2023 BMW 330I TSBs
52 Technical Service Bulletins across 13 categories
Categories
Infotainment
10 bulletinsAfter replacing the Multifunctional Display (MFD), the Central Information Display (CID) is black.
Read full bulletin
The backlight of the CID is illuminated, and touch function does register an audible sound.
It is not possible to complete the setup of the BMW Digital Key function in the vehicle with a smartphone.
Read full bulletin
The main digital key cannot be paired using the My BMW App. The digital key pairing process does notrespond after the message Please place your smartphone on the NFC tray appears in the CentralInformation Display (CID). No function is available with the NFC (near-field commumication) card either.
No Bass or a cracking noise can be heard from the bass speakers.
The Central information Display (CID) screen goes black and the Headunit (HU-H3) resets sporadically.After a short...
Read full bulletin
period of time, the function of the CID and HU-H3 is available again. Additionally, fault code B7F8F9 HU-H: Reset will be stored in the HU-H3. The issue may occur multiple times while driving longer distances. CAUSE Unfavorable
The Central Information Display goes black intermittently due to resets of the Head Unit (HU-H3).
Read full bulletin
FaultB7F8F9 HU-H: Reset will be stored in the HU-H3.
Customers may be experiencing one or more of these following issues with Bluetooth operation: Bluetooth cannot be...
Read full bulletin
switched on or off in the head unit (HU-H4) Paired mobile devices cannot be deleted Customer is unable to make phone calls or stream music with mobile device Customer is unable to connect a new mobile device via Bluetooth Mobile device does not automatically reconnect via Bluetooth in the next drive cycle (after short sleep cycle)
Central information display.
Customer is shown an incorrect GPS location in the vehicle (i.e., Nav Map, coordinates).
Customer states there is no audio playback (telephony, navigation, radio) and system sounds (PDC, turn indicators,...
Read full bulletin
acoustic signals) may also have failed.
Customer is shown an incorrect GPS location in the vehicle (i.e., Nav Map, coordinates).
Engine
9 bulletinsThe EVAP systems purge (vent) valve limited warranty for defects in materials or workmanship has been extended to 15...
Read full bulletin
years / 150,000 miles as determined from the original in-service date.
When turning the steering wheel while stationary or when driving on uneven roads; cracking, creaking, or knocking noises...
Read full bulletin
may be heard.
Check Control message (CCM) indicates: (ID 213): Stop, exercising due care.
Read full bulletin
Voltage supply The Service Engine Soon light is on with the following DME Fault Code: 21B209 - Starter alternator / belt for 48V system (OSA_RIEMEN_RISS): Belt betweenCombustion engine and starter generator torn And/or one or more of the following other issues are also occurring: Noise in the area of the belt drive. Odor from the engine compartment. Smoke formation in the area of the belt drive. Drive belt damaged or prematurely worn. Torn drive belt.
An interference noise (groaning noise) can be heard from within the heating and air-conditioning unit in thecenter of the instrument panel.
Read full bulletin
The groaning noise always occurs when either a ventilation flap, air stratification flap or the recirculated airflap moves to a different position. Due to the complex design of the heating and air-conditioning unit, the kinematics causing it (top or bottom,left or right) may not be able to be precisely located. Depending on the vehicle model, the number of servomotors (and the associated kinematics unit) varies.Various models use either 2 or 3 servomotors.
Check Control message (CCM) indicates: (ID 213): Stop, exercising due care.
Read full bulletin
Voltage supply The Service Engine Soon light is on with the following DME Fault Code: 21B209 - Starter alternator / belt for 48V system (OSA_RIEMEN_RISS): Belt betweenCombustion engine and starter generator torn And/or one or more of the following other issues are also occurring: Noise in the area of the belt drive. Odor from the engine compartment. Smoke formation in the area of the belt drive. Drive belt damaged or prematurely worn. Torn drive belt.
?A software error may cause an unwanted pressure pulsation in the transmission during a "Remote Engine Start."
Engine Variants Updated.
In hot ambient conditions, if the engine was running for a prolonged time while the vehicle is stationary, a jolt may be...
Read full bulletin
experienced while lightly accelerating.
When turning the steering wheel while stationary or when driving on uneven roads; cracking, creaking, or knocking noises...
Read full bulletin
may be heard.
Other
7 bulletinsBMW AG has issued a Delivery Stop effective June 6, 2023 on certain Model Year 2023 - 2024 BMW vehicles that were...
Read full bulletin
produced between October 26, 2022 and May 8, 2023.
Issues with the various functions of the camera-based driver assistance systems (KAFAS system) can possibly lead to...
Read full bulletin
following customer complaints: KAFAS camera system deactivates itself, due to system restrictions that are not clear to the customer KAFAS camera system cannot be activated due to system restrictions that are not clear to the customer Road signs are sporadically not detected.
There is a howling or whistling noise from under the vehicle at 30 -37 mph (50 -60 km/h) when driving after a cold...
Read full bulletin
start, when the outside temperature is 32 F (0 C) or lower.
BMW AG has issued a Delivery Stop (effective October 25, 2021) on certain Model Year 2022 BMW vehicles that were produced after October 25, 2021.
Read full bulletin
Due to supply chain limitations, certain vehicles were produced without a CID with touch function and and without Reversing Assistant.
Customer is unable to power up or charge accessories through a plug adapter inserted in the front 12-volt power socket plug.
Read full bulletin
Alternatively, it will only operate when constant downward hand pressure is maintained.
There is a howling or whistling noise from under the vehicle at 30 -37 mph (50 -60 km/h) when driving after a cold...
Read full bulletin
start, when the outside temperature is 32 F (0 C) or lower. The noise goes away as the vehicle/driveline reaches operating temperature.
BMW AG has issued a Delivery Stop (effective November 10, 2022) on a small number of Model Year 2023 BMW vehicles that...
Read full bulletin
were produced between August 8, 2022 and October 18, 2022.
Body & Paint
5 bulletinsA groaning noise is present from the door frame of any door, most commonly when driving over rough roadsor during body flex.
Read full bulletin
This situation may be worse in vehicles which are regularly waxed in th e area of the door jamb.
The basic conditions for initializing the power windows are not met.
A groaning noise is present from the door frame of any door, most commonly when driving over rough roadsor during body flex.
Read full bulletin
This situation may be worse in vehicles which are regularly waxed in the area of the door jamb. Note: This service information bulletin contains diagnostic and repair information which was previouslyincluded in an NED test plan that has been removed.
Upon opening and closing the tailgate, a creaking/groaning sound can be heard from tailgate actuator.
Hood lever is pulled twice but the hood only achieves the pre-latch position on both sides.
Electrical
5 bulletinsThe electrical system of BMW vehicles has been subject to an ongoing development process over the last few years.
Read full bulletin
This has led to increased demands being placed on the battery. This document covers important information for the dealer on how to handle discharged battery complaints.
Customer states one of the front seats is inoperative.
Read full bulletin
The seat heater and power supply are inoperative. During the vehicle test, the seat module does not respond. The power supply fuse for the seat module isfound to have blown.
Headlight check control (CC) message 128 "High beam headlight failure" is displayed.
Read full bulletin
The following fault codes are stored during a vehicle test: 80419A - Left high-beam headlight: Short circuit and/or 8041A5 - light outputs: Number of permitted short circuit cycles exceeded
Due to a software error, the vehicle sporadically does not achieve sleep mode.
Read full bulletin
As a result, the 12-volt battery becomes discharged and may cause a no-start condition.
Due to a software error, the vehicle sporadically does not achieve sleep mode.
Read full bulletin
As a result, the 12-volt battery becomes discharged and may cause a no-start condition.
Lighting
4 bulletinsWhile driving on a smooth and/or uneven road, a cracking sound is heard from the rear wheel arch area (highlighted in...
Read full bulletin
orange) on either the right or left side.
A vehicle listed above may arrive with a Check Control Message (CCM), and/or malfunction indicator lamp(MIL) illuminated.
Read full bulletin
After carrying out the vehicle test, one or more of the stored faults indicate that the operation of the frontbottom active air flap is obstructed or blocked.
Condensation is present on the inner surfaces in one or both taillights (circled).
When unlocking the vehicle, the welcome light in the headlight "lights up eratically."
Fuel System
3 bulletinsA vehicle arrives at your center to be diagnosed for a micro-leak in the fuel evaporative (EVAP) system(NVLD natural vacuum leak detection).
Read full bulletin
For this condition, the following fault is stored in the DME: 190302 - fuel tank ventilation and scavenging air system, micro-leak: leakage more than 0.5mm For: Model vehicles other that the ones listed above, or for EVAP faults related to a large leak, after confirming that the fuel filler cap is fitted properly, then, proceed to follow the corresponding test plan
A vehicle arrives at your center to be diagnosed for a micro-leak in the fuel evaporative (EVAP) system (NVLD natural vacuum leak detection).
Read full bulletin
For this condition, the following fault is stored in the DME: 190302 - fuel tank ventilation and scavenging air system, micro-leak: leakage more than 0.5 mm.
Due to component-related supply issues, the central information displays (CID) in some of the Model Year 2022 vehicles...
Read full bulletin
listed above were produced without the integrated touch screen function.
Transmission
3 bulletinsBMW AG has issued an Emissions Recall (effective March 17, 2023) on a certain Model Year 2021 - 2023 BMW vehicles that...
Read full bulletin
were produced between June 16, 2020, and December 13, 2022. Due to a software failure, there is the possibility that the transmission does not go into "sleep mode" if the car is turned off.
The gear selector switch (GWS) consists of the control electronics circuit and the selector lever.
Read full bulletin
The sensors for recording the gearshift lever position and for inhibiting inadvertent gearshifts are integrated in the control electronics.
BMW AG has issued a Delivery Stop: Due to a software failure, there is the possibility that the transmission does not go...
Read full bulletin
into "sleep mode" if the car is turned off.
Pre-Delivery & Maintenance
2 bulletinsBMW AG has requested the inspection of all dealer stock of the following part number(s) listed below to ensure the...
Read full bulletin
spacer is conformed to drawing.
The 3G network in the US has been shut down.
Read full bulletin
This means that only the 4G network will be available. In the 4G network, voice calls will be transferred via the Voice over LTE (VoLTE) function. For this purpose, the SIM card must perform an IMS registration in the mobile communication network. Due to a production error, the telematics control units were delivered without an IMS configuration. The Connected Drive voice services (Concierge Call, BMW Assistance, and emergency call voice) can no longer be used regionally in the US in vehicle with telematics control units ATM-1 and TCB-4G. Voice control of the vehicle and all other telephone (paired mobile devices) functions are not affected. Emergency call location data is unaffected.
Steering
1 bulletinAt low outside temperatures (below 40 degrees F) and slow driving speeds (i.e.
Read full bulletin
when parking, maneuvering)with a large steering angle, the front end can be slightly axially misaligned. This can be felt (jerking)/ heard via an acoustic acknowledgement (clunk) as seen at the 11 second mark of the video. See attached video V36 01 21.
Suspension
1 bulletinThe left front suspension's aluminum strut dome (general area circled) was incorrectly riveted to the body's wheel-well.
Hybrid & EV
1 bulletinA limited number of the G20 PHEVs may not have been supplied with an Occasional Use Charging (Standard OUC/Level 1/Mode...
Read full bulletin
2) cable in error.
Software & Calibration
1 bulletinWith the introduction of the BMW Remote Software Upgrade, all Service Pack 18 vehicles and partial Service Pack 15...
Read full bulletin
vehicles may receive new functionality or modifications in their features.