2025 Ford F-150 Lightning Bev TSBs

pack state of charge (SOC) that drops from 100% to less than 90% within 60 seconds of being driven, and an inability to reach a target SOC using the scheduled charging feature without any diagnostic trouble codes (DTCs) in the battery energy control module (BECM). This may be due to an issue in one or more cells within the high voltage battery pack. To correct the condition, run the "BECM Battery Health" application using the latest software version of the Ford Diagnosis and Repair System (FDRS). If any cells are identified as exceeding state of charge and/or capacity thresholds, refer to the Workshop Manual (WSM), Section 414-03A High Voltage Battery, Mounting and Cables > Diagnosis and Testing > High Voltage Battery, Mounting and Cables - Electric > Pinpoint Test AP > Step AP4 and continue diagnosis. If all cells are within state of charge and capacity thresholds or DTCs are present in the BECM, refer to the WSM for normal diagnosis. For claiming, use causal part 10D672 and labor op

Software Update Manager was sending an uninterruptible update to the Body Control Module."

indicator with diagnostic trouble code (DTC) P2797 stored in the secondary on-board diagnostic control module B (SOBDMB) and/or the secondary on-board diagnostic control module C (SOBDMC). This may be due to the software in the SOBDMB and/or the SOBDMC.

SiriusXM disk memory usage"

Hydraulic braking assist will still be available"

control symptoms with diagnostic trouble code (DTC) B1717:06 in the heat pump valve control module (HPVCM). Workshop Manual (WSM), Section 412-00 Climate Control System - General Information > Diagnosis and Testing > Pinpoint Test AW has been updated to address this condition. Refer to the revised WSM section for normal diagnosis.

(HPVCM) after a diagnostic self-test is performed.

Mustang Mach-E Vehicles Undesired Acceleration Due to Adaptive Cruise Control (ACC) Activation

Front Door Lower Window Glass Run Replacement

vehicles, the GSM may experience a malfunction and the floor console GSM shifter may be unable to stow or un-stow when the gear shift stow button is pressed and an illuminated wrench light will be displayed on the Instrument Panel Cluster (IPC). The vehicle may be inoperable if the shifter is in the stowed position when the malfunction occurs. If the shifter is not in the stowed position when the malfunction occurs, the customer will still be able to drive the vehicle and may observe a wrench light on the IPC