2020 Can-Am Ryker TSBs
18 Technical Service Bulletins across 8 categories
Categories
Electrical
4 bulletinsRYKER YAW Rate - SAS Sensor Faults These 3 faults (C0063 and/or C0051 and *C006C) can be triggered if the front...
Read full bulletin
suspension has excessive play or the front wheel alignment is out of specification
Yaw rate sensor faults might be triggered due to loose front suspension components.
This bulletin is the detailed repair procedure if the position light and flasher electrical harness in the front fenders...
Read full bulletin
have rubbed on the tires wearing the insulating sheath.
YAW rate sensor faults might be triggered due to loose front suspension components.
Other
3 bulletinsUpon installation of the 2-UP passenger seat, difficulty to install might result in the breakage of the latch.
This TST includes solution for the noise that can be heard or felt under deceleration at high speed.
Ryker 2020 Low Torque on FDU The bolts that holds the FDU to the swing arm are not torqued as specification for these...
Read full bulletin
vehicles.
Engine
3 bulletinsRykers 900 engines that may have the incorrect camshaft timing.
Read full bulletin
Ryker Equipped with the 900 engine may start well when cold but then can have a rough idle or even dies at idle when the engine is warmed up.
We have some report that some 602 and 903 engines have been produced with the wrong camshaft.
Read full bulletin
This document will help you to identify the correct one. If the wrong camshaft is installed the unit can have the following symptoms poor, idle, engine performance, O2 fault, engine misfire.
Possible contact between the exhaust pipe and frame.
Read full bulletin
Here are some ways to increase the distance between the exhaust pipe and the frame. The minimal distance between the exhaust pipe and the frame should be 5mm. Symptoms Excessive engine vibration felt, exhaust manifold bolts loose, engine rattle noise.
Tires & Wheels
2 bulletinsMessage and alert to all dealer RYKER mandatory certification form The front wheel installation is a critical operation...
Read full bulletin
and must be performed as explained in the PDI bulletin.
Safety Campaign- Possible Front Wheel Loss.
Read full bulletin
The front wheel assembly may not have been performed properly (torque application and installation of the red locking clip).
Fuel System
2 bulletinsFuel Pump can be noisy especially when low fuel levels and warm temperatures.
One or more wheel nuts may crack resulting in a reduced clamping force.
Read full bulletin
This could eventually affect the integrity of the wheel assembly and the vehicle's behavior. This may increase the risk of a crash.
Brakes
2 bulletinsRepair Procedure Revision- Brake Light Switch Adjustment Vehicle may indicate brake light switch failure, rear brake...
Read full bulletin
light stays ON or flashes intermittently.
Vehicle may indicate brake light switch failure.
Read full bulletin
One of the probable cause is the adjustment of the brake light switch/low pressure switch.
Lighting
1 bulletinSafety Campaign Revision- Wheel nut may crack.
Read full bulletin
One or more wheel nuts may crack resulting in a reduced clamping force. New VINs added in the warranty campaign and new steps in the procedure.
Pre-Delivery & Maintenance
1 bulletinThis technical service tips is to show how to fix some leaks coming from the coolant cap area.