2026 Dodge Durango TSBs

S2623000040.

Mirror Contacts Door Window Glass In The Folded Position.

Mirror Contacts Door Window Glass In The Folded Position.

Mirror Contacts Door Window Glass In The Folded Position.

Mirror Contacts Door Window Glass In The Folded Position.

chatter/streak/jump/skip/smear or make noise while traveling across the windshield. . No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, photocopying, or otherwise, without written permission of FCA US LLC.

exterior surface areas of the hinges, doors, fenders, swing gates or liftgates.

exterior surface areas of the hinges, doors, fenders, swing gates or liftgates.

exterior surface areas of the hinges, doors, fenders, swing gates or liftgates

chatter/streak/jump/skip/smear or make noise while traveling across the windshield.

(MIL) illumination and one or more of the SYMPTOM: following Diagnostic Trouble Codes (DTCs): B22A9-96 - ECU Internal Performance-Component Internal Failure. B1560-11 - Cellular Antenna 1-Circuit Short To Ground. B1560-13 - Cellular Antenna 1-Circuit Open. B1561-11 - Cellular Antenna 2-Circuit Short To Ground. B1561-13 - Cellular Antenna 2-Circuit Open. B1562-14 - GPS Antenna-Circuit Short To Ground Or Open. Customers may also experience the following: "Uconnect Box Requires Service" Message in Radio Display Fig. 1. This bulletin involves reprogramming the TBM with the latest available software.

illumination and the vehicle must SYMPTOM: exhibit/set the following Diagnostic Trouble Code (DTC): C14A4-00 - Sensor Adjustment Required. Customers may also experience the following: "ACC/FCW Unavailable, Service Required" message in the Instrument Panel Cluster (IPC). This bulletin involves reprogramming of the ACC module with the latest available software.

gauge accuracy and drivability issues, the technician should disconnect the electrical connector at the pump and perform a visual inspection of the connector for and bent, spread, or pushed out terminals. Repair any issues found. Reconnect the plug and perform a push pull push to ensure the connector is fully installed. Then perform 3 keys cycles and listen to hear if the fuel pump is operational. If the fuel pump is heard that indicates that everything is operating correctly. If the pump is heard replacement is not necessary, any replacement will function in the same way.

one or more of the SYMPTOM: following Diagnostic Trouble Codes (DTCs): B22A9-96 - ECU Internal Performance-Component Internal Failure. B1560-11 - Cellular Antenna 1-Circuit Short To Ground. B1560-13 - Cellular Antenna 1-Circuit Open. B1561-11 - Cellular Antenna 2-Circuit Short To Ground. B1561-13 - Cellular Antenna 2-Circuit Open. B1562-14 - GPS Antenna-Circuit Short To Ground Or Open. Customers may also experience the following: "UConnect Box Requires Service" Message in Radio Display.

function is not operating properly? *Forward/Backward *Recline Forward *Recline Backward *Height Adjustment *Multiple Functions 2.Is the concern constant or Intermittent? 3.If intermittent, how often does it occur? Daily, Weekly, Randomly 4.Does the seat move on its own without pressing any switch? Yes / No 5.Does the issue occur only while driving, only at key-on, or while the vehicle is parked? 6.Has the concern occurred after the vehicle has been sitting for an extended period (overnight or several hours)? 7.Does pressing the switch multiple times temporarily restore operation? 8.Have any other seat functions or electrical features been affected at the same time? 9.Has the seat adjuster switch or seat assembly been previously repaired or replaced? Before replacing the seat adjuster switch, verify power, ground, connector engagement, wiring integrity, and inspect for blown fuses or damaged harnesses. If no external issues are found and the concern is verified, an intermittent internal switch failure should be considered.

gauge accuracy and drivability issues, the technician should disconnect the electrical connector at the pump and perform a visual inspection of the connector for and bent, spread, or pushed out terminals. Repair any issues found. Reconnect the plug and perform a push pull push to ensure the connector is fully installed. Then perform 3 keys cycles and listen to hear if the fuel pump is operational. If the fuel pump is heard that indicates that everything is operating correctly. If the pump is heard replacement is not necessary, any replacement will function in the same way.

prevent unauthorized key fob programming This bulletin involves **inspecting and possibly** updating the RFHM module with the latest available software

Tech Tip: Reset the IPC module first before any steps are taken to replace the module are undertaken. Connect Witech to the vehicle. Reset all DTCs and check for active DTCs warnings set against IPC. If battery low indicated against IPC, reset the module via WiTech tool. NOTE: After Battery Drainage, the IPC may not function correctly. Please follow the following steps before considering an IPC replacement: 1) Charge the Battery Ensure the battery is fully charged. 2) Soft Reset Perform a soft reset on the IPC. 3) Power-Up Issue 4) If the IPC does not power up, proceed with the following steps: a. Disconnect the battery. b. Reconnect the battery. 5) If condition still exists, consider IPC replacement.

Battery Charging Message, Presence of IBS related Diagnostic Trouble Codes (DTCs), or Battery Warning Lamp On

Rain Sensor Internal Failure.

Rain Sensor Internal Failure.

Malfunction Indicator Lamp (MIL) illumination and the vehicle may exhibit/set the following Diagnostic Trouble Code (DTC): B1E21-96 - Backup Battery Component Internal Failure.

prevent unauthorized key fob programming This bulletin involves updating the RFHM module with the latest available software.

the radio: "Battery of Uconnect Box requires service. SOS call and related functions may be unavailable. Please visit an authorized dealer." PLEASE do not Replace the TBM module, only replace TBM Internal Battery (inside Telematics Box Module) and order PN68493347

Indicator Lamp (MIL) illumination and the vehicle may exhibit/set the following Diagnostic Trouble Code (DTC): B1E21-96 - Backup Battery Component Internal Failure

Refer to SOL S2609000006 The IAFM Foam Engine Valley Cover (PN 53013735AB) does not provide sufficient clearance for proper routing of the MDS solenoid jumper harness (PN 05148163AE). As a result, the harness may become compressed by the foam cover. To prevent unnecessary part replacement, the MDS solenoid jumper harness (PN 05148163AE) should be inspected for damage or pinch conditions prior to replacing the following part numbers: Engine PNs: 68409343AA 68409357AA 68450915AA OCV PNs: 53022338AB Phaser PNs: 53022298AA 53022298AB

and the vehicle must SYMPTOM: exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs): **P0111-00 - Intake Air Temperature Sensor 1 Circuit Range Performance Bank 1. (In Active or Stored status) P0071-00 - Ambient Air Temperature Sensor Performance. (In Active or Stored status) P0072-00 - Ambient Air Temperature Sensor Circuit "A" Low. (In Active or Stored status) P0073-00 - Ambient Air Temperature Sensor Circuit "A" High. (In Active or Stored status) P0011-00 - Bank 1 Camshaft 1 Position Timing Over Advanced Or. (In Active or Stored status) P25E4-00 - B Camshaft Position - Unable To Achieve Locked Position Bank 1. (In Active or Stored status) P05BD-00 - Stop-Start Mode Switch Range/Performance. (In Active or Stored status) P0116-00 - Engine Coolant Temperature Sensor 1 Performance. (In Active or Stored status) P062B-00 - Internal Control Module Fuel Injector Control Performance. (In Active or Stored status) P0604-00 - Internal Control Module Random Access Memory Ram Error. (In Active or Stored status) P060C-00 - Internal Control Module Main Processor Performance. (In Active or Stored status)** P018B-00 - Fuel Pressure Sensor "B" Circuit Range/performance. **(In Active or Stored status)** P1CEA-00 - Boost Side EVAP Purge System Performance. **(In Active or Stored status)** P06DD-00 - Engine Oil Pressure Control Circuit Performance/Stuck Off. **(In Active or Stored status)** P00C6-00 - Fuel Rail Pressure Too Low - Engine Cranking. **(In Active or Stored status)** P0300-00 - Multiple Cylinder Misfire. **(In Active or Stored status)** Customers may also experience one or more of the following: **Oil Level High Warning in the Instrument Panel Cluster (IPC).** Fully Autonomous Parking Assist (FAPA) is not deactivated when accelerator pedal is pressed. Vehicle is not heating up fast enough at freezi

845RE, 8HP45, 850RE, 8HP50, 8HP70, 8HP75, 8HP75-PHEV, 8HP75-LCV, 8HP90, 8HP95. Transmissions may exhibit the following diagnostic codes: P07E4, P1DB2, P0716, P1B14, P0733, P1D90, P1DB7, P1B13.

This data collection is applicable to all vehicle with engines with sales codes: ERG, ERC, EH3 and ERF. To assist with monitoring and quality improvement of the 3.6L engine, every time a vehicle comes for any of the first 3 oil changes, please use wiTECH to record the total engine idle time and the total engine runtime. 1. Prior to perform the oil change connect wiTECH diagnostic tool. 2. Navigate to the topology screen on the action item section. 3. Once the topology screen loads, disconnect wiTECH and continue with oil change.

blank/black at times.

Will Not Open/ Close. Liftgate/Hatch Ajar Message Displayed. Rev A

Will Not Open/ Close. Liftgate/Hatch Ajar Message Displayed.

Cluster (IPC) when the turn-by-turn feature is enabled. This issue occurs when using Google Maps for Navigation via CarPlay

Cluster (IPC) when the turn-by-turn feature is enabled. This issue occurs when using Google Maps for Navigation via CarPlay

or B1570-93

part, we want to notify them to review Star Online S2208000045 before replacing cameras for poor image quality (fuzzy, blurry, pixelated) to ensure camera replacement is warranted / justified. This SOL provides a process for evaluating if the camera's image quality is within a typical range.

A/C relay clutch not operating, dealers are unnecessary replacing PDCs. Battery disconnection is required to reset PCM. Please follow SOL S2624000004.

A/C relay clutch not operating, dealers are unnecessary replacing PDCs. Battery disconnection is required to reset PCM. Please follow SOL S2624000004.

A/C relay clutch not operating, dealers are unnecessary replacing PDCs. Battery disconnection is required to reset PCM. Please follow SOL S2624000004.

The Tech May Find Damaged and/or Worn Transmission Output Shaft Splines (850RE Transmission Only)

Order a "Z" part number for all Exchange Orders: Warranty, Mopar, Customer pay and Service contract. Order "68" part number for New unsold units only.

Rattle (BSR) from rear of vehicle. This bulletin involves inspecting and possibly replacing the rear suspension cradle / crossmember.

Power surge on USB hub detected Fig. 1. NOTE: After the message appears, no USB devices function in the hub (no charging, no data). NOTE: Hub operation does not return until the vehicle undergoes a full key cycle.

Power surge on USB hub detected Fig. 1. NOTE: After the message appears, no USB devices function in the hub (no charging, no data). NOTE: Hub operation does not return until the vehicle undergoes a full key cycle

Power surge on USB hub detected Fig. 1. NOTE: After the message appears, no USB devices function in the hub (no charging, no data). NOTE: Hub operation does not return until the vehicle undergoes a full key cycle

B1A17-00 in The Radio Frequency Hub (RFH)

Squealing/squeaking/grinding noise when braking. Vehicle pulls to one side when braking. This bulletin involves lubricating the brake pad anchors.

Diagnostic Trouble Code (DTC) B1D9B-54- Seat Horizontal Front Stop Not Learned-Missing Calibration

lamps (headlamps, fog lamps, grille lamps, logo lamps or signature lamps) assemblies are fogged with a light layer of condensation on the inside of the lenses*