2013 Aston Martin DB9 TSBs
33 Technical Service Bulletins across 11 categories
Categories
Other
11 bulletinsPhased Launch of Bosch MTS 6531 VCI Unit
Set up Guide for Data Loggers
We have introduced a new special tool 43-28335 Docking Station Bezel Release Tool.
Set up Guide for Dataloggers
Customer Handover Checklist
Parts return requests PRRs
Technical Assessments launched on the training academy
Aftermarket dash camera questionnaire
To inform about the changes we are making to Technical Training along with the introduction of the 3 tier Technician...
Read full bulletin
grading system
Reminder to do OBD In-use Monitoring with AMDS.
ASTON MARTIN: DOCKING STATION LENS REPLACEMENT.
Read full bulletin
CONSUMER MAY COMPLAIN THAT THE DOCKING STATION WILL COME DETACHED. WHOLE BEZEL LENS ASSEMBLY MUST BE REPLACED IF HALF OF THE LENS IS DETACHED. *KB
Electrical
4 bulletinsModifications to the Electrical Connections on the V12 Starter Solenoid.
Modifications to the Electrical Connections on the V12 Starter Solenoid.
Correct Diagnosis and Replacement of Restraint Control Modules
New electrical content and HTML5 upgrade for Cortona 3D content on the dealer communication system (DCS).
Engine
4 bulletinsCrankshaft Sensor - High RPM Test
Recommended Engine Oils for V8 and V12 Naturally Aspirated Engines
Introduction of a remanufactured long-block V8 engine
ASTON MARTIN: SOFTWARE UPDATE FOR THE ENGINE.
Read full bulletin
*KB
Suspension
3 bulletinsWelcome to Technical Hub V2
Welcome to Technical Hub
The Introduction of Tech Hub and Spotlight
Software & Calibration
3 bulletinsEPDR Submission process update to existing SPL-30-0458
2018 Technical Training Update.
Client Services Department Team Update.
Fuel System
2 bulletinsCompliance with E10 Fuel
Fuel filling problem
Body & Paint
2 bulletinsThe reason for this policy letter is to give you information that was not available before, when body repair policy...
Read full bulletin
BPL-01-0021 "Change of Paint Supplier" was published.
A new type of throttle pedal needs an additional support bracket.
Read full bulletin
The support bracket is installed in Production on vehicles after the VINs given. Before you install a new-type throttle pedal on a vehicle before the VINs given, you must bond a support bracket to the body extrusion. If you install a new-type throttle pedal on an earlier vehicle, you must do the Workshop Procedure that follows also to install a support bracket. Amended to show new kit of parts needed.
Lighting
1 bulletinWhen one of the two rear lamp assemblies is removed you must make sure that the assembly is installed correctly.
Tires & Wheels
1 bulletinInstructions for the ATEQ TPMS / RKE Tool
Pre-Delivery & Maintenance
1 bulletinDeployable Spoiler wear inspection - annual check required.
Brakes
1 bulletinASTON MARTIN: CARBON CERAMIC MATRIX (CCM) BRAKE DISCS ARE BEING INTRODUCED ON THE PRODUCTION VEHICLES.
Read full bulletin
ALL MODELS INCLUDED. *KB