG
SUBJECT REGARDING AUTOMATIC TRANSAXLE HARSH AND/OR DELAYED SHIFTS.
Read full bulletin
*JG
SUBJECT REGARDING AUTOMATIC TRANSAXLE DIAGNOSTIC TROUBLE CODES LIST.
Read full bulletin
*YH
SUBJECT ON AUTOMATIC TRANSAXLE HARSH OR DELAYED PARK REVERSE OR PARK DRIVE ENGAGEMENT.
Read full bulletin
*YH
SUBJECT REGARDING TRANSAXLE DIAGNOSTIC TROUBLE CODES.
Read full bulletin
*TT
INFORMATION ON PERFORMING A TEST DRIVE FOR TRANSAXLE SHIFT QUALITY.
Read full bulletin
*TT
Hyundai approves only the ATF, DCT gear oil and IVT gear oil specified in the vehicles owners manual.
Read full bulletin
Use of other ATF may result in improper shift quality or other drivability conditions. Use of other DCT and IVT gear oil may result in reduced durability. Hyundai does not approve the use of any aftermarket ATF or gear oil additives.
The automatic transmission warranty repair policy authorizes in-dealership repairs of the following components for both...
Read full bulletin
OEM (new) and remanufactured automatic transmissions:
THIS BULLETIN PROVIDES INFORMATION ON COMPONENTS, ATTRIBUTES, AND PRECAUTIONS OF THE 7-SPEED DRY-TYPE DUAL CLUTCH...
Read full bulletin
TRANSMISSION (DCT).
AUTOMATIC TRANSAXLE DIAGNOSTIC TROUBLE CODES LIST.
Read full bulletin
*TT
AUTOMATIC TRANSAXLE DIAGNOSTIC TROUBLE CODES LIST.
Read full bulletin
*TT
AUTOMATIC TRANSAXLE PULSE GENERATOR DIAGNOSTIC TROUBLE CODES P0717 & P0722.
Read full bulletin
2004 ACCENT INCLUDED. *TT
IMPROVED CLUTCH RELEASE SHAFT UPPER AND LOWER BUSHING.
Read full bulletin
*TT
Engine
12 bulletinsSUBJECT REGARDING AUTOMATIC TRANSAXLE OIL LEAKING FROM OIL PAN GASKET.
Read full bulletin
*JG
ON SOME VEHICLES, A NOISE MAY BE HEARD FOR THE FIRST FEW MINUTES AFTER STARTING AND DRIVING IN COLD WEATHER FROM THE ENGINE COMPARTMENT.
Read full bulletin
*TT
This bulletin provides important checkpoint guidelines when performing engine oil and filter change services.
This bulletin provides information regarding condensation related to the accumulated moisture in the headlamp, rear...
Read full bulletin
combination lamp, daytime running lamp (DRL), or fog lamp. This TSB illustrates the various causes of condensation inside the lamp assembly. Lamp assembly replacement is NOT necessary in most cases. This condition can be eliminated by turning on the lamps with the engine running for several minutes or during normal driving operation.
Effective June 2, 2008, Federal Motor Vehicle Safety Standard 110 (FMVSS 110) established a threshold for correcting...
Read full bulletin
load carrying capacity information indicated on tire placards when vehicle weight has been increased before retail sale. This limit is the lesser of 1.5% of GVWR or 100 pounds. If the total added weight exceeds the lesser of the limit, a label must be added to the driver-side B-pillar within 25mm (1 inch) of the original tire placard.
Follow the guidelines outlined in this bulletin to inspect and clean or replace certain components of the engine intake...
Read full bulletin
system accordingly during engine short block or sub-assembly replacement.
This bulletin provides the service procedure for engine connecting rod bearing clearance testing.
Read full bulletin
Perform the procedure outlined in this bulletin to fulfill the Bearing Clearance Test inspection requirements to determine next required steps.
This bulletin provides information regarding condensation related to moisture accumulation in the headlamp, rear...
Read full bulletin
combination lamp, daytime running lamp (DRL), or fog lamp. The TSB illustrates the various causes of condensation inside the lamp assembly. Lamp assembly replacement is NOT necessary in most cases. This condition can be eliminated by turning on the lamps with the engine running for several minutes, or during normal driving operation.
HYUNDAI: AUTOMATIC TRANSAXLE RANGE SWITCH DIAGNOSTIC TROUBLE CODES P0705 (RANGE SWITCH SIGNAL PROBLEMS), P0707 (RANGE...
Read full bulletin
SWITCH OPEN CIRCUIT), AND P0708 (RANGE SWITCH SHORT CIRCUIT OR MULTIPLE INPUTS). AN IMPROPERLY ADJUSTED OR IMPROPERLY OPERATING RANGE SWITCH MAY RESULT IN THE ABOVE MENTIONED CONDITIONS. MALFUNCTION INDICATOR LIGHT (MIL) ILLUMINATED; IMPOSSIBLE ENGINE START IN P OR N. *PE
EXHAUST MANIFOLD ASSEMBLY INSPECTION AND REPLACEMENT CAMPAIGN - V04.
Read full bulletin
*TT
EXHAUST NOISE COMING FROM THE ENGINE COMPARTMENT.
Read full bulletin
VOLUNTARY SERVICE CAMPAIGN V04 INVOLVES INSPECTING AND, IF NECESSARY, REPLACING THE EXHAUST MANIFOLD. *TT
EXHAUST MANIFOLD ASSEMBLY INSPECTION AND REPLACEMENT CAMPAIGN.
Read full bulletin
*EH
Electrical
6 bulletinsSUBJECT REGARDING DIAGNOSTIC GUIDE FOR CLIFFORD AND DEI SECURITY SYSTEM.
Read full bulletin
*JG
SUBJECT REGARDING CAMPAIGN 040 - MASS AIR FLOW SENSOR CONNECTION RECALL CAMPAIGN.
Read full bulletin
*TT
SUBJECT REGARDING A VOLUNTARY CUSTOMER NOTIFICATION (MASS AIR FLOW SENSOR CONNECTION RECALL CAMPAIGN) ON CERTAIN...
Read full bulletin
VEHICLES MANUFACTURED BETWEEN JUNE 1, 1999 AND JUNE 16, 2000. *TT
SUBJECT REGARDING MASS AIR FLOW SENSOR CONNECTOR REPLACEMENT CAMPAIGN.
Read full bulletin
*TT
This bulletin provides information on identifying dealer stock vehicles with either: A Battery SOC alert - low Battery...
Read full bulletin
State of Charge (SOC) at or below 50%. A 30 Day alert - vehicle has not started and reported an SOC in 30 days.
The Blind Spot Detection (BSD) or Blind-Spot Collision Warning (BCW) is a system that measures the speed of and distance...
Read full bulletin
from the following vehicles by using two magnetic wave radar sensors attached in the rear bumper. The BSD/BCW detects vehicles within the blind spot zone and gives off an alarm (visual and audible). The two magnetic radar sensors provide these functions for BSD/BCW: ? Senses other vehicles in the BSD/BCW zone and turns on the BSD/BCW warning lamp for the driver. The warning lamp starts blinking, along with an audible sound, when the driver turns on the turn signal lamp to enter the lane where another vehicle is driving.
Other
5 bulletinsThis bulletin describes the general guidelines to help disinfect and protect vehicle exterior/interior surfaces using...
Read full bulletin
recommended safe chemical products.
This bulletin describes the general guidelines to disinfect and protect vehicle interior surfaces using certain safe...
Read full bulletin
chemical products.
This bulletin provides instruction detailing the proper methodology for scanning and uploading captured GDS data files to the Techline Repository.
Read full bulletin
Compliance with this bulletin ensures that the GDS data files are correctly transferred and matched with a Techline Case number.
ATA SOLENOID DIAGNOSTIC TROUBLE CODES P0740, P0741, P0742, P0743, P0745, P0747, P0748, P0750, P0752, P0753, P0755, P0757, P0758, P0760, P0765.
Read full bulletin
*TT *MJ
OBD-II READINESS TEST DRIVE CYCLE.
Read full bulletin
*TT
Brakes
3 bulletinsSUBJECT REGARDING FRONT BRAKE CALIPER RATTLE NOISE REPAIR KIT.
Read full bulletin
*TT
This bulletin provides best practice recommendations when performing brake service procedures.
This bulletin describes the procedure to inspect and identify fluid which may appear around the brake caliper area.
Tires & Wheels
3 bulletinsThis bulletin provides tire vibration service procedures, including how to optimize vehicle vibration performance.
Read full bulletin
For all wheel/tire balance claims, the Tire Balance Data Sheet must be fully completed including imbalance and Road Force Variation (RFV) data. The Data Sheet can be found at the end of this bulletin.
This bulletin provides information on tire maintenance best practices and procedures for dealers and customers to...
Read full bulletin
maximize tire life and performance.
This bulletin describes the requirements for all wheel alignment and/or vehicle tracking claims and best practices when...
Read full bulletin
diagnosing and conducting alignment-related repairs for all models and model years.
Body & Paint
2 bulletinsHyundai applies a Paint Protection Film (PPF) on new vehicles before delivery to dealerships.
Read full bulletin
It provides a barrier between the paint and contaminants, such as rail dust, acid rain, and industrial fallout. In rare cases, the paint can become clouded under the PPF. These spots are the result of moisture trapped between the PPF and the paint.
INTERIOR DOOR TRIM PANEL FABRIC REPAIR.
Read full bulletin
*TT
Fuel System
1 bulletinTHIS TSB PROVIDES INFORMATION REGARDING THE LOCATION AND CORRECT INFORMATION OF THE EMISSION LABELS.
Read full bulletin
*TT
Suspension
1 bulletinThis bulletin contains information about the proper removal of the windshield wiper blade protective cover on all models.
Read full bulletin
If the protective cover is not removed correctly, there is a possibility of the rubber insert and rail spring becoming partially separated on the inner side of the wiper blade, which could lead to poor wiping performance and/or possible scratching of the windshield glass. Follow the procedure in this bulletin to properly remove the windshield wiper blade protective cover on all new wiper blades.
Pre-Delivery & Maintenance
1 bulletinThis bulletin provides the inspection procedure and repair guidelines for certain vehicles listed below.
Infotainment
1 bulletinThis bulletin provides guidelines to inspect the USB, head unit, and multi-box for common connection conditions.
Read full bulletin
2. This bulletin presents guidelines to inspect for common Android Auto and Apple CarPlay connection conditions. 3. This bulletin provides physical differences between the USB 2.0 port and USB 3.0 port.