2019 BMW R1200 GS TSBs

camshaft signal, transmission signal, fuel pressure sensor, gear-lever sensor (GearShift Assistant), oxygen sensor and switching cam. These can result in functional impairments andmalfunctions, fault messages and fault memory entries. Besides isolated defective components, the sporadic faults are often mainly caused by contactproblems and increased contact resistances. These can generally occur along the entire signal pathof the respective affected component, but especially at plug connections. In this context, the plugconnection to the engine control unit has emerged as the main focus of the fault. Analyses of defective parts showed that in many cases the passivation (a production coating) of thepins at the plug-in contact (plug connection) of the engine control unit can result in correspondingfaults. A service solution for cleaning the pins has been created which can considerably improvecontact if implemented correctly. In most cases, this means that exchanging expensive componentslike the DME or the wiring harness can be avoided.

caliper have loosened in customer vehicles while driving.

catalog for the GS models.

vehicles fitted with option code 0190 "Enduro ASC + Riding Modes" can experience functional problems in the Enduro PRO mode. Effective March 06, 2013, BMW Motorrad has a software solution available. Once the coding plug has been fitted and the software update performed, the customer can use all the riding modes

2018 to end of June 2018, cross-spoked wheels with reduced spoke tension have been produced.

clutch slave cylinder and the braided stainless steel clutch line. The cause is a burr in the clutch slave cylinder which may damage the gasket of the clutch line.

clutch slave cylinder and the braided stainless steel clutch line. The cause is a burr in the clutch slave cylinder which may damage the gasket of the clutch line. A vehicle with high mileage can show signs of gradual impairment of the clutch function. The separating action of the clutch can worsen gradually over a period of time.

with the gearshift assistant (SA X222A) OE, a few faulty gearshift assistants have been installed in the production period from 09/02/2016 to 09/05/2016. Over the service life of the vehicle, there can be impairment of functions up to a loss of function of the gearshift assistants. In the case of a loss of function, a gear change (without the gearshift assistant) is possible only with the actuation of the clutch lever.

For the first time, maintenance positions for the cardan shaft (Driveshaft) are included. NOTICE: 1. The new maintenance schedule is not limited to vehicles affected by the SI 33 02 22 (SERVICE ACTION: Swingarm Drain retrofit and Driveshaft Check), but is valid for all K5x models - including retroactively. In case of retroactive validity (model year 2023 and older), affected customers will be informed about the change. This will be in the form of a direct-to-customer letter with a description of the new maintenance schedule, specific owners manual insert, and consumer warranty book insert. 1. For vehicles affected by SI 33 02 22 (SERVICE ACTION: Swingarm Drain retrofit and Driveshaft Check), this service action must be performed first. All conditions described in this bulletin apply after the open Service Action has been completed. No additional communication is required for K5x models model year 2024 and onwards. Those models have the new maintenance schedule in their owners manual.

The keyless Ride button must be pressed for several seconds to shut the bike down

This has led to increased demands being placed on the battery. This document covers important information for the dealer on how to handle discharged battery complaints.

2009)Headlights and rear lights light up intermittently despite the ignition being switched off and the battery charger being connected to the on-board socket.

travel

disk and makes noises.

This is due to a progrm fault in ISTA/p version 3.56.0.

and wear and tear exacerbated by certain climatic conditions.

a programming abort occurred. Afterwards the vehicle is inoperative and can no longer be started. Repeated programming is not possible with this tversion. Software bug.

k001-15-03-510.