2001 Hyundai Accent TSBs
59 Technical Service Bulletins across 12 categories
Categories
Transmission
18 bulletinsSUBJECT REGARDING DIAGNOSTIC TROUBLE CODE P0722 - PULSE GENERATOR - B INSPECTION AND TRANSMISSION CONTROL MODULE REPROGRAMMING INSTRUCTIONS.
Read full bulletin
*JG
AUTOMATIC TRANSAXLE PULSE GENERATOR DIAGNOSTIC TROUBLE CODES P0717 AND P0722 - REVISED.
Read full bulletin
*JG
SUBJECT REGARDING AUTOMATIC TRANSAXLE BELLHOUSING COVER.
Read full bulletin
*JG
SUBJECT REGARDING AUTOMATIC TRANSAXLE HARSH AND/OR DELAYED SHIFTS.
Read full bulletin
*JG
SUBJECT REGARDING AUTOMATIC TRANSAXLE DIAGNOSTIC TROUBLE CODES LIST.
Read full bulletin
*YH
SUBJECT ON AUTOMATIC TRANSAXLE HARSH OR DELAYED PARK REVERSE OR PARK DRIVE ENGAGEMENT.
Read full bulletin
*YH
SUBJECT REGARDING TRANSAXLE DIAGNOSTIC TROUBLE CODES.
Read full bulletin
*TT
SUBJECT REGARDING MANUAL TRANSAXLE SHIFT FEEL IMPROVEMENT - SERVICE KIT PARTS.
Read full bulletin
*TT
Hyundai approves only the ATF, DCT gear oil and IVT gear oil specified in the vehicles owners manual.
Read full bulletin
Use of other ATF may result in improper shift quality or other drivability conditions. Use of other DCT and IVT gear oil may result in reduced durability. Hyundai does not approve the use of any aftermarket ATF or gear oil additives.
The automatic transmission warranty repair policy authorizes in-dealership repairs of the following components for both...
Read full bulletin
OEM (new) and remanufactured automatic transmissions:
AUTOMATIC TRANSAXLE DIAGNOSTIC TROUBLE CODE (DTC) LIST.
Read full bulletin
*KB
REMANUFACTURED AUTOMATIC TRANSAXLE DIFFERENTIAL OIL SEAL.
Read full bulletin
*TT
AUTOMATIC TRANSAXLE DIAGNOSTIC TROUBLE CODES LIST.
Read full bulletin
*TT
REPROGRAMS ARE AVAILABLE FOR AUTOMATIC TRANSAXLE DRIVEABILITY ISSUES.
Read full bulletin
TECHNET TIMES. HYUNDAI. *TT
AUTOMATIC TRANSAXLE DIAGNOSTIC TROUBLE CODES LIST.
Read full bulletin
*TT
DIAGNOSTIC TROUBLE CODE (DTC) P0130 (OXYGEN SENSOR MALFUNCTION); DIAGNOSTIC TROUBLE CODE (DTC) P0503 (SPEED SENSOR...
Read full bulletin
MALFUNCTION; REVERSE TO DRIVE LURCH WHILE ROLLING BACKWARDS (ON AUTOMATIC TRANSAXLE EQUIPPED VEHICLES ONLY). *TT
AUTOMATIC TRANSAXLE PULSE GENERATOR DIAGNOSTIC TROUBLE CODES P0717 & P0722.
Read full bulletin
2004 ACCENT INCLUDED. *TT
SHOCK OR DELAYED ENGAGEMENT DURING PARK TO REVERSE OR PARK TO DRIVE SHIFT TRANSMISSION CONTROL MODULE (TCM) REPROGRAMMING INSTRUCTIONS.
Read full bulletin
*TT
Engine
13 bulletinsINFORMATION REGARDING SHOP MANUAL CORRECTION FOR IDLE SPEED ACTUATOR RESISTANCE CHECK.
Read full bulletin
*YH
SOME VEHICLES MAY EXPERIENCE VERY INTERMITTENT CRANK-NO-START; THE CHECK ENGINE LIGHT DOES NOT LIGHT UP AS NORMALLY IS...
Read full bulletin
DOES; THE HI-SCAN PRO CANNOT COMMUNICATE WITH THE ENGINE CONTROL MODULE. *TT
SUBJECT REGARDING SHOP MANUAL CORRECTION FOR IDLE SPEED ACTUATOR RESISTANCE CHECK.
Read full bulletin
*YH
This bulletin provides information regarding condensation related to the accumulated moisture in the headlamp, rear...
Read full bulletin
combination lamp, daytime running lamp (DRL), or fog lamp. This TSB illustrates the various causes of condensation inside the lamp assembly. Lamp assembly replacement is NOT necessary in most cases. This condition can be eliminated by turning on the lamps with the engine running for several minutes or during normal driving operation.
This bulletin provides important checkpoint guidelines when performing engine oil and filter change services.
This bulletin provides information regarding condensation related to the accumulated moisture in the headlamp, rear...
Read full bulletin
combination lamp, daytime running lamp (DRL), or fog lamp. This TSB illustrates the various causes of condensation inside the lamp assembly. Lamp assembly replacement is NOT necessary in most cases. This condition can be eliminated by turning on the lamps with the engine running for several minutes or during normal driving operation.
Effective June 2, 2008, Federal Motor Vehicle Safety Standard 110 (FMVSS 110) established a threshold for correcting...
Read full bulletin
load carrying capacity information indicated on tire placards when vehicle weight has been increased before retail sale. This limit is the lesser of 1.5% of GVWR or 100 pounds. If the total added weight exceeds the lesser of the limit, a label must be added to the driver-side B-pillar within 25mm (1 inch) of the original tire placard.
Follow the guidelines outlined in this bulletin to inspect and clean or replace certain components of the engine intake...
Read full bulletin
system accordingly during engine short block or sub-assembly replacement.
This bulletin provides the service procedure for engine connecting rod bearing clearance testing.
Read full bulletin
Perform the procedure outlined in this bulletin to fulfill the Bearing Clearance Test inspection requirements to determine next required steps.
This bulletin provides information regarding condensation related to moisture accumulation in the headlamp, rear...
Read full bulletin
combination lamp, daytime running lamp (DRL), or fog lamp. The TSB illustrates the various causes of condensation inside the lamp assembly. Lamp assembly replacement is NOT necessary in most cases. This condition can be eliminated by turning on the lamps with the engine running for several minutes, or during normal driving operation.
HYUNDAI: AUTOMATIC TRANSAXLE RANGE SWITCH DIAGNOSTIC TROUBLE CODES P0705 (RANGE SWITCH SIGNAL PROBLEMS), P0707 (RANGE...
Read full bulletin
SWITCH OPEN CIRCUIT), AND P0708 (RANGE SWITCH SHORT CIRCUIT OR MULTIPLE INPUTS). AN IMPROPERLY ADJUSTED OR IMPROPERLY OPERATING RANGE SWITCH MAY RESULT IN THE ABOVE MENTIONED CONDITIONS. MALFUNCTION INDICATOR LIGHT (MIL) ILLUMINATED; IMPOSSIBLE ENGINE START IN P OR N. *PE
SLOWER THAN USUAL ACCELERATION AFTER AN INITIAL COLD START; GREATER THAN USUAL RPM DROP WHEN ENGAGING DRIVE OR REVERSE;...
Read full bulletin
CHECK ENGINE LIGHT ON AND P0116 STORED. *TT
RESISTANCE VALUES FOR IDLE SPEED CONTROL ACTUATOR (ISCA).
Read full bulletin
VARIOUS MODELS INCLUDING THE 2004 SONATA. *TT
Electrical
7 bulletinsSUBJECT REGARDING ELECTRONIC CONTROL MODULE REPROGRAMMING TO IMPROVE ACCELERATION AFTER AN INITIAL COLD START.
Read full bulletin
*JG
SUBJECT ON REGARDING ECM REPROGRAMMING FOR POOR ACCELERATION CONDITION.
Read full bulletin
*YH
This bulletin provides information on identifying dealer stock vehicles with either: A Battery SOC alert - low Battery...
Read full bulletin
State of Charge (SOC) at or below 50%. A 30 Day alert - vehicle has not started and reported an SOC in 30 days.
The Blind Spot Detection (BSD) or Blind-Spot Collision Warning (BCW) is a system that measures the speed of and distance...
Read full bulletin
from the following vehicles by using two magnetic wave radar sensors attached in the rear bumper. The BSD/BCW detects vehicles within the blind spot zone and gives off an alarm (visual and audible). The two magnetic radar sensors provide these functions for BSD/BCW: ? Senses other vehicles in the BSD/BCW zone and turns on the BSD/BCW warning lamp for the driver. The warning lamp starts blinking, along with an audible sound, when the driver turns on the turn signal lamp to enter the lane where another vehicle is driving.
2000-2004 1.5L & 1.6L ACCENT P0130 (OXYGEN SENSOR) AND P0530 (SPEED SENSOR).
Read full bulletin
*SC
DIAGNOSTIC TROUBLE CODE (DTC) P0722 - PULSE GENERATOR-B INSPECTION AND TCM REPROGRAMMING.
Read full bulletin
*TT
ATM DIODE PIN CORROSION IN THE CONTROL WIRING HARNESS LOCATED BEHIND THE DASH PANEL.
Read full bulletin
*TT
Other
4 bulletinsThis bulletin describes the general guidelines to help disinfect and protect vehicle exterior/interior surfaces using...
Read full bulletin
recommended safe chemical products.
This bulletin describes the general guidelines to disinfect and protect vehicle interior surfaces using certain safe...
Read full bulletin
chemical products.
This bulletin provides instruction detailing the proper methodology for scanning and uploading captured GDS data files to the Techline Repository.
Read full bulletin
Compliance with this bulletin ensures that the GDS data files are correctly transferred and matched with a Techline Case number.
ATA SOLENOID DIAGNOSTIC TROUBLE CODES P0740, P0741, P0742, P0743, P0745, P0747, P0748, P0750, P0752, P0753, P0755, P0757, P0758, P0760, P0765.
Read full bulletin
*TT *MJ
Body & Paint
3 bulletinsTHIS REVISED BULLETIN DESCRIBES THE REPAIR FOR A RATTLE OR CREAK NOISE HEARD INSIDE THE VEHICLE FROM THE DOOR HINGE AREAS.
Read full bulletin
THE NOISE MAY OCCUR ON ALL FOUR DOORS. *TT
THIS BULLETIN DESCRIBES THE REPAIR FOR A RATTLE OR CREAK NOISE HEARD INSIDE THE VEHICLE FROM THE DOOR HINGE AREAS.
Read full bulletin
*TT
Hyundai applies a Paint Protection Film (PPF) on new vehicles before delivery to dealerships.
Read full bulletin
It provides a barrier between the paint and contaminants, such as rail dust, acid rain, and industrial fallout. In rare cases, the paint can become clouded under the PPF. These spots are the result of moisture trapped between the PPF and the paint.
Pre-Delivery & Maintenance
3 bulletinsThis bulletin provides the inspection procedure and repair guidelines for certain vehicles listed below.
FRONT A-PILLAR BRACKETS - (CAMPAIGN 055).
Read full bulletin
*TT
FRONT A-PILLAR BRACKET INSTALLATION (CAMPAIGN 055).
Read full bulletin
*TT
Tires & Wheels
3 bulletinsThis bulletin provides tire vibration service procedures, including how to optimize vehicle vibration performance.
Read full bulletin
For all wheel/tire balance claims, the Tire Balance Data Sheet must be fully completed including imbalance and Road Force Variation (RFV) data. The Data Sheet can be found at the end of this bulletin.
This bulletin provides information on tire maintenance best practices and procedures for dealers and customers to...
Read full bulletin
maximize tire life and performance.
This bulletin describes the requirements for all wheel alignment and/or vehicle tracking claims and best practices when...
Read full bulletin
diagnosing and conducting alignment-related repairs for all models and model years.
Suspension
2 bulletinsTHIS BULLETIN PROVIDES INSTALLATION PROCEDURES FOR THE MOUNTING BUSHINGS FITTED TO THE FRONT SUSPENSION CROSS MEMBER.
Read full bulletin
*TT
This bulletin contains information about the proper removal of the windshield wiper blade protective cover on all models.
Read full bulletin
If the protective cover is not removed correctly, there is a possibility of the rubber insert and rail spring becoming partially separated on the inner side of the wiper blade, which could lead to poor wiping performance and/or possible scratching of the windshield glass. Follow the procedure in this bulletin to properly remove the windshield wiper blade protective cover on all new wiper blades.
Brakes
2 bulletinsThis bulletin provides best practice recommendations when performing brake service procedures.
This bulletin describes the procedure to inspect and identify fluid which may appear around the brake caliper area.
HVAC & Climate
2 bulletinsFD46XG POLY ALKYLEN GLYCOL (PAG) OIL SPECIFICATIONS FOR AIR CONDITIONING COMPONENT REPLACEMENT.
Read full bulletin
*NM
FD46XG PAG OIL SPECIFICATIONS FOR AIR CONDITIONING COMPONENT REPLACEMENT.
Read full bulletin
*TT
Infotainment
1 bulletinThis bulletin provides guidelines to inspect the USB, head unit, and multi-box for common connection conditions.
Read full bulletin
2. This bulletin presents guidelines to inspect for common Android Auto and Apple CarPlay connection conditions. 3. This bulletin provides physical differences between the USB 2.0 port and USB 3.0 port.
Lighting
1 bulletinREPLACEMENT CIGARETTE LIGHTER.
Read full bulletin
*NM