2009 Aston Martin DBS TSBs
31 Technical Service Bulletins across 12 categories
Categories
Other
8 bulletinsPhased Launch of Bosch MTS 6531 VCI Unit
We have introduced a new special tool 43-28335 Docking Station Bezel Release Tool.
Customer Handover Checklist
Parts return requests PRRs
Technical Assessments launched on the training academy
Aftermarket dash camera questionnaire
To inform about the changes we are making to Technical Training along with the introduction of the 3 tier Technician...
Read full bulletin
grading system
Reminder to do OBD In-use Monitoring with AMDS.
Engine
4 bulletinsCrankshaft Sensor - High RPM Test
Recommended Engine Oils for V8 and V12 Naturally Aspirated Engines
Introduction of a remanufactured long-block V8 engine
ASTON MARTIN SERVICE CAMPAIGN: SEE DOCUMENT SEARCH BUTTON FOR OWNER LETTER.
Read full bulletin
THE WINDSCREEN WIPERS, WHEN THEY ARE AT FAST SPEED, CAN STOP AFTER A PERIOD OF CONSTANT USAGE. THE NEW 200 AMP ALTERNATOR GIVES AN INCREASED VOLTAGE TO THE WIPER MOTOR. CSC LETTER WAS RECEIVED. *PE
Suspension
3 bulletinsWelcome to Technical Hub V2
Welcome to Technical Hub
The Introduction of Tech Hub and Spotlight
Software & Calibration
3 bulletinsEPDR Submission process update to existing SPL-30-0458
2018 Technical Training Update.
Client Services Department Team Update.
Fuel System
2 bulletinsCompliance with E10 Fuel
Fuel filling problem
Lighting
2 bulletinsWhen one of the two rear lamp assemblies is removed you must make sure that the assembly is installed correctly.
ASTON MARTIN: THE TYRES SUPPLIED BY ASTON MARTIN PARTS OPERATIONS ARE THE SAME SPECIFICATION AS THE ORIGINAL INSTALLED...
Read full bulletin
EQUIPMENT AND ARE FULLY APPROVED. NO MODEL OR MODEL YEARS LISTED. *PE
Body & Paint
2 bulletinsThe reason for this policy letter is to give you information that was not available before, when body repair policy...
Read full bulletin
BPL-01-0021 "Change of Paint Supplier" was published.
A new type of throttle pedal needs an additional support bracket.
Read full bulletin
The support bracket is installed in Production on vehicles after the VINs given. Before you install a new-type throttle pedal on a vehicle before the VINs given, you must bond a support bracket to the body extrusion. If you install a new-type throttle pedal on an earlier vehicle, you must do the Workshop Procedure that follows also to install a support bracket. Amended to show new kit of parts needed.
Electrical
2 bulletinsCorrect Diagnosis and Replacement of Restraint Control Modules
New electrical content and HTML5 upgrade for Cortona 3D content on the dealer communication system (DCS).
Transmission
2 bulletinsASTON MARTIN: SOME DBS AUTOMATIC TRANSMISSION VEHICLES HAVE TRANSMISSION ELECTRICAL HARNESSES INSTALLED THAT CAN BECOME...
Read full bulletin
DEFECTIVE BECAUSE OF A MANUFACTURING FAULT. THE FAILURE DOES NOT OCCUR FREQUENTLY BUT IF IT DOES, AN OVERLAY HARNESS HAS BEEN MADE THAT WILL CORRECT THE PROBLEM. NO MODEL YEARS ARE LISTED. *PE
ASTON MARTIN: GEAR CHANGE CABLES ARE HELD INTO A BRACKET ABOVE THE TRANSAXLE BY SPRING LOADED SLEEVES.
Read full bulletin
THE CABLES CAN COME OUT OF THE BRACKET, IF THIS HAPPENS SOME OF THE GEARS CAN NOT BE SELECTED. *PE
Tires & Wheels
1 bulletinInstructions for the ATEQ TPMS / RKE Tool
Pre-Delivery & Maintenance
1 bulletinDeployable Spoiler wear inspection - annual check required.
Steering
1 bulletinASTON MARTIN SERVICE CAMPAIGN: SEE DOCUMENT SEARCH BUTTON FOR OWNER LETTER.
Read full bulletin
THERE ARE FRONT ARM SUSPENSION BOLTS THAT ARE OUT OF SPECIFICATIONS AND COULD CRACK AFFECTING STEERING AND STABILITY. *RM