2019 Honda GL1800 TSBs

Inspect the number five (15 amp) audio fuse next to the battery in the main fuse box. If failed, replace the fuse and disconnect the main multi pin connector from the Navi/audio unit. Power up the unit, and the fuse should not blow. You can also test with a known good Navi/audio unit. TechLine may be able to loan a known good Navi/audio unit if one is not available. If the fuse does not fail, the original Navi/audio unit is internally shorted and will need to be replaced. " Newsletter - We have heard of customers riding with the cruise ON with no intention of actually using the cruise control function. These customers have noticed an issue where the cruise ON light in the dash will intermittently turn off on its own and not turn on again until the ignition key is turned off and back on. This will cause a P0504 error code to be stored for a brake switch malfunction. However, there is no actual malfunction of the switch. The rear brake pedal has a brake light switch and a cruise cancel switch. The problem is when both switches are activated for longer than 30 seconds while riding. Newsletter - When installing the NC750X/D accessory light bar (p/n 08A70-MJL-D30 or p/n 08A70-MGS-D30), ensure the front cowl stay holes are drilled in the correct position. The distance between the two mounting holes should be 37mm. If the mounting holes are less than 37mm, the front cowl stay (p/n 08A70-MJL-D30 or p/n 08A70-MGS-D30) will need to be replaced to install the accessory light bar. Newsletter - If the indicator warning light is on at all times and the motorcycle functions normally, you could have a DTC code P170D (shift sensor ground fault) due to the unit not having the quick shift option installed.

factory runs the freshly built unit on a dyno to verify proper engine and transmission operation. These stored codes are easily cleared using MCS, and will not return unless there is a problem related to the front (1-1) or rear (1-3) wheel speed sensors, or there is a CAN communication error (8-7) related to the ABS system.

If DTCs appear on a new 2018 and newer GL1800, these are likely ABS related and are generated when the factory runs the freshly built unit on a dyno to verify proper engine and transmission operation. These stored codes are easily cleared using MCS, and will not return unless there is a problem related to the front (1-1) or rear (1-3) wheel speed sensors, or there is a CAN communication error (8-7) related to the ABS system."

Steering Bridge to adjust the upper steering stem nut on any 2018 and newer GL1800, the left rear tie rod bolt needs to be held by a 14 mm open wrench to prevent the bolt from turning when loosening the 17 mm upper nut. If the bolt is not supported, the rubber bushing will be damaged, which will then need to be replaced. Bushing damage will not be covered by warranty.