2023 BMW 430I TSBs
61 Technical Service Bulletins across 10 categories
Categories
Body & Paint
13 bulletinsWhile driving on rough surfaces, a tapping noise can be heard from the tailgate area
Hood lever is pulled twice but the hood only achieves the pre-latch position on both sides.
The trunk lid trim panel may partially comeloose/dangle (red arrows show the mostprevalent areas).
The basic conditions for initializing the power windows are not met.
The paint finish on the door jamb (above the door striker) is scratched due to the inner door cavity window seal.
A groaning noise is heard from the trunk when driving on rough roads.
Upon opening and closing the tailgate, a creaking/groaning sound can be heard from tailgate actuator.
Sudden failure of the power window(s).
Black resin is leaking from below the outside door handle(s).
Hood lever is pulled twice but the hood only achieves the pre-latch position on both sides.
An interference noise (groaning noise) can be heard from within the heating and air-conditioning unit in the center of...
Read full bulletin
the instrument panel.
A limited amount of Model Year 2022/2023 (MY22/23) vehicles were produced with non-functional smart opener control units.
Read full bulletin
The Smart Opener is part of the Comfort Access feature, enabling to open the trunk lid or tailgate using the "foot kicking" motion beneath the rear bumper. Do not deliver to a customer, a New, Certified Pre-Owned or Used vehicle subject to a Delivery Stop, until the vehicle is repaired. Do not use or sell replacement equipment/parts subject to a Delivery Stop.
A limited amount of Model Year 2022/2023 (MY22/23) vehicles were produced with non-functional smart opener control units.
Read full bulletin
The Smart Opener is part of the Comfort Access feature, enabling to open the trunk lid or tailgate using the foot kicking motion beneath the rear bumper.
Other
13 bulletinsBMW AG has issued a Delivery Stop (effective September 28, 2023) on certain Model Year 2023 BMWvehicles that were...
Read full bulletin
produced between January 23, 2023, and June 15, 2023.
BMW AG has issued a Delivery Stop (effective February 9, 2023) on certain Model Year 2022 - 2023 BMW vehicles that were...
Read full bulletin
produced between June 29, 2022 and February 16, 2023.
BMW AG has issued a Delivery Stop (effective June 29, 2023) on certain Model Year 2023 BMW i4 vehicles that were...
Read full bulletin
produced between April 19, 2023, and April 24, 2023.
While the vehicle is at a standstill, a clicking noise can be heard in the passenger compartment.
BMW AG has issued a Delivery Stop effective June 6, 2023 on certain Model Year 2023 - 2024 BMW vehicles that were...
Read full bulletin
produced between October 26, 2022 and May 8, 2023.
Issues with the various functions of the camera-based driver assistance systems (KAFAS system) can possibly lead to...
Read full bulletin
following customer complaints: KAFAS camera system deactivates itself, due to system restrictions that are not clear to the customer KAFAS camera system cannot be activated due to system restrictions that are not clear to the customer Road signs are sporadically not detected.
BMW AG has issued a Delivery Stop (effective December 1, 2022) on certain Model Year 2023 BMW i4 and i7 vehicles that...
Read full bulletin
were produced between October 5, 2022 and November 10, 2022. A bearing in the front electric drive unit could fail due to a manufacturing defect, resulting in a noise while driving.
BMW AG has issued a Delivery Stop (effective October 25, 2021) on certain Model Year 2022 BMW vehicles that were produced after October 25, 2021.
Read full bulletin
Due to supply chain limitations, certain vehicles were produced without a CID with touch function and and without Reversing Assistant.
Customer is unable to power up or charge accessories through a plug adapter inserted in the front 12-volt power socket plug.
Read full bulletin
Alternatively, it will only operate when constant downward hand pressure is maintained.
A bearing in the front electric drive unit could fail due to a manufacturing defect, resulting in a noise while driving.
A cracking, metallic noise from under the center of the vehicle.
BMW AG has issued a Delovery Stop (effective December 1, 2022) on certain Model Year 2023 BMW i4 and i7 vehicles that...
Read full bulletin
were produced between October 5, 2022 and November 10, 2022. Due to a supplier production issue, it may cause the electric drive unit to fail.
Customer is unable to power up or charge accessories through a plug adapter inserted in the front 12-volt power socket plug.
Read full bulletin
Alternatively, it will only operate when constant downward hand pressure is maintained.
Infotainment
10 bulletinsAfter replacing the Multifunctional Display (MFD), the Central Information Display (CID) is black.
Read full bulletin
The backlight of the CID is illuminated, and touch function does register an audible sound.
The Central Information Display goes black intermittently due to resets of the Head Unit (HU-H3).
Read full bulletin
FaultB7F8F9 HU-H: Reset will be stored in the HU-H3.
Customers may be experiencing one or more of these following issues with Bluetooth operation: Bluetooth cannot be...
Read full bulletin
switched on or off in the head unit (HU-H4) Paired mobile devices cannot be deleted Customer is unable to make phone calls or stream music with mobile device Customer is unable to connect a new mobile device via Bluetooth Mobile device does not automatically reconnect via Bluetooth in the next drive cycle (after short sleep cycle)
Intermittently the GPS location in 3 Party Navigation Apps (i.e., Apple Maps, Google Maps, Waze) will drift fromthe correct location.
Read full bulletin
In addition, the location of the vehicle in the My BMW app may be incorrect. BMW Navigation isnot affected.
Central information display.
Customer is shown an incorrect GPS location in the vehicle (i.e., Nav Map, coordinates).
Customer states there is no audio playback (telephony, navigation, radio) and system sounds (PDC, turn indicators,...
Read full bulletin
acoustic signals) may also have failed.
Customers may complain about a loss of displayed estimated electric driving range in the instrument cluster (KOMBI)...
Read full bulletin
after programming to I-level S18A-22-07-5XX.
Customer is shown an incorrect GPS location in the vehicle (i.e., Nav Map, coordinates).
The sound output intermittently drops out entirely.
Read full bulletin
This can be reproduced with all audio sources as well as telephone and voice output.
Engine
7 bulletinsThe EVAP systems purge (vent) valve limited warranty for defects in materials and / or workmanship has been extended to...
Read full bulletin
15 years / 150,000 miles as determined from the original first in-service / delivery date.
When turning the steering wheel while stationary or when driving on uneven roads; cracking, creaking, or knocking noises...
Read full bulletin
may be heard.
Check Control message (CCM) indicates: (ID 213): Stop, exercising due care.
Read full bulletin
Voltage supply The Service Engine Soon light is on with the following DME Fault Code: 21B209 - Starter alternator / belt for 48V system (OSA_RIEMEN_RISS): Belt betweenCombustion engine and starter generator torn And/or one or more of the following other issues are also occurring: Noise in the area of the belt drive. Odor from the engine compartment. Smoke formation in the area of the belt drive. Drive belt damaged or prematurely worn. Torn drive belt.
An interference noise (groaning noise) can be heard from within the heating and air-conditioning unit in thecenter of the instrument panel.
Read full bulletin
The groaning noise always occurs when either a ventilation flap, air stratification flap or the recirculated airflap moves to a different position. Due to the complex design of the heating and air-conditioning unit, the kinematics causing it (top or bottom,left or right) may not be able to be precisely located. Depending on the vehicle model, the number of servomotors (and the associated kinematics unit) varies.Various models use either 2 or 3 servomotors.
Check Control message (CCM) indicates: (ID 213): Stop, exercising due care.
Read full bulletin
Voltage supply The Service Engine Soon light is on with the following DME Fault Code: 21B209 - Starter alternator / belt for 48V system (OSA_RIEMEN_RISS): Belt betweenCombustion engine and starter generator torn And/or one or more of the following other issues are also occurring: Noise in the area of the belt drive. Odor from the engine compartment. Smoke formation in the area of the belt drive. Drive belt damaged or prematurely worn. Torn drive belt.
When turning the steering wheel while stationary or when driving on uneven roads; cracking, creaking, or knocking noises...
Read full bulletin
may be heard.
Vehicle cannot be opened or closed using comfort access, engine start is not possible, and the vehicle may not start...
Read full bulletin
when placing the key against the steering column.
Electrical
7 bulletinsSITUATION After the telematics module (TCB4) has been replaced, the replacement part control unit is not accepted...
Read full bulletin
byISTA.
The electrical system of BMW vehicles has been subject to an ongoing development process over the last few years.
Read full bulletin
This has led to increased demands being placed on the battery. This document covers important information for the dealer on how to handle discharged battery complaints.
Customer states one of the front seats is inoperative.
Read full bulletin
The seat heater and power supply are inoperative. During the vehicle test, the seat module does not respond. The power supply fuse for the seat module isfound to have blown.
?BMW AG has issued a Delivery Stop (effective June 29, 2023) on certain Model Year 2023 BMW i4 vehicles that were...
Read full bulletin
produced between April 19, 2023, and April 24, 2023. Contaminants were found on the printed circuit board of the electric A/C compressor (EKK).
Headlight check control (CC) message 128 "High beam headlight failure" is displayed.
Read full bulletin
The following fault codes are stored during a vehicle test: 80419A - Left high-beam headlight: Short circuit and/or 8041A5 - light outputs: Number of permitted short circuit cycles exceeded
Due to a software error, the vehicle sporadically does not achieve sleep mode.
Read full bulletin
As a result, the 12-volt battery becomes discharged and may cause a no-start condition.
Due to a software error, the vehicle sporadically does not achieve sleep mode.
Read full bulletin
As a result, the 12-volt battery becomes discharged and may cause a no-start condition.
Lighting
4 bulletinsWhile driving on a smooth and/or uneven road, a cracking sound is heard from the rear wheel arch area (highlighted in...
Read full bulletin
orange) on either the right or left side.
A vehicle listed above may arrive with a Check Control Message (CCM), and/or malfunction indicator lamp(MIL) illuminated.
Read full bulletin
After carrying out the vehicle test, one or more of the stored faults indicate that the operation of the frontbottom active air flap is obstructed or blocked.
Condensation is present on the inner surfaces in one or both taillights (circled).
Upon parking and exiting the vehicle, the parking lights remain active.
Fuel System
3 bulletinsA vehicle arrives at your center to be diagnosed for a micro-leak in the fuel evaporative (EVAP) system(NVLD natural vacuum leak detection).
Read full bulletin
For this condition, the following fault is stored in the DME: 190302 - fuel tank ventilation and scavenging air system, micro-leak: leakage more than 0.5mm For: Model vehicles other that the ones listed above, or for EVAP faults related to a large leak, after confirming that the fuel filler cap is fitted properly, then, proceed to follow the corresponding test plan
A vehicle arrives at your center to be diagnosed for a micro-leak in the fuel evaporative (EVAP) system (NVLD natural vacuum leak detection).
Read full bulletin
For this condition, the following fault is stored in the DME: 190302 - fuel tank ventilation and scavenging air system, micro-leak: leakage more than 0.5 mm.
Due to component-related supply issues, the central information displays (CID) in some of the Model Year 2022 vehicles...
Read full bulletin
listed above were produced without the integrated touch screen function.
Transmission
2 bulletins?The customer states there is a Drivetrain Malfunction message displayed in the instrument cluster, and in some cases...
Read full bulletin
the vehicle will not go into drive readiness.
The gear selector switch (GWS) consists of the control electronics circuit and the selector lever.
Read full bulletin
The sensors for recording the gearshift lever position and for inhibiting inadvertent gearshifts are integrated in the control electronics.
Steering
1 bulletinAt low outside temperatures (below 40 degrees F) and slow driving speeds (i.e.
Read full bulletin
when parking, maneuvering)with a large steering angle, the front end can be slightly axially misaligned. This can be felt (jerking)/ heard via an acoustic acknowledgement (clunk) as seen at the 11 second mark of the video. See attached video V36 01 21.
Pre-Delivery & Maintenance
1 bulletinBMW AG has requested the inspection of all dealer stock of the following part number(s) listed below to ensure the...
Read full bulletin
spacer is conformed to drawing.