Powered byNHTSA|EPA|Community Reports|Updated

2026 BMW M5 TSBs

11 Technical Service Bulletins across 6 categories

Lighting

4 bulletins
11035396

Due to an implementation error in various OBD diagnostics in the vehicle's control units, in very rare cases itmay...

Read full bulletin

happen that stored fault memory codes (DTCs) and the MIL (warning light) are not automaticallydeleted even though the underlying malfunction has already been rectified. This does not comply with the statutory OBD specifications.

11030053

The malfunction indicator lamp (MIL) is triggered by the erroneous fault code 031BFC- AC charging,charging electronics...

Read full bulletin

2, internal fault: No internal capacitor discharge stored in the CCU. However, AC charging is operating as designed without a charging concern or issue. Affected PHEV vehicles have the CCU-03 (7.4 kW / 11 kW) with I-levels from 24-07-500 to 25-11-5xx.

11030051

The malfunction indicator lamp (MIL) is triggered and 0318E2 AC charging, charging electronics 1,component protection:...

Read full bulletin

Overload current on AC side fault may be stored during AC charging Level 1(120 VAC). Note: Despite the fault memory entry (and the malfunction indicator lamp), the AC charging process willcontinue operating as designed and there is no related drivability complaint. Affected PHEV (plug-in hybrid electric vehicle) vehicles with CCU-03 (7.4 kW combined charging unit).

11026951

The rear tow hook cover cannot be reinstalled after it has been removed.

Other

2 bulletins
11036433

Bonnet Release Holder

11031898

Expansion Tank Return

Hybrid & EV

2 bulletins
11031576

Gen 5 BEV/PHEV vehicles may set the Combined Charging Unit (CCU) in programming abort due to no communication to the HV...

Read full bulletin

charge socket electronics.

11031572

A possible jerking motion may arise when using the Parking Maneuver Assistant in purely electric mode in vehicles with 7...

Read full bulletin

kW charging power and a programmed I-level starting from 25-03-500

Transmission

1 bulletin
11030054

Several complaints are possible: Vehicle does not start Gear cannot be engaged Various Check Control Messages...

Read full bulletin

Malfunction indicator lamp (MIL) on Several Check Control messages are possible: It is possible to continue driving. High-voltage system. You can continue driving. Drivetrain. Restart not possible. Drivetrain fault. Call Roadside Assistance. Drivetrain failure. Information: Total error of vehicle. The following fault memory entries are stored in the CCU: D796D9 - Message (- 0x91) not up-to-date, receiver CCU, transmitter EME D796DC - No message (- 0x91), receiver CCU, transmitter EME D796D8 - No message (- 0x91), receiver CCU, transmitter EME Other fault codes below may be stored in the EGS BA09B8 Inverter, Voltage Sensor, 5V HV AUX: Out of range or open connection detected BA0A45 ECU internal: Internal error of the synchronous serial data bus. Additional fault memory entries are possible. Similar fault memory entries indicating a missing EMEmessage (Traction E-Machine Electronic) can also be stored in other control units.

Electrical

1 bulletin
11030052

Malfunction indicator lamp (MIL) is triggered by the erroneous fault code(s) BA0023 - Control unit: internalfault...

Read full bulletin

(software group fault) In addition, the BA0008 - CCU, internal coolant temperature sensor:Signal implausible faults may be stored in the CCU memory. However, AC charging is still operating as designed, without any related drivability complaints. Affected PHEV vehicles have the CCU-03 (7.4 kW / 11 kW) with I-levels from 24-07-500 to 25-11-5xx.

Body & Paint

1 bulletin
11028924

The hood is difficult to close, or may not close