2006 Acura Tsx TSBs

Indicator Lamp (MIL) on with the DTC P2138 (Accelerator Pedal Position Sensor A/B Incorrect Voltage Correlation) stored and poor engine performance. To fully understand the cause of this condition, AHM would like to collect specific parts from the vehicle prior to you attempting any further repair of any kind.

Indicator Lamp (MIL) on with the DTC P2138 (Accelerator Pedal Position Sensor A/B Incorrect Voltage Correlation) stored and poor engine performance. To fully understand the cause of this condition, AHM would like to collect specific parts from the vehicle prior to you attempting any further repair of any kind.

Indicator Lamp (MIL) on with the DTC P2138 (Accelerator Pedal Position Sensor A/B Incorrect Voltage Correlation) stored and poor engine performance. To fully understand the cause of this condition, AHM would like to collect specific parts from the vehicle prior to you attempting any further repair of any kind.

TO FULLY UNDERSTAND THE CAUSE OF THIS CONDITION, AHM WOULD LIKE TO INSPECT THE VEHICLE PRIOR TO YOU ATTEMPTING A REPAIR OF ANY KIND."

VOLTAGE CORRELATION), AND HAVE POOR PERFORMANCE IN ENGINE. MODEL 2004-2008 TL, TSX. *PE

SENSOR A/B INCORRECT VOLTAGE CORRELATION). THERE MAY ALSO BE POOR ENGINE PERFORMANCE. AHM IS ATTEMPTING TO COLLECT SPECIFIC PARTS FROM THE VEHICLE BEFORE ANY FURTHER EFFORT TOWARD REPAIRS. *JS

MALFUNCTION INDICATOR LAMP (MIL) IS ON WITH DIAGNOSTIC TROUBLE CODE (DTC) 02138, AN INVESTIGATION WILL CHECK CAUSE OF CONDITION. MODEL 2004-2008 TX, TSX. *PE

MODEL 2004-2008 TSX. *PE

MODEL 2004-2008 TSX. *PE

*PE

TRAILER STABILITY MALFUNCTION LIGHT IS ON, ENGINE OIL APPLICATION GUIDE, NEW SOFTWARE, NEW TRANSMISSION FLUID, NOTCHY STEERING FEELING. *RM

are you seeing this message? "Immobilizer system is not normal". We?re aware of this issue and have it under investigation.

*PE

*KB

*TT

This is due to a limited GPS receiver capacity resulting in rollover of internal chip memory. The rollover occurred on January 1, 2022 at 12:00AM local time

This issue is due to a limited GPS receiver capacity resulting in "rollover" of the internal chip memory; the "rollover" will occur on January 1, 2022, at 12:00AM local time. As a result, the navigation date and time will be incorrect.

As of August 4, 2014, affected VINs have been identified, and VIN status inquiry has been updated.

*KB AFFECTS 2002 THROUGH 2006 ACURA MODELS. UPDATED 8/15/08. *PE

REPLACING, SERVICING AND REPAIRING VARIOUS MODEL AND MODEL YEAR VEHICLES. *PE

A FEDERAL COURT PROVIDED FINAL APPROVAL OF THE SETTLEMENT OF A CLASS ACTION LAWSUIT ALLEGING THAT THE ODOMETERS ON CERTAIN MODELS WERE OVERSTATING MILEAGE. VEHICLES AFFECTED BY THIS SETTLEMENT INCLUDE CERTAIN 2002-2006. ON AFFECTED VEHICLES, THE SETTLEMENT REQUIRES YOU TO HONOR A 5 PERCENT INCREASE IN THE MILEAGE COVERAGE PERIOD FOR ALL WARRANTIES. NO MODELS WERE LISTED. *PE

SERVICENEWS. *TT

As of July 23, 2014, affected VINs have been identified, and service bulletins 14-023, Safety Recall: Front Passenger?s Airbag Inflator Can Be Over-Pressurized, 14-029, Recall: Front Driver?s Airbag Inflator May Produce Excessive Pressure After Long-Term Exposure to High Absolute Humidity Recall, and 14-030, Recall: Front Passenger?s Airbag Inflator May Produce Excessive Pressure After Long-Term Exposure to High Absolute Humidity have been posted to ISIS. However, due to the large number of affected units, Acura is still in the process of populating the VIN status inquiry function on iN, which is expected to take several days. When this process is complete, Acura will notify all dealers again via iN message. Until that time, the existing acknowledgement procedure must be used for all potentially affected vehicles.

*NJ

MODULE THAT IS INSTALLED ON GR8 DIAGNOSTIC BATTERY STATION. *PE

SOME REAR WHEEL SENSORS MAY HAVE BEEN IMPROPERLY INSTALLED, ALLOWING MOISTURE TO ENTER THE REAR HUB BEARING UNIT. IF THE NOISY HUB BEARING UNIT IS RUSTY, REPLACE IT AND THE WHEEL SENSOR. IF THE NOISY HUB BEARING UNIT IS NOT RUSTY, REPLACE JUST THE HUB BEARING UNIT. *PE

*PE

*KB

The customer communication requested return of unsold inventory to inspect for the outer diameter of the ball joint housing being too small. The outer diameter being too small would prevent the part from being installed, and would therefore have no impact on the end user besides time to complete installation.

correct kit for to the A/C system you are working on.

to a potentially leaking power steering feed hose. For some time, the countermeasure hoses and required repair parts have been in stock as part of special campaign parts kits available for dealer ordering.

*TT

ACURA. SERVICENEWS. *TT