2019 BMW I3 TSBs

15 years / 150,000 miles as determined from the original first in-service / delivery date.

been extended to 15 years / 150,000 miles as determined from the original in-service date. This coverage is subject to the same vehicle eligibility requirements, limitations, and exclusion criteria that apply to the BMW New Vehicle Limited Warranty. Vehicles that are registered in California or a State that has fully adopted the State of California PZEV(SULEV) / TZEV emission regulations (As applicable, State of registration, model, and model year dependent), the emission-relevant coverage for this component is 15 years / 150,000 miles.

The following fault code is saved in the IHKA (integrated automatic heating/air conditioning system) control unit: 801189 - Engine mixed air right: Initialization fault.

small number of Model Year 2021 BMW i3 vehicles that were produced between March 1, 2021 and April 26, 2021. The vehicle cannot be charged on Level 1 because the Occasional Use Charging Cable (Standard OUC/Level 1/Mode 2), may have not been included.

Engine) warning light on, performing a Vehicle Test.

not charge the vehicle.

the range extender (REx) engine will run rough for about 1 to 2 seconds during cold start.

// Battery. Electrostatic discharge at standstill / start engine. Energy management" The results of the Energy Diagnosis test plan identifies the Controller as the root cause of the CCM. The Controller delays the vehicle going to sleep by up to 6 minutes. In some cases this will cause the CCM 415 to be displayed when starting the vehicle. Replacing the Controller in this case will not correct this situation.

more of the following faults are stored in the DME. All models: FC 191C02 - Fuel tank ventilation system 2nd discharge point: malfunction FC 195014 - Differential pressure sensor tank vent valve signal: fixed FC 118001 - Mixture control: mixture too lean FC 118401 - Mixture control: mixture too lean large deviation I01 only: FC 124103 - Mixture control: mixture too lean FC 124101 - Mixture control: Mixture lean large deviation CAUSE Internal mechanical defect in the tank ventilation valve. The defect can also result in a very loud clicking noise when the valve is cycling.

ConnectedDrive/BMW Assist features are partially or completely inoperative. This Service Information Bulletin: Is being published because vehicles are down for an extended period of time when researching system failures with ConnectedDrive or BMW Assist. Will assist you both in identifying the issue and providing technical support. CAUSE Not enough information is available for BMW NA engineers to assist the technician in diagnosing the root cause.

display for brake suspension and air bag system malfunction. The customer may also complain about any of the following: Engine can no longer be switched off Drive position (D) cannot be engaged on the gear selector switch (GWS) Reduction of steering assist After an engine emergency shut-off (either a prolonged long press; or 3 consecutive short presses of the Start/Stop button) and the vehicle going to sleep (identifiable by the lighting of the "Start/Stop button") everything resumes normal functionality and the CCM messages no longer appear.

Electrostatic discharge at standstill / start engine. Energy management" The results of the Energy Diagnosis test plan identifies the Controller as the root cause of the CCM. The Controller delays the vehicle going to sleep by up to 6 minutes. In some cases this will cause the CCM 415 to be displayed when starting the vehicle. Replacing the Controller in this case will not correct this situation.

After a vehicle has been programmed to an I-level greater than 19-11-5xx and lower than I-level 20-03-530; the safety belt (aka seat belt) acoustic warning sounds when in Park (engine running) and the safety belt is unbuckled. The chime/gong lasts for up to 1 minute 40 seconds. The customer only expects the acoustic warning when the vehicle is moving and the safety belt is not buckled. The acoustic warning can occur when the seat is occupied and the safety belt buckle is opened on the driver's or passenger's side. Software in the ACSM4 Control Unit.

A yellow CCM (Check Control Message) ID 415 is displayed- "Increased battery drain! // Battery. Electrostatic discharge at standstill / start engine. Energy management" The results of the Energy Diagnosis test plan identifies the Controller as the root cause of the CCM. The Controller delays the vehicle going to sleep by up to 6 minutes. In some cases this will cause the CCM 415 to be displayed when starting the vehicle. Replacing the Controller in this case will not correct this situation.

replaces SI B32 02 14 dated November 2016. The power-assisted steering is unavailable at start up/drive readiness. No communication with the Electric Power Steering (EPS). Possible fault codes: Fault code Text D356A5 message fault (display of the check control driving dynamics 02 D: Disp_CC_DRDY_02) Timeout D359BF message fault (actual steering torque of the driver actuator ID: AVL_STMOM_DV_ACT) Timeout D356B6 message fault (display of the check control driving dynamics 02 ID: DISP_CC_DRDY_02) - Alive 480AB8 internal status management of the complete monitoring range CDA451 FlexRay message (actual steering torque of the driver actuator 49.0.2): missing CDA452 FlexRay message (actual force of the rack 49.0.2): missing D35B26 message fault (actual position of the EPS ID: AVL_PO_EPS) - Timeout D355C4 message fault (status of the electrical steering front axle ID: ST_EST) - Timeout 48083B Peripheral/functional error on the engine control unit interface Actual steering angle of the front axle; signal temporarily invalid D35COC message fault (actual force of the rack ID: AVL_FORC_GRD) - Timeout. Electric Power Steering (EPS).

warranty for defects in materials or workmanship has been extended to 15 years/150,000 miles as determined from the original in-service/first delivery date.

warranty for defects in materials or workmanship has been extended to 15 years / 150,000 miles as determined from the original in-service/first delivery date.

This has led to increased demands being placed on the battery. This document covers important information for the dealer on how to handle discharged battery complaints.

communication for Combox, TCB 3G and ATM 3G (Telematics ControlModule) can no longer be supported by the cellular network provider starting February 2022.

voltage system shutdown while running range extender (REx). - Inconsistent performance of the REx. - High voltage system shutdown in vehicles without REx. - Excessively high range displayed in instrument cluster.

A vehicle test reveals one or both of the following faults stored in the IHX_I1 Control Module: 801295 - Heat Pump pressure-temperature sensor 2 after air condition compressor: pressure short to ground / open circuit 80112A - Heat Pump pressure-temperature sensor 2 after air condition compressor: temperature - short to ground A short circuit at the temperature sensor due to aluminum particles in the high-pressure line.

via the high-voltage charging procedure. The indicator light on the charging socket lights up white and does not change colors. The high-voltage charging cable cannot be unlocked and disconnected.

with option 609 (as of 7/2012 production). This uses map North America NEXT. The Headunit High 2 (HU-H2), also called NBT-EVO, superseded the NBT HU and was introduced in 3/2014. This uses map North America EVO. The Headunit High 4 (HU-H4, also called MGU21) superseded the MGU starting with certain MY2021 vehicles with option code 6U3 Live Cockpit Professional. This uses map North America JOY. The ENTRY Media/Navigation (HU-B) is the low line business version of the navigation system and was introduced in 3/2014. This uses map North America ROUTE. The ENTRY NAV EVO (HU-B2) replaced Entry Media/Navigation as the low-line business version and was introduced in certain MY2018 vehicles. This uses map North America WAY.

with option 609 (as of 7/2012 production). This uses map North America NEXT. The Headunit High 2 (HU-H2), also called NBT-EVO, superseded the NBT HU and was introduced in 3/2014. This uses map North America EVO. The Headunit High 3 (HU-H3, also called MGU) superseded the NBT-EVO starting with certain MY2019 vehicles with option code 6U3 Live Cockpit Professional or 6U2 Live Cockpit Plus. This uses map North America LIVE. The ENTRY Media/Navigation (HU-B) is the low line business version of the navigation system and was introduced in 3/2014. This uses map North America ROUTE. The ENTRY NAV EVO (HU-B2) replaced Entry Media/Navigation as the low-line business version and was introduced in certain MY2018 vehicles. This uses map North America WAY.

Roads can change by up to 15% every year. To ensure the best navigation experience, we do everything in our power to create the best maps. Your reports help us to detect changes in your area and keep future versions of our maps as accurate as possible. Therefore, a road map error or missing data must be reported directly to the map supplier.

the tailgate is open even though it is mechanically closed. Faulty tailgate lock or incorrect adjustment.

The INITIAL NAV enabling code no longer needs to be pre-ordered through the Parts department! When the vehicle is connected to the diagnostic system ISTA to perform PDI/QC1 the step to activate the navigation system (part of Delete Transport Mode) will automatically request the INITIAL NAV enabling code (VIN-specific) without pre-ordering the enabling code. This enabling code will be automatically delivered through ISTA and it then activates the navigation system.

Incorrect bonding during production.

Incorrect bonding during production.

Incorrect bonding during production.

Trunk/tailgate may open when vehicle is locked Trunk/tailgate may open while the vehicle is in motion usually after stopping such as a traffic light etc. Vehicle key trunk/tailgate button may be accidentally pressed thus opening the tailgate.

Steering control is never lost when the reduction of assistance occurs.

Steering control is never lost when the reduction of assistance occurs.

The driver notices a reduction of steering assistance sporadically while in certain driving situations. Steering control is never lost when the reduction of assistance occurs. The fault may self-correct for no obvious reason or be eliminated with a terminal change/key cycle. There is no Check Control (CC) message when the issue occurs. Unfavorable software in the Electric Power Steering (EPS).

Injectors to: 15 years/150,000 miles as determined by the vehicle's original in-service date.

programming to an Integration level (I-level) between I001-1911-500 and I001-19-11-556. Software in the Vehicle Sound Generator (VSG).

brakes applied, noticeable at low speeds. The vehicle must be moving.

Ticking noise coming from front wheel while cornering without brakes applied noticeable at low speeds. The vehicle must be moving. See attached video V34 01 20 Note: For a similar noise heard when parking with the brakes applied refer to SIB 31 01 12. Microscopic movement of the contact interface between the inner brake disc and the wheel bearing flange on vehicles equipped with lightweight brake discs.

customers, BMW of North America, LLC (BMW NA) is proud to announce a digital version of both the BMW Maintenance Booklet and BMW Original Equipment Manufacturers' (OEM) Tire Warranties.

illuminated when the Washer Fluid Tank is Full.There are no faults stored in the system for the washer fluid level switch.

Charging Socket Emergency release (2). Possible reasons for damage to the emergency release tensioning strap are: Excessive force was required to operate the emergency release Improper routing of tensioning strap.