2008 Ford Mustang TSBs

Some 2000 and newer Ford/Lincoln/Mercury vehicles equipped with aluminum body panels may exhibit corrosion concerns appearing as bubbled and/or peeling paint with or without accompanying white dust. Panel replacement is recommended.

appearing as bubbled and/or peeling paint with or without accompanying white dust. Panel replacement is recommended. Follow the Service Procedure steps to correct the condition

appearing as bubbled and/or peeling paint with or without accompanying white dust. Panel replacement is recommended. Follow the Service Procedure steps to correct the condition

THIS MAY BE CAUSED BY LOOSE GROMMETS AND/OR SEALER SKIPS AROUND COWL AREA, LOOSE A PILLAR WINDOW WEATHERSTRIP RETAINER. *PE

MAY BE CAUSED BY LOOSE GROMMETS AND/OR SEALER SKIPS AROUND THE COWL AREA, LOOSE A-PILLAR WINDOW WEATHERSTRIP RETAINER. *PE

*PE

VEHICLES MAY EXHIBIT UN-COMMANDED PERIMETER LIGHTING FEATURE (HEAD, PARK AND SIDE MARKER LAMPS) DUE TO WATER INDUCED SHORT TO GROUND IN THE DOOR DISARM SWITCH. *PE

2007-2010 Edge & MKX Vehicles Driver & Passenger Airbag Module Quality Control Inspection REASON FOR THIS SUPPLEMENT Updated Ranger Technical Information to include images of a pass and fail airbag inflator inspection for 2007-2011 model years.

It is also not recommended to order a replacement module using a vehicle identification number (VIN) from a different vehicle. Most modules on these affected vehicles are VIN/vehicle specific and hardware variations between modules do exist. Swapping a module from a vehicle or ordering a module using a different vehicle/VIN can cause ineffective repairs and additional vehicle down time. Make sure all appropriate Workshop Manual (WSM) procedures are followed when diagnosing the condition prior to all module replacements and only order modules using the correct VIN.

The ETC_ACT and ETC_DSD PIDs should not used to diagnose possible ETB concerns. The IDS has a limited refresh rate when reading these PIDs and cannot display quickly enough to validate a concern. The PCM automatically monitors these inputs more accurately and will set diagnostic trouble codes (DTCs) when appropriate. Using these PIDs for diagnostics will lead to inaccurate results and improper ETB replacements. If a concern is intermittent and no DTCs are present, refer to historical DTCs and the PC/ED, Section 3 No DTCs Present Index chart for further information.

A WIRING HARNESS CONNECTION MAY BE CAUSING THE AIR BAG LIGHT TO ILLUMINATE IN VEHICLES WITH SIDE AIR BAGS. *RM

VEHICLES MAY EXHIBIT AIRBAG LIGHT WITH B2292 HARD FAULT CODE POINTING TOWARD SEAT BELT PRETENSIONER. REPLACE BODY WIRING HARNESS CONNECTOR. *PE

Edge & MKX Vehicles Driver & Passenger Airbag Module Quality Control Inspection: Ford Motor Company has determined that some vehicles claimed by dealers as repaired under Takata Airbag Safety Recalls 15S21, 17S42, 18S02, 19S01, and 21S12 may not have received the claimed repairs. The propellant in certain Takata airbag inflators can experience an alteration over time with exposure to certain climate conditions. A combination of time, high temperature fluctuations, and humidity contribute to the degradation of the propellant in the inflators. This degradation can cause the propellant to burn too quickly, creating high pressure inside the inflator, and in extreme cases causing the inflator to rupture in the event of a crash necessitating airbag deployment. A ruptured inflator can send inflator parts toward vehicle occupants resulting in serious injury or death. Additional information regarding Takata recalls can be found at www.nhtsa.gov and www.safercar.gov.

symptoms that may include upper end engine noise, rough running, misfire and/or engine damage. If diagnosis leads to only camshaft/camshaft roller follower(s) requiring replacement, replace all of the camshaft roller followers on both banks/cylinder heads with part number 3L3Z-6564-A, not just the faulty roller follower(s). When replacing the camshaft roller followers, refer to Workshop Manual (WSM), Section 303-01.

IDLE RPM FLUCTUATION AND EXHIBIT DIAGNOSTIC TROUBLE CODES (DTCS) P0505, P0506, P2111 AND P2112. *PE

LOW SPEED AND IS CHARACTERISTIC OF HEAVY DUTY/RACING TYPE LIMITED SLIP DIFFERENTIAL. MODEL 2007-2014 MUSTANG GT500, GT, BULLITT. *PE

1ST AND REVERSE, HARD TO SHIFT ANY GEAR, VEHICLE CREEPS WITH TRANSMISSION IN GEAR AND CLUTCH PEDAL FULLY DEPRESSED WITHOUT BRAKE PEDAL APPLICATION. *PE

CONDITION MAY BE MORE PRONOUNCED WHEN THE TRANSMISSION IS COLDER THAN 40 DEGREES F (5 DEGREES C). *PE

original SYNC/Navigation parts to provide additional features is not recommended nor supported on any Ford, Mercury or Lincoln vehicle. Only approved Genuine Ford accessories or originally installed systems are supported and certified to function correctly with other vehicle systems. If you suspect a system has been modified, the following resources can be used to verify original equipment: Monroney Label (Window Sticker), Professional Technician Society (PTS) OASIS tab  select SYNC or HVBOM. For Genuine Ford accessories use: PTS Workshop Tab  select Dealer Installed Accessory or Accessory Installation.

ORIGINAL SYNC/NAVIGATION PARTS TO PROVIDE ADDITIONAL FEATURES IS NOT RECOMMENDED NOR SUPPORTED ON ANY FORD, MERCURY OR LINCOLN VEHICLE. ONLY APPROVED GENUINE FORD ACCESSORIES OR ORIGINALLY INSTALLED SYSTEMS ARE SUPPORTED AND CERTIFIED TO FUNCTION CORRECTLY WITH OTHER VEHICLE SYSTEMS. IF YOU SUSPECT A SYSTEM HAS BEEN MODIFIED, THE FOLLOWING RESOURCES CAN BE USED TO VERIFY ORIGINAL EQUIPMENT: MONRONEY LABEL (WINDOW STICKER), PROFESSIONAL TECHNICIAN SOCIETY (PTS) OASIS TAB  SELECT SYNC OR HVBOM. FOR GENUINE FORD ACCESSORIES USE: PTS WORKSHOP TAB  SELECT DEALER INSTALLED ACCESSORY OR ACCESSORY INSTALLATION.

*TA

THE U.S VIRGIN ISLANDS ARE IN NEED OF AN AIRBAG INFLATOR REPLACEMENT. 06/11/15 *TA.

*RM

*NJ